The diagram below represents the layout of a typical single-beam UV-Vis, explain the function of each identified part. Computer Exit slits Grating Collimating optics Source carousel Sample cell Detector Mirror Collimating slits Dz-lamp Tungsten-halogen lamp

The diagram below represents the layout of a typical single-beam UV-Vis, explain the function of each identified part. Computer Exit slits Grating Collimating optics Source carousel Sample cell Detector Mirror Collimating slits Dz-lamp Tungsten-halogen lamp

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Related questions

Q: Focusing Lenses Radiation Source Wavelength Selector Detector Atomizer Signal Processor Amplifier…

A: 5) The capillary column are more efficient than packed columns in GC.

Q: Explain about role of gas detection system in Laser.

Q: The following are the basic components of XRD except-* Source Primary optics Sample Holder…

A: XRD is used to determine the crystal structure of a sample, It is the important characterization…

Q: Explain how beam chopping reduces line noise and noise from source drift.

A: To explain: How beam chopping reduces line noise and noise from source drift.

Q: Find all the IR Peak Assignment and NMR Peak Assignment

A: To assign the various IR and NMR peak present in the given NMR spectrum and IR spectrum of C4H8O2.

Q: calculate the absorbance of the transmittance of the % crystal violet of all columns 1-11

A: ABSORBANCE: Absorbance is defined as the inverse of transmittance and it refers to the measure of…

Q: What are the interferences in AAS technique? Give examples and corrective measures

A: Atomic absorption spectrometry (AAS) is a technology that uses free gaseous atoms to absorb…

Q: * TRANSMITTANCE Mol. fimula eo 60 4.0 4000 3.5 CH100 3339 3503 3000 Capillary film batuen salt…

Q: i) Find the differences between the AES and XPS in terms of principle and information obtained from…

A: (i) AES is the auger electron spectroscopy that provides the quantitative elemental and the chemical…

Q: A student will be performing analysis of water samples collected from the Lake Eymir to determine Fe…

Q: What is the IR ANALYSIS FROM THIS MODEL Please help

A: IR spectroscopy is a technique used in laboratories to identify the functional groups present in the…

Q: Discuss the diagnostic bands which will be everything in the non-fingerprint region. Have a sentence…

A: The question is based on the concept of IR spectroscopy. We need to analyse the spectra & assign…

Q: 100 80 60 40 20 - -0. 3000 2000 1000 Wavenumbers (cm-1) %Transmittance 川| 1862.43 1782.54 1458.51…

A: From IR one can get a glimpse of some functional groups like carbonyls, hydroxyl, aromatic C=C bond…

Q: Standard solutions of a chemical species with different concentrations are analyzed using a UV-Vis…

A: The expression of beer's law is shown below: A =ε c l where; A = absorbance c = concentration l =…

Q: Any concerns about using electrochemical sensing? what are the benefits and the dangers?.

Q: Determine the relationship. In…

A: To determine the relationship of ATR-FTIR with penetration depth, sample size and reflective index…

Q: why Calibration curve for agiven specie s at a fixe wavelength will become more non- linear at…

A: Lambert Beer Law According to Lambert Beer Law, the absorbance is directly proportional to…

Q: The transmittance of a solution in 1-cm cuvette is 60.0%. Calculate the transmittance of the same…

Q: Using words and/or pictures and/or equations, explain how the use of a deuterium (D2) lamp can…

A: Atomic Absorption Spectroscopy is a technique used for the quantitative determination of different…

Q: Calculate the Absorbance from concentration for each trial of 0,10, 30, 40, 50 % (with yellow LED)…

A: The Absorbance from concentration for each trial of 0,10, 30, 40, 50 % has to be calculated.

Q: the transmittance concentration pairs could have been used to determine a calibration curve. state…

A: There are limitations to the law. Some of those are the following: 1. There are no solute-solute…

Q: When analyzing a selution component by UV-visible spectrophotometry. we prepare solutions with a…

A: When analyzing a solution fraction with UV-visible spectrophotometry, it is important to…

Q: A dilute solution of caffeine was analyzed by UV-Visible spectroscopy and found to have a percentage…

A: Answer:Beer-Lambert law gives a relation between molar concentration and molar absorptivity as shown…

Q: II B C D What is the design of figure Il? double beam spectrophotometer diode array…

Q: Q3. A 1.28x10-4M solution of potassium permanganate has a transmittance of 0.5 when measured in a 1…

A: The Beer-Lambert law states that:for a given material sample path length and concentration of the…

Q: The thickness b of very thin film can be determined by the IR interference fringe method. Such…

A: The thickness of polymer material is done by preparing a thin film and observing its infrared…

Q: An empty infrared cell showed 8.9 interference fringes in the wavelength range of 1894 to 2399 cm-1.…

A: The equation required to determine the path length of cell is as follows, b=∆N2ν1-ν2

Q: as we increase the wavenumber, the penetration A. increases B. does not affect gher the reflective…

Q: The drug pentobarbital is a sedative. It was extracted from a urine sample during a particular…

Q: which Characterization techniques and instrument is usually used to analyse the particle size…

A: Analytical chemistry is branch of chemistry that do the separation, identification, and the…

Q: Helen performed an experiment with KMNO4 at 520 nm. Given the percent transmittance of 5 ppm KMNO4…

A: Answer :- ε = 2047 (L.mol-1.cm-1) The Molar absorptivity (ε) of KMnO4 solution = 2047 L.mol-1.cm-1…

Q: The diagram below represents the layout of a typical single-beam UV-Vis, explain the function of…

Q: 21 Select all the components that are part of a ICP-MS (as discussed during lectures) analytical…

A: Inductively coupled plasma mass spectrometry (ICP-MS) is one type of mass spectrometry which uses an…

Q: Components of Shimadzu Double Beam Spectrophotometer: Describe the major components of a Shimadzu…

A: As you can see in the picture above -In a double beam spectrophotometer, the instrument resembles a…

Q: A beam of light with an irradiance of Po passes through a solution of a substance that can absorb…

A: Molar absorbtivity (ε) = A/bc where, b= path length and c =…

Q: Determine the molar absorptivity of a colored solution with a concentration of 0.0455M, a pathlength…

Q: Explain difference between 1) Allowed Transition and Forbidden Transition 2) Transmittance and…

A: Hello. Since the question contains more than three sub-parts, the first three sub-parts shall be…

Question

The diagram below represents the layout of a typical single-beam UV-Vis, explain the
function of each identified part.
Computer
Exit
slits
Grating
Collimating
optics
Source
carousel
Sample
cell
Detector
Mirror
Collimating
slits
D2-lamp
Tungsten-halogen
lamp

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemistry and related others by exploring similar questions and additional content below.

Similar questions

Given the following size frequency for a dust: Size Interval (um) 7-17.5 17.5-21 21-25 25-28 28-30 30-33 33-36 36-41 41-49 49-70 % by Number 10 10 10 10 10 10 10 10 10 10 a. Plot the cumulative frequency distributions (in %) of the number, surface area, and mass on linear graph paper assuming all particles are spheres with Pp 1.6 g cm ³. = b. Is this a log-normally distributed dust?
Peak or band broadening is more likely to occur in: gradient elution or isocratic elution?
Figures below show the graphite tube and the schematic heating cycle profile for graphite furnace atomic absorption spectrometry (GF-AAS). Based on these figures, explain how the atomization process occurs in a GF-AAS. optical window sample graphite tube inert gas inlets optical window optical path, T Dry Ash Time Atomize
7
What is flame photometry The general principles of flame photometry Limitation of techniques for flame photometry (what to measure) How to use flame photometry in clinical applications
You have a concentrated sample solution of a new wine from a winery to analyze for malic acid content. once you have worked up the sample and done one 5x dilution you record an absorbance of .395 at the analytical wavelength of the malic acid. the molar absorptivity coefficient E of the malic acid for this method of measurement is 15.84 mM-1cm-1. What was the molarity of malic acid in original wine sample mM?
Using words and/or pictures and/or equations, explain how the use of a deuterium (D2) lamp can correct for spectral interference in flame atomic absorption spectrophotometry (background absorption/scattering by non- specific absorbers).
Electromagnetic radiation source for XPS * Gamma ray X-ray UV-Visible Infra red Radiowave The following are the basic components of XRD except-* Source Primary optics Sample Holder Cantilever Secondary optics W The following are the different modes at which AFM operates except- Contact mode Non-contact mode Tapping mode Adhesion mode
In Monochromators the entrance slit transmits a single A the exit slit transmits a single A the grating produce rectangular beam of radiation None is correct The full range of À is introduced to the sample All are correct as the transmitted band width is broader as the spectrum is cfearer
A sample that is 10 mM in concentration with a molar absorbance coefficient of 20 M ¹cm-² on a cuvette that is 0.5 cm in path length is analyzed by a laser for its fluorescence behavior. A calibration curve of the same molecule is given. Predict quantum yield. 1.00E+01 Flurorescence (A.U.) 1.00E+00 1.00E-01 1.00E-02 1.00E-03 1.00E-04 0.001 O 0.1 absorbance units 4x10 fluorescence units y = 0.1969x + 0.0019 R² = 1 O 8x10+ fluorescence units 0.01 Cannot be determined with the current information. 0.1 Concentration (mm) 1 10
Define the following terms: spectrophotometer, absorbance, pathlength, & (also known as molar absorptivity), concentration, transmittance, Beer's law. RODUCTION:
I’m trying but I do not understand how to get it