Questions a/b c₁₂=c 200 10 E 5 0.291 m 20 40 289 10 0.312 200 0.323 0.328 10 1. 6.3 kNm torque is applied to a 3m long steel angle with a 200mm x 200mm x 10mm cross section. From tabulated properties for equal angles, the gross cross sectional area of the section is 5090 mm². knowing that G = 77 GPa, determine (a) the maximum shearing stress along line m-m. Provide the answer in MPa with precision n to two decimal points. 2. Determine the angle of twist if 1.7 kNm of torque is applied to the above long angle steel. Provide the answer in Degrees with precision to two decimal points.

Q: a) Determine thę centroid location (measured upward from the bottom), in mm rounded to the nearest…

A:

Q: ENGINEERING MECHANICS: STATICS (J.L.MERIAM) 2/8: Two forces are applied to the construction bracket…

A:

Q: A solid circular steel shaft of diameter 20 mm is enclosed within a brass hollow circular shaft of…

A:

Q: The cross section of the steel tube (G = 11 x 106) as nown carries a 50 kip-in torque. Calculate (a)…

A:

Q: The beam shown is made of a nylon for which the allowable stress is 24 MPa in tension and 30 MPa in…

A:

Q: Question The electric motor exerts 600 Nm torque on the aluminum shaft ABCD when it is rotating at a…

A: T = 600 Nm GBC = 16 GPa or 16000 MPa GCD = 12 GPa or 12000 MPa dBC = 30 mm

Q: y supported beam shown consists of a W410 × 60 structural steel wide-flange shape [E = 200 GPa; I =…

A: Given data E = 200 GPa = 2 × 105 N/mm2 I = 216 × 106 mm4

Q: A steel rod (E-29000ksi) was pulled by a 2kip force. The initial length of the rod is 3ft and the…

A:

Q: Question 2: The young modulus of the shaft shown in figure below is 80 GPa Diameter of the shaft AB…

A: Given: The young modulus of the shaft is 80 GPa. The diameter of the shaft AB is 55 mm. The diameter…

Q: The steel beam shown in the figure 2 is made by a steel type that has σY=250 MPa and σU=400MPa…

A: To find maximum torque

Q: Bar ABCD is rigid and rotates freely about B. Determine the vertical displacement of point D given…

A:

Q: Bodies A and B are joined by a cord parallel to the inclined plane shown in the figure. Under body A…

A:

Q: A steel bar AD has a cross-secțional area of 260 mm? and is loaded by forçes P, = 12 kN. P,= 8 kN.…

A:

Q: allowed.

A: Given data- Diameter of the solid segment 1 d1 = 41 mm= 0.041mDiameter of the solid segment 2 d2 =…

Mechanics of Solids

It is the study of the behavior of solid materials, their characteristics under various circumstances such as variation in external forces, temperature, and other internal factors. It is one of most important study in the field of engineering science, especially chemistry and mechanical engineering. In rigid body, the idealization of the solid body in which deformation is neglected. Deformation is known as the force acting on the solid state system which exerts change in its shape of the body but it continues to be at rest or in a uniform motion but it cannot accelerate. But those solid systems do have elasticity, compressibility and can be bent. This field is very vast since there are wide range of materials around us.