The 20 kg roll of paper has a radius of gyration kA = 85 mm about an axis passing through point A. It is pin supported at both ends by two brackets AB. If the roll rests against a wall for which the coefficient of kinetic friction is μk = 0.25 and a vertical force F = 30 N is applied to the end of the paper, determine the angular acceleration of the roll as the paper unrolls

Q: The spool has a mass of 90 kg and a radius of gyration of kg = 0.3 m. igure 250 mm G 400 mm Part A…

A: Given data : The mass of the spool m=90 kg. The radius of gyration kg=0.3 m. The coefficient of…

Q: after the decimal point. Take g = 9.81 m/s². r 0 F

A: Given,

Q: Determine the magnitude P and direction 0 of the force required to impart a rearward acceleration a…

A:

Q: The two uniform 4-kg bars DC and EF are fixed (welded) together at E. Determine the normal force NE,…

A:

Q: 6/40 If the frictional moment at the pivot O is 2 N m, de- termine the angular acceleration of the…

A: Consider below FBD for the given question: Here,  m1 = 12 kg m2 = 7 kg r1 = 200 mm = 0.2 m r2 = 300…

Q: The 24-kg wheel has a radius of gyration about its center O of ko = 260 mm, and radius r= 0.4 m.…

A:

Q: The homogeneous cylinder of mass m and radius R is placed on the cart and restrained by a horizontal…

A:

Q: The 17-kg wheel is rolling under the constant moment of M = 85 N-m. The wheel has radius r= 0.50 m,…

A:

Q: The 10-kg wheel is rolling under the constant moment of M = 97 N-m. The wheel has radius r= 0.59 m,…

A:

Q: 4. The uniform slender rod has a mass m= 20 kg and length L = 0.5 m. As the frame accelerates…

A:

Q: A 20kg slender rod AB is pinned to a roller at A that slides freely along the slot as shown in the…

A: mass of the rod, m = 12 kg             couple moment of M = 5 N.m  acceleration of…

Q: The mass of gear A is 25 kg and its centroidal radius of gyration is 105 mm. The mass of gear B is…

A:

Q: The 200-kg spool has a radius of gyration about kG its mass center of kg = 300 mm. If the couple…

A:

Q: If P = 30 lb, determine the angular acceleration of the 50-lb roller. Assume the roller to be a…

A: Given data as per questionForce = 30 lbRoller weight =50 lbTo solve this, we need two more…

Q: The 25-kg roll of paper has a radius of gyration kA - 90 mm about an axis passing through point A.…

A:

Q: The circular concrete culvert rolls with an angular velocity of w=0.58 rad/s when the man is at the…

A:

Forming and Shaping

Metal forming is a category of metalworking process through which the material can be given the desired shape and size by subjecting it to plastic deformation, where the component undergoes bulk deformation process upon application of loads. Unlike the shearing and machining process, the material does not undergo up to a failure point as indicated in the stress-strain curve. Hence, the stresses induced during the forming process are greater than yield strength but less than the failure strength of the material. The process does not lead to the loss of material, so it can be said to be an economical process. During forming, the material is subjected to tensile forces, compressive forces, bending, and shearing loading conditions. The material should possess the property of ductility to undergo the forming process.