Answered: Swell under overburden and Depth from…

Swell under overburden and Depth from ground surface (ft) estimated foundation surcharge pressure, sw(1) (%) 4 4.75 2.75 8 1.5 10 0.6 12 0.0

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

A
A column foundation [ 2.0 m x (1.7m] in size is located at a depth of 1.4 m in a strong cohesive soil layer 2.4 m thick has a unit weight of 19.7 kN/m3, cohesion of 29 kN/m2 and , friction angle of 28o. This layer overlies a weaker cohesive soil layer 15 m thick has a unit weight of 16.3 kN/m3, cohesion of 8 kN/m2 and friction angle of 20o. Determine the allowable foundation load if the factor of safety is 2.5. Show all the related labeled sketches clearly.
A circular foundation 2m in diameter is shown in the figure below. A normallyconsolidated clay layer 5m thick is located below the foundation. Determine the consolidation settlement of the clay. 1- method 2:1 2- consolidation settlement Cc method
You are requested to design a column for PD = 225 k and PL = 400 k, using A992 steel with KL =16ft. A W14 x 68 is available but may not provide sufficient capacity. If it does not, cover plates may be added to the section to increase the W14's capacity. Design the cover plates to be 12 inch wide and welded to the flanges of the section to enable the column to support the required load (see figure below). Determine the minimum plate thickness required, assuming the plates are available in 1/16th-in increments.
For the embedded strip footing (infinitely long in the out-of-plane direction) shown below, the maximum vertical pressure that the soil can bear before failure is 100 kPa (i.e., qmax should not exceed 100 kPa). What is the maximum overall eccentricity of the foundation in mm before failure? (answer tolerance = 2%). Consider γconcrete = 25 kN/m3, γsoil = 18 kN/m3 and assume that the width of the embedded column is negligible, and the entire top of the foundation is covered with soil. Hint: for a strip footing, the calculations should be conducted assuming a 1-m long footing in the out-of-plane direction.
A circular footing with a radius of r = 4.0 ft will be embedded D = 2 ft in uniform clay. The top of the foundation is at the surface. The water table is at the ground surface. An intact sample of the clay with Gs=2.75 was obtained using a thin-walled Shelby tube from a depth of 10 ft below the ground surface. The sample was saturated and has a gravimetric water content of 45 %. Estimate its void ratio e0 and total unit weight y _in pcf. Ovp' = 800psf Void Ratio 1.5 1.4 1.3 1.2 1.1 1.0 0.9 0.8 do 10 0.1 0 2 z/r, depth in radii 6 7 8 9 Cr = 0.07 100 1000 Effective Stress (psf) 0.2 0.3 0.4 0.6 0.81.0 7.0 10.0 Cc = 0.3 8.0 9.0 5.0 6.0 I, stress in percent of surface contact pressure 2 3456 8.10 10000 3.0 2.5 (2.0) 1.25 20 30 40 50 60 80 100 1.0 PAG 0.75 Note: Numbers on curves indicate offset distances in radii, x/r. 2r Z 0.5 0₂- KAB X 0.25 IX q 100 0, 10 FIGURE 4.10 Chart for calculating the increase in vertical stress beneath a uniformly loaded circular area. (From NAVFAC DM-7.1, 1982,…
11.17 A plate load test was conducted in sand on a 300 mm diameter plate. If the plate settlement was 5 mm at a pressure of 100 kPa, the settlement (in mm) of a 5 m x 8 m rectangular footing at the same pressure will be
Consider Figure FE 3. Compute the difference in the primary consolidation settlement. Further, if foundation B is to be loaded with an additional 150 kN, suggest an increase in dimension for said foundation if a differential settlement of 20 mm is not to be exceeded. You may use the equation for primary consolidation settlement of HomvΔσv.
Please answer question 3b Question 3b
4. A square foundation will be constructed at ground surface. The subsoil profile is shown in the figure below. The mat will have a net uniform load of 500 psf at El. O. The mat will have a net uniform load (Induce stress) at El. -15 of 360 psf, the primary consolidation settlement (in.) of the clay layer directly below the center of the foudnation is? fr ORIGINAL GROUND SURFACE ELEV. O ft ELEV-5 ft. ELEV-10 ft ELEV-20 ft 30 ft SAND Y = 115 pcf MAT FOUNDATION SAND Y = 105 pcf GROUNDWATER TABLE NORMALLY CONSOLIDATED CLAY SATURATED UNIT WEIGHT = 95 pcf COMPRESSION INDEX C₂ = 0.29 VOID RATIO=1.0
This is for foundation engineering review. Please show work and choose from the answer choices
In a plate load test on sandy soil, the test plate of 60 cm x 60 cm undergoes a settlement of 5 mm at a pressure of 12 x 104 N/m². What will be the expected settlement of 3 m x 3 m footing under same pressure?