The current of an LED lamp employing series connected LEDS is regulated with the feedback circuit shown in the figure. What is the maximum number of 2V-LEDS that can be connected in series in the LED lamp? The Mosfet operates in saturation. Circuit parameters / Devre Parametreleri VREF=2,6 V, Rs=100 Q, W/L=52/0.18, VDD = 44 V, H.Cox = 200 µA/W², VTH = 0.4 V, 0, A, = 00, VDD series-connected LEDS A1 VREF Rs "W-

The current of an LED lamp employing series connected LEDS is regulated with the feedback circuit shown in the figure. What is the maximum number of 2V-LEDS that can be connected in series in the LED lamp? The Mosfet operates in saturation. Circuit parameters / Devre Parametreleri VREF=2,6 V, Rs=100 Q, W/L=52/0.18, VDD = 44 V, H.Cox = 200 µA/W², VTH = 0.4 V, 0, A, = 00, VDD series-connected LEDS A1 VREF Rs "W-

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Diagram showing zero basing in field effect transistors as applied in electronics
Question-4: Design a positive biased limiter circuit (use silicon or germanium diode) that limit the output waveform at 6.3 V.
04:- Design a bias circuit for NPN silicon transistor having a nominal B-100 to be used in voltage divider circuit with Q-point of Ic 10 mA and VCE = 10 V. Use standard valued 5% resistors and draw a schematic diagram of your design. (10 points)
a ): The depletion region is a layer of positive and negative charge in the semiconductormaterial Briefly explain how the depletion region formed in the semiconductormaterial after the PN junction is created.b): An audio signal amplifier is used to reproduce input audio signals at sound-producoutput elements, with desired volume and power levels. What is the function of volumecontrol and power amplifier in an audio signal amplifier ?
Design a POWER SUPPLY with 5V output voltage. Use zener diode as a voltage regulator. Then solve for theoretical computations. Thanks!
Question 4. Design a limiter circuit using only diodes and 10 K resistor to provide an output signal limited to +1.4 V.
Sketch the voltage transfer characteristics of an ideal voltage amplifier and a real voltageamplifier. Ensure to label the important regions.
You are tasked to look for a converter circuit design that has the specifications tabulated in Table I. The aim is to produce an output voltage of 20 V which can be used to drive a load of 120 W. The converter must operate in CCM. Table I: Design Specifications Design Parameters Input voltage Switching frequency Output current ripple Output voltage ripple Values 35 V 60 kHz 5 % 1% a) Sketch the final converter and label all parameter values b) Sketch the final operating waveforms and label all parameter values c) Determine Ve.min and Vemax- Check if the output voltage ripple matches with the design requirement.
Explain the operation of a full-wave voltage quadrupler circuit (With proper explanation, equation, and diagram of each cycle).
Q10. Determine maximum and minimum value of Zener current if value of series resistance is 1 K, load resistance is 2KN and input varies from 10V to 30V. Zener voltage is 5 V. Q11. What is LED? Q12. Which materials are used in manufacturing of LEDS?
Please answer quickly thank you