The 11-kg homogeneous plank of length L = 9.4 m and width d = 0.5 m rotates about trestle Aand strikes trestle B without rebounding. If the angular velocity of the plank, just before theimpact, is 2 rad/s clockwise, determine the angular speed of the plank just after impact. Thedistances from the tips of the plank to the trestles are al and bL, where a = 0.11 and b = 0.33.blL(1 -a - b)alL(1 – a – b)AB

Answered: Image /qna-images/answer/89d9ff25-5b02-42e5-8c3e-a309d2f8c9d8.jpg

The 11-kg homogeneous plank of length L = 9.4 m and width d = 0.5 m rotates about trestle A and strikes trestle B without rebounding. If the angular velocity of the plank, just before the %3D impact, is 2 rad/s clockwise, determine the angular speed of the plank just after impact. The distances from the tips of the plank to the trestles are alL and bL, where a = 0.11 and b = 0.33. %3D bL L(1-a-b)

The 11-kg homogeneous plank of length L = 9.4 m and width d = 0.5 m rotates about trestle A and strikes trestle B without rebounding. If the angular velocity of the plank, just before the %3D impact, is 2 rad/s clockwise, determine the angular speed of the plank just after impact. The distances from the tips of the plank to the trestles are alL and bL, where a = 0.11 and b = 0.33. %3D bL L(1-a-b)

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

lb ft The wheel shown has a weight of 30 lb and a radius of gyration of kg = 0.6 ft. It is attached to a spring which has a stiffness k = 2. and an unstretched length of 1 ft. If the disk is released from rest in the position shown and rolls without slipping, determine its angular velocity at the instant G moves 3 ft to the left. 4 ft Sommi k = 2 lb/ft -3 ft 0.75 ft
The spring is uncompressed when the uniform sender bar AB is in the vertical position shown. Bar AB with a mass of 50 kg and a length of 1 m is released from rest in the position where the bar has been rotated 30° clockwise from the position shown. This initial position of the bar AB is illustrated using the dashed line in the figure. Neglect any sag of the spring as well as the spring mass. (b) Find the angular velocity of the bar when it reaches the vertical position. A Initial position of the bar AB when it is released from rest k=12 kN/m Answers: (a) a = 198.951 rad/s² (b) 2 = 10 rad/s 30º B
The mass center of the 7-1b ball has a velocity of (vc)1 = 6 ft/s when it strikes the end of the smooth 5-lb. slender bar which is at rest (Eigure 1) Figure Part A wi-4.239 Submit B HÅ 051 Determine the angular velocity of the bar about the z axis just after impact if e=0.7 Express your answer with the appropriate units. rad (a)i-6 ft/s S P-05 ft Answers Request Answer ? x Incorrect; Try Again; 5 attempts remaining 1 of 1
The small end rollers of the 6.2-lb uniform slender bar are constrained to move in the slots, which lie in a vertical plane. At the instant when e = 30°, the angular velocity of the bar is 2.6 rad/sec counterclockwise. Determine the angular acceleration of the bar, the reactions at A and B, and the accelerations of points A and B under the action of the 5.1-lb force P. Neglect the friction and mass of the small rollers. The angular acceleration is positive if counterclockwise, negative if clockwise. The acceleration of A is positive if downward, negative if upward. The acceleration of B is positive if down the slot, negative if up the slot. The reaction at A Is positive If to the right, negative If to the left. The reaction at 8 Is positive If up and to the right, negative If down and to the left. L= 5.2 ft 107 P= 5.1 lb Answers: Jad/sec? F = Fg =
The 35 lb slender rod AB is 277 in. long and at rest in a horizontal position supported by a spring located at h = 226 in. from the suspension cable at B. If the cable at B fails, answer the following 1) Part A: Determine the magnitude of the acceleration of end A. 2) Part B: Determine the magnitude of the acceleration of end B. 3) Part C: Determine the angular acceleration of the rod.
The 18-kg rod AB is pin-connected at A and subjected to a couple moment of M =15 N- m The rod is released from rest when the spring is unstretched at 0 = 30°. As the rod rotates, the spring always remains horizontal, because of the roller support at C. (Figure 1) Determine the rod' s angular velocity, measured clockwise, at the instant 0 = 60°. Express your answer using three significant figures. Enter positive value if the angular velocity is clockwise and negative value if the angular velocity is counterclockwise. vec rad/s k = 40 N/m 0.75 m M = 15 N- m
The uniform slender rod AB of weight 5 lb and length 30 in. forms an angle = 30° with the vertical as it strikes the smooth corner shown with a vertical velocity v₁ of magnitude 17 ft/s and no angular velocity. Assuming that the impact is perfectly plastic, determine the angular velocity of the rod immediately after the impact. В A G B The angular velocity of the rod immediately after the impact is rad/s O.
19–34. The platform swing consists of a 200-lb flat plate suspended by four rods of negligible weight. When the swing is at rest, the 150-lb man jumps off the platform when his center of gravity G is 10 ft from the pin at A. This is done with a horizontal velocity of 5 ft/s, measured relative to the swing at the level of G. Determine the angular velocity he imparts to the swing just after jumping off. 10 ft 11 ft 4 ft-
6/183 The uniform concrete block, which weighs 171 lb and falls from rest in the horizontal position shown, strikes the fixed corner A and pivots around it with no rebound. Calculate the angular velocity w of the block immediately after it hits the corner and the percentage loss n of energy due to the impact. 32" 24" 11"- 12" A Problem 6/183
Part A The 100-kg spool is resting on the inclined surface for which the coefficient of kinetic friction is uz = 0.12. The radius of gyration about the mass center is kg = 0.25 m (Figure 1) Determine the angular velocity of the spool, measured clockwise, when t = 6 s after it is released from rest. Express your answer using three significant figures. Enter positive value if the angular velocity is clockwise and negative value if the angular velocity is counterclockwise. VO A£¢ !f vec ? W = rad/s Figure 1 of 1 > Submit Request Answer Provide Feedback Next > 0.4 m 0.2 m 30°
Draw the impulse-momentum diagram and line of action for e. Solve for the following: 1. Determine the angular velocity of the slender bar (B) immediately after impact. angular velocity of A = 57.1 rad/s since there is no external torque 2. Determine the linear velocities of both the sphere (A) and the slender bar (B) immediately after impact at their centroids ANSWERS I GOT BUT ARE INCORRECT: (the unit is given) angular velocity of the slender bar (B) immediately after impact: 8.089 rad/s , 18.49 rad/s linear velocity of the sphere (A) immediately after impact at the centroid: 0.485 rad/s^2, 0.16 rad/s^2, 2.11 rad/s^2 linear velocity of the slender bar (B) immediately after impact at the centroid: 0.485 rad/s^2, 0.49 rad/s^2, 2.21 rad/s^2
The uniform 80 kg slender rod is at rest in the position shown when P = 450 N is applied. Determine the value of angular velocity, w2 the rod if L1 = 5.5 m and L2 = 6.5 m. A L L2 L1 B