The beam is supported by a pin at C and by a short link AB. Each pin has a diameter of 20 mm. Assume L = 1.5 m and 0 = 35°. If the average shear stress in the pins at A, B, and C cannot exceed 120 MPa, determine the maximum distributed load Wmax that can be supported by the structure. P T B Answer: Wmax= i kN/m L

Q: The boom supports the two vertical loads, F = 800 N and F2 = 350 N. Neglect the size of the collars…

A:

Q: The cantilever strut is subjected to the point loads P1 = 1.4 kN and P2 = 2.8 kN. Determine the…

A: A loading beam With LoadsP1=1.4 kNP2=2.8 kNTo determine: Shear stress at point B

Q: The pole BC is supported by a pin C and by the steel wire AB. A horizontal force of 30 kN is acted…

A: Given data, Horizontal force at E, FE = 30 KN Ultimate shear stress of the pin, 𝞽ut = 100 MPa…

Q: Provide final answer and equations used.

A:

Q: The rectangular bar is connected to the support bracket with a 10-mm-diameter pin. The bar width is…

A:

Q: Determine the average shear stress developed in the nails within region AB of the beam. The nails…

A: Step 1: Step 2: Step 3: Step 4:

Q: 250 mm D 750 mm 120 N•m The two shafts are made of A-36 steel. Each has a diameter of 25 mm, and…

A:

Q: The allowable shear stress is Tallow = 805 psi. The supports at A and B are smooth. B 3 ft 6 ft -3…

A: Find the maximum allowable distributed load Given data  Maximum shear stress = 805 psi

Q: The tube has an inner diameter d; = 20 mm and an outer diameter d, = 22 mm. It is subjected to an…

A: In strength of material , Properties and failure of material is analyzed. Material is failed due to…

Buckling of columns

The column is described as a vertical member of the structure that carries an axial compressive load, and buckling is a lateral deformation of the column under the application of load.