The crate, which has a mass of 190 kg, is subjected to the action of the two forces. (Figure 1) If it is originally at rest, determine the distance it slides in order to attain a speed of 7 m/s. The coefficient of kinetic friction between the crate and the surface is μk = 0.2. Express your answer to three significant figures and include the appropriate units

Q: determine thelargest mass of block B without causing motion of the system

A: GIVEN :- mA=2kgμs=0.15let mass of block B: mB FREE BODY DIAGRAM :-

Q: = Q8. The 3.1-kg, uniform crate starts from rest to slide down the inclined surface. If the…

A: Given data:- Mass of the crate =3.1 kg μk=0.12 g=9.81 m/s2 and S=2.7 m To find:- Work done by…

Q: The force Pis applied to the 48-kg block when it is at rest. Determine the magnitude and direction…

A:

Q: Question a) The 10-kg block has a speed of 4 m/s when the force of F = (8t²) N is applied (Figure…

A:

Q: If block A has a mass of 2.0 kg, determine the smallest mass of block B without causing motion of…

A:

Q: 30°

A: Given,  using impulse momentum equation and Free body diagram

Q: A car with a mass of 1100 kg is traveling at 50 km/hr when it locks up its brakes, stopping over a…

A:

Q: : A 5 kg block is pushed up along the slope as shown. The coefficient of kinetic friction is ?௞ =…

A:

Q: A 100kg crate is originally at rest and is subjected to two forces. Determine the distance(m) it…

A:

Q: The crate, which has a mass of 170 kg, is subjected to the action of the two forces. (Figure 1) •…

A:

Q: When s = 0, the spring on the firing mechanism is unstretched. The arm is pulled back such that s =…

A:

Q: 6. A 10 kg crate slides 1 meter down a 30 degree ramp where it comes in contact with a spring. The…

A: The mass of crate is The stiffness of spring is The compression in spring is .The distance travel by…

Q: A 100kg crate is originally at rest and is subjected to two forces. Determine the distance(m) it…

A:

Q: The 20-g bullet is travelling at 400 m/s when it becomes embedded in the 2-kg stationary block. The…

A:

Q: Determine the normal force the box exerts on the surface when it reaches point B. Neglect friction…

A: Given Data:the mass of the box m= 8Kgthe velocity of the box at point A neglecting the friction and…

Q: The 2-kg spool S fits loosely on the inclined rod for which the coefficient of static friction is μ…

A:

Forming and Shaping

Metal forming is a category of metalworking process through which the material can be given the desired shape and size by subjecting it to plastic deformation, where the component undergoes bulk deformation process upon application of loads. Unlike the shearing and machining process, the material does not undergo up to a failure point as indicated in the stress-strain curve. Hence, the stresses induced during the forming process are greater than yield strength but less than the failure strength of the material. The process does not lead to the loss of material, so it can be said to be an economical process. During forming, the material is subjected to tensile forces, compressive forces, bending, and shearing loading conditions. The material should possess the property of ductility to undergo the forming process.