The 0.5-lb particle is guided along the circular path using the slotted arm guide. If the arm has an angular velocity ?̇ = 8 rad/s and an angular acceleration ?̈ = 4 rad/s2 at the instant ? = 30°, determine the force of the guide on the particle. Motion occurs in the horizontal plane. Show every single step of the solution please

Q: The spring-held follower AB has a mass of 0.4 kg and moves back and forth as its end rolls on the…

A:

Q: At the instant shown, the spring is undeformed. Determine the change in potential energy if the 20…

A:

Q: -4 m 0.5m 3 m/s²

A: Given:Mass of the concrete culvert, m=636 kgMean radius of the culvert, r=0.5mAcceleration of the…

Q: moment c Angular velocity

A:

Q: The dynamic system is initially at rest. The rod has a mass of m=0.5kg and a length of L=1m. The CG…

A: To find: The acceleration of the rod at CG and the Reaction at O. Given: The length of the rod, L =…

Q: The telephone-cable reel rolls without slipping on the horizontal surface. If point A on the cable…

A:

Q: The robot arm is elevating and extending simultaneously. At a given instant, 0 = 38", 0 = 32 deg/s,…

A:

Q: A small block having a mass of m kg is given a horizontal velocity vo when it slides along the…

A:

Q: Q2 The constant tensions of 200 N and 160 N are ap- plied to the hoisting cable as shown. If the…

A:

Q: The 0.2-Kg pin P is constrained to move in the smooth curved slot. Which is (0.6 cos20) m. Its…

A: (a) To find: The force exerts by arm OA on the pin when θ=0°. The acceleration in the r and θ…

Q: OR COSI The 10-kg bar is released from rest in the horizontal position 1 and falls to position 2.…

A: Write the given data with suitable variables. Ls=0.6 mk=20 N/mm=10 kgLb=1 m

Q: 6/139 The constant tensions of 200 N and 160 N are applied to the hoisting cable as shown. If the…

A: The maximum tension, T1 = 200 N The minimum tension, T2 = 160 N The radius of drum, r = 300 mm = 0.3…

Q: 1. What is the vertical acceleration and normal velocity when the spring is stretched an extra…

A: We have  (d1)=0.70.7 mm (Wrong)So take it(d1)=((0.707) mm) (d2)=0.10.1 mm (Wrong)So take…

Q: 2. Consider the 5-1lb bar with length of 2½ feet and width of 2 inches. Small frictionless bearings…

A: FREE BODY DIAGRAM is a diagram of the system which represents all the forces acting on the system.…

Q: A smooth can C, having a mass M = 3 kg, is lifted from a feed at A to a ramp at B by a rotating rod.…

A: Here the data are- θ=30° θ'=0.5 rad/s M=3 Kg r=2bcosθ b=600 mm=0.6m

Q: 8. The garage door has a weight of 220 lb and a center of gravity at G. The man pushes on it with a…

A:

Q: 3/319 The block of weight W is given an initial velocity U1 20 ft/sec up the 20° incline at point A.…

A:

Q: The system is at rest with the spring unstretched when = 0. The 3-kg particle is then given a slight…

A: (a) To find: The spring constant k. Given: The mass of the particle is m=3 kg. The system is in rest…

Q: 2- As the hydraulic cylinder rotates about 0, the exposed length I of the piston rod P is controlled…

A:

Q: 5- The slotted arm OA rotates about a fixed axis through O. At the instant under consideration, 0 =…

A:

Q: 5. 1) As shown in the image below, the snowmobile has a weight of 259 lb, centered at G1, while the…

A: INTRODUCTION : The net forces on the body will be equal to zero at the static condition. But when…

Q: A smooth can C, having a mass of 5 kg, is lifted from a feed at A to a ramp at B by a rotating rod.…

A: Given: θ˙=0.5 rad/sθ¨=0r=1.2 cosθm=5 kgr=600 mm

Q: The slender g bar AB is horiontal and at rest. The spring has an unstretched length sof1mand a…

A:

Q: The man pushes on the roller with force P through a handle that connects to the central axle of the…

A:

Q: Rod OA rotates counterclockwise at a constant angular rate e = 4 rad/s. The double collar Bis…

A:

Q: 1) Determine the force of the guide of the circular path on the pin when theta = 60° Express your…

A: mass m = 70 g = 0.07 Kg  r = (0.8sinθ) θ = 60°  Stiffness k = 30 N/m Unstretched length = 0.25 m.…

Q: *13=108. The collar, which has a weight of 3 lb, slides along the smooth rod lying in the horizontal…

A: The weight of the collar is W=3 lb. The angular rate of the collar is θ˙=4 rad/s. The expression for…

Q: When in the mode of adsorbing, the vertical shaft is rotating with an angular velocity of 3 rad/s at…

A: Given:At , the angular velocity is The mass of rod AB and CD each The length of AB and CD is The…

Conservation of Energy

In physics, the rule of the conservation of energy states that energy doesn’t disappear from the atmosphere; instead, it changes its form from one type to another. Energy is one of the most important physical quantities in nature, and it cannot be created or destroyed — only transformed.