The cross section at station 2+60 has a cut area of 9 ft² and a fill area of 4 ft² and the cross section at station 3+00 hasa cut area of 7 ft² and a fill area of 8 ft². What is the volume (yd) of fill between these stations? Assume no swell orcompaction.Round to the nearest hundredths.Response Feedback:AV=L-fill+A542+603+00

The cross section at station 2+60 has a cut area of 9 ft² and a fill area of 4 ft² and the cross section at station 3+00 has a cut area of 7 ft² and a fill area of 8 ft2. What is the volume (yd) of fill between these stations? Assume no swell or compaction.

The cross section at station 2+60 has a cut area of 9 ft² and a fill area of 4 ft² and the cross section at station 3+00 has a cut area of 7 ft² and a fill area of 8 ft2. What is the volume (yd) of fill between these stations? Assume no swell or compaction.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Please give a more detailed and correct solution with question C. The embankment for a highway 5097 ft long, 104 ft wide and 6 ft in compacted thickness is to be constructed from a sandy soil trucked from a borrow pit. The water content of the sandy soil in the borrow pit is 6.748% and its porosity is 0.422. The specification requires the embankment be compacted to a dry unit weight of 122.874 lb/ft3. The specific gravity is 2.588. Determine the following: a. Total weight of the soil solids, kips. b. Total volume of the soil required from the borrow pit, ft3. c. Weight of water to be added per foot length of the embankment to reach 10% moisture content, lb.Round off answers to three decimal places.
The following cross-sectional areas (m2) are calculated for centre line of a drain trench at 5 m interval 2.5 2.7 1.8 3.5 3.7 2.9 2.8 1.6 1.1 V=d[(first+last)/2)+ sum of rest cross-sectional areas] Trapezoidal formula The calculated volume in m3 of the material for the trench is; Select one: O a. 111.4 O b. 113.0 O c 104.0 O d. 118.0 O e. 34.2 Of. None of the given answers
An embankment is to be constructed at a 5% moisture content. Material will be placed at the rate of 300 ccy/hr. The specified dry weight of the compacted fill is 2,700 lb/ccy. How many Ibs of water must be dried each hour to decrease the moisture content of the material from 20% to 5% by weight?
solve quesuion 5 only
A new road is to be constructed with formation width of 20 m , side slopes of 1 vertical to 2.5 hor izontal.The heights of fill at the center line of three successive cross sections, 50 m apart, are 3.3 m , 4.1 m , and4.9 m , respectively. The existing ground has a crossfall of 1 in 10. Calculate the volume of the fill.
Explain the Compaction Control for ClayHydraulic Barriers ?
QUESTION 3 Determine the fill and cut volumes of the 10 m by 10 m grid below. A B 0.7 F 0.7 C 0.8 F 1 2 0.8 C QUESTION 10 What is the area of the cut, in square metres (m²)? QUESTION 11 What is the average cut, in metres (m)? QUESTION 12 What is the volume of cut, in cubic metres (m³)? QUESTION 14 What is the average fill, in metres (m)? QUESTION 15 What is the volume of fill, in cubic metres (m³)?
Questions:1 A 1/2 cubic metre short boom dragline having ideal output of 150 m³/hr is to be used to excavate hard tough clay. The effect of the depth of cut of 5.0 m and angle of swing of 120° shall be 0.89. The operating factor shall be 50 min/hour. Determine the probable output of the dragline. Question:2 Calculate the time required to grade and finish 30 km of road formation of 9.0 m width for two-lane road with motor grader having width of 3.0 m, using six passes with speed for each of the successive two passes as 5 kmph, 7 kmph and 9 kmph respectively. Assume machine efficiency based on operator skill, machine characteristics and working conditions as 80%.
What is the area of cut in square metre? what is the average cut in metres? what is the volume of cut in cubic metres? what is the area of the fill in metre square? what is the average fill? what is volume of full in cubic metres? QUESTION 3. Determine the fill and cut volumes of the 10 m by 10 m grid below. A B 0.7 F 0.7 C 0.8 F 0.8 C 2 1 2
Question:- Demonstrate that the contraction scour can be classified as being “live-bed” at a bridge that crosses a stream bed of fine gravel (D50 = 0.0196-ft) when the stream is flowing at 6.8 ft/sec at a depth of 8.5 ft upstream of the contraction?
Refer to Figure 2. Embankments are generally constructed in several layers that are compacted according to geotechnical specifications.layers that are compacted according to geotechnical specifications. The thickness of eachof each layer is 3ft and should have a dry unit weight of 118 lb/ft3 .. It is known that theThe soil used in the embankment has a wet unit weight of 111 lb/ft3, moisture contentmoisture content of 23%, and Gs = 2.67. Complete the following tasks:(a) Determine the wet weight of the soil required to construct the first layer.(closest to the foundation soil) per foot (ft) of the embankment.b) On the day of construction there was a heavy rain that caused the soil used to reach a nearly saturated condition.used to reach a near saturated condition. Recalculate the wet weightwet weight of soil required to construct the first layer.
solve very fast in 15 min and I need a clear answer | dybala