Part A) Too much current can be a bad thing. When too much current flows through a wire, the wire heats up and eithermelts or causes a fire. Turning on too many appliances at the same time can cause a large amount of current to flowthrough the wiring in your home. Since this can be a dangerous thing, most homes are protected by a circuit breaker. Acircuit breaker monitors the amount of current and shuts it down if the current becomes larger than a specified value.Suppose the circuit in your kitchen is protected by a circuit breaker that shuts off the current when it reaches 10amperes. A new toaster oven that you have just purchased has a resistance of 8 ohms. When you plug the toaster intothe 120-volt electric outlet, does the circuit breaker shut off? yes / no. Why or why not?Part B) What is the power rating of the toaster? In other words, how much power does the toaster normally consume?Show your work below:

Write the provided value with suitable variables.Current required in toaster oven will be By this, we get Current required in toaster oven is greater than circuit breaker current. Thus to protect the circuit in kitchen, current will shut off when it reaches to 10A. Due to which circuit will disconnected after 10A. Therefore, circuit breaker will shut off.(b) Power Rating of the toaster is

Science

Physics

Suppose the circuit in your kitchen is protected by a circuit breaker that shuts off the current when it reaches 10 amperes. A new toaster oven that you have just purchased has a resistance of 8 ohms. When you plug the toaster into the 120-volt electric outlet, does the circuit breaker shut off? yes /no. Why or why not? Part B) What is the power rating of the toaster? In other words, how much power does the toaster normally consume? Show your work below:

Suppose the circuit in your kitchen is protected by a circuit breaker that shuts off the current when it reaches 10 amperes. A new toaster oven that you have just purchased has a resistance of 8 ohms. When you plug the toaster into the 120-volt electric outlet, does the circuit breaker shut off? yes /no. Why or why not? Part B) What is the power rating of the toaster? In other words, how much power does the toaster normally consume? Show your work below:

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Related questions

Q: When switch S in the figure is open, the voltmeter V of the battery reads 3.09 V. When the switch is…

Q: How much power is dissipated by the 12 Ω resistor in the figure? Express your answer in watts.…

Q: Resistors in series or in parallel can be treated as a single “equivalent resistor”By using…

A: Given data: Resistance of each resistor is R Circuit diagram

Q: Q1. Calculate the value of current through each resistor, the total current, and the total…

Q: A 1500-W heater is designed to be plugged into a 120-V outlet. Part A What current will flow through…

Q: Three resistors are connected as shown below. R1 = R2 = R3 = 62 Ω. The voltage across the battery is…

Q: Part A In the circuit shown in the figure (Figure 1) the batteries have negligible internal…

Q: In the circuit shown, two identical 1.5 V batteries (with the positive or high potential ends…

A: As the bulb A and B are of same resistance, and are connected in parallel, then current through the…

Q: Consider the circuit below and answer the following questions. In this sketch, V=5 V, R1=100 2,…

A: Given Data:- Potential of the battery is V=5 V Resistance of the resistors are R1=100 Ω, R2=300 Ω,…

Q: Need help with part b please !!!!!! (a) What is the hot resistance (in Ω) of a 29 W light bulb…

A: The following data are given: Operating Resistance, R0= 496.5 Ω Operating Temperature, T0=2700°C…

Q: 2. Using Kirchoff's rules, analyze the circuit below. Assume the resistive elements obey Ohm's law.…

A: Given:- Using Kirchoff’s rules, analyze the circuit below. Assume the resistive elements obey…

Q: A 30.0 ohm resistor is connected in parallel to a 15.0 ohm resistor. These are joined in a series to…

Q: Consider the following circuit ww R1 R2 3 where V = 10.0V, R2 = 10.0kN and R3 = 20.0k2. 1. Are the…

Q: A voltmeter is (incorrectly) inserted into a circuit as shown.a. What is the current in the…

Q: 1. Are the resistors connected in series or parallel? 2. What is the equivalent resistance of the…

A: Given V = 30V , R1= 3ohm , R2= 3ohm

Q: A 250 V battery is connected in series to a 30 Ω resistor that is then connected to a 100 Ω resistor…

Q: Trace the flow of energy in the diagram. How does the circuit demonstrate the transformation of…

A: A light bulb is connected to a battery using two wires. As the current flows, the bulb lights up.

Q: For the following questions, you do not need to understand the physics. Just focus on working with…

A: Part(a):Two resistors connected in parallel.The equivalent of theses resistances is Find:Simplyfy…

Q: ▼ Part A What is the internal resistance of a 12.0-V car battery whose terminal voltage drops to 9.3…

Q: In the circuit shown in, the switch has been open for a long time and is suddenly closed. Neither…

Q: Cost of Electricity A refrigerator is an appliance that is left running all the time. In New…

Concept explainers

Ohm's law

Ohm’s law is a prominent concept in physics and electronics. It gives the relation between the current and the voltage. It is used to analyze and construct electrical circuits. Ohm's law states that the voltage across a conductor is directly proportional to the current flowing through it.

Path of Least Resistance

In a series of alternate pathways, the direction of least resistance is the actual or metaphorical route that offers the least resistance to forwarding motion by a given individual or body.

Question

100%

Part A) Too much current can be a bad thing. When too much current flows through a wire, the wire heats up and either
melts or causes a fire. Turning on too many appliances at the same time can cause a large amount of current to flow
through the wiring in your home. Since this can be a dangerous thing, most homes are protected by a circuit breaker. A
circuit breaker monitors the amount of current and shuts it down if the current becomes larger than a specified value.
Suppose the circuit in your kitchen is protected by a circuit breaker that shuts off the current when it reaches 10
amperes. A new toaster oven that you have just purchased has a resistance of 8 ohms. When you plug the toaster into
the 120-volt electric outlet, does the circuit breaker shut off? yes / no. Why or why not?
Part B) What is the power rating of the toaster? In other words, how much power does the toaster normally consume?
Show your work below:

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps with 4 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

Part D
The 10 Ω resistor in (Figure 1) is dissipating 36 W of power. How much power is the 5.0 Ω resistor dissipating? Express your answer with the appropriate units. How much power is the 20 Ω resistor dissipating? Express your answer with the appropriate units.
Problem 19: Consider a 1.36 kW short circuit through a 0.095 resistance. What voltage is involved in the short circuit, in volts? AV=I
Consider a circuit consisting of a battery and two bulbs. Explain why the following two statements are direct consequences of the preceding definitions. A. When two bulbs are connected in series, the same current that passes through one bulb must also pass through the other. B. When two bulbs are connected in parallel, current that passes through one bulb does not pass through the other.
A student calculates the total potential difference of a circuit given the total current and total resistance for the circuit. The student works a new version of the question where the power has been changed by a factor of 0.693. Determine the factor by which the answer would change. 0.693 It does not change or it does not make sense to calculate given this information. 0.480 1.443
3. Write down the equation for V for this RC circuit and describe the relationship between the variables. For example, if C remains constant and R is larger, the potential difference changes (faster/slower/stays the same). 4. Write another sentence for V vs. C if R remains constant and C is increased.