You are performing studies of the possibility of migrating birds using the Earth's magnetic field for navigation. To modify themagnetic field in the brain of a bird, you fit the bird with coils as "caps" and "collars" as shown in the figure below.The data on the coils indicate that they each have 210 2 of resistance, a radius of 1.20 cm, and 50 turns of wire. The centers ofthe coils are separated by 2.25 cm. You wish to create an "Earth-like" magnetic field of 5.0 x 10-5 I at the midpoint of the axisbetween the coils. Given this data, you need to determine the voltage of the battery (in V) needed to power the coils.V

Given:- The resistance R = 210 ohm The radius R = 1.20 cm = 1.20 x 10-2 m The turn N = 50 x 2 =…

The data on the coils indicate that they each have 210 N of resistance, a radius of 1.20 cm, and 50 the coils are separated by 2.25 cm. You wish to create an "Earth-like" magnetic field of 5.0 x 10-5 - between the coils. Given this data, you need to determine the voltage of the battery (in V) needed

The data on the coils indicate that they each have 210 N of resistance, a radius of 1.20 cm, and 50 the coils are separated by 2.25 cm. You wish to create an "Earth-like" magnetic field of 5.0 x 10-5 - between the coils. Given this data, you need to determine the voltage of the battery (in V) needed

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

A uniform magnetic field is perpendicular to the plane of a circular loop of diameter 9.8 cm formed from wire of diameter 2.7 mm and resistivity of 2.41 × 10-8Ω·m. At what rate must the magnitude of the magnetic field change to induce a 11 A current in the loop?
You take a conducting wire with a total length of 10.0m and form a square with it. A uniform magnetic field is oriented 30.0° above the plane of the square. If the magnitude of the magnetic field is 1.20T, what is the magnetic flux through the square? Uniform B – field - 30° 3.75 T · m² 6.50 T · m2 12.0T· m² None of the other answers. 7.50 T · m²
A square loop of wire consisting of a single turn is perpendicular to a uniform magnetic field. The square loop is then re-formed into a circular loop, which also consists of a single turn and is also perpendicular to the same magnetic field. The magnetic flux that passes through the square loop is 5.78 × 10-3 Wb. What is the flux that passes through the circular loop?
A 13-cm length of wire is held along an east-west direction and moved horizontally to the north with a speed of 2.2 m/s in a region where the magnetic field of the earth is 55 micro-T directed 28° below the horizontal. What is the magnitude of the potential difference between the ends of the wire? Write your answer in micro-volts.
So theres 2 long straight current-carrying wires are lined up parallel to one another at a distance ?d. Currents of 4 A and 2 A flow through the wires, both in the same direction generating the field of 9.2x10-6 T at a midpoint between them. Calculate the distance between the wires. Give your answer in SI units. Use ?0=4?×10−7μ0=4π×10−7 Hm-1.
The figure shows the cross section of a long conducting cylinder with inner radius a= 2cm and outer radius b-4cm. the cylinder carries a current out of the page and the current density in the cross section is given by j=cr^2 with c=3x10^6 A/m^4 and r in meters What is the magnetic field B at a point 3 cm from the central axis of the cylinder?
A five-sided object, whose dimensions are shown in the drawing, is placed in a uniform magnetic field. The magnetic field has a magnitude of 0.30 T and points along the positive y direction. Determine the magnetic flux through each of the five sides.
Four long, parallel conductors carry equal currents of I = 8.00 A. The figure shows a cross-sectional view of the conductors. The direction of currents is into the page for wires A and B and out of the page for wires C and D. Calculate the magnitude of the resulting magnetic field (in μT) at point P, located at the center of the square of edge length 0.400 m. Round your answer to 2 decimal places.
The force on a wire is a maximum of 4.38 N when placed between the pole faces of a magnet. The current flows horizontally to the right and the magnetic field is vertical. The wire is observed to "jump" toward the observer when the current is turned on. If the pole faces have a diameter of 12.9 cm, estimate the current in the wire if the field is 0.184 T. If the wire is tipped so that it now makes an angle of 15.1° with the horizontal, what force will it now feel?