Suppose that the Stop & Wait flow control mechanism (containing source and destination hosts) is configured in a system to provide reliability in frame transmissions. Assume that the environment being configured has 8000 bits of frame size and the available bandwidth at the source side is 80 Kbps. Similarly, assume that the acknowledgment packet size is 800 bits and the available bandwidth at the destination side is 8 Kbps. The round trip time in the system is 200 ms. Supposing that there is no loss of frames in this network environment, what should be the effective bandwidth utilization of the sender? (Note: the answer must be in bytes/s only)

Q: Assume a shared connection of 1 Mbps (for example, an Ethernet bus). How long does it take (in…

A: - We have to calculate the time required to transmit thousand bit frame over connection of 1 mbps.

Q: Suppose you are designing a sliding window protocol for a 2-Mbps point-to-point link to the moon,…

A: Given- Bandwidth = 2 Mbps Propagation delay (Tp) = 1.25 sec Packet size = 1 KB = 210B= 210*8 bits

Q: Computer Science assume a frame is traveling from Station A to Station B. The switches have been…

A: Actually, LAN is a Local Area Network.

Q: ng message pássing- 2nd, 5th an at message's successfully transfe

A: Q

Q: Consider a 1Mbps transmission channel. The clock at the receiver has a drift of 1 second in one…

A: In the rapidly evolving world of telecommunications, precise synchronization is paramount to…

Q: Suppose hosts A and B are connected by a link. Host A continuously transmits the current time from a…

A: (a) The clock at the end of A begins at 0000. The bandwidth is sufficient to allow writing every…

Q: Consider a CSMA/CD network that transmits data at a rate of 400 x 106 bits per second. The maximum…

A: Introduction : Given  ,A CSMA/CD network data rate = 400 x 106 bits /second.Tp = 20 microsecondsWe…