Calculate the latency (from first bit sent to last bit received) for the following: (a) 100-Mbps Ethernet with a single store-and-forward switch in the path and a packet size of 12,000 bits. Assume that each link introduces a propagation delay of 10 us and that the switch begins retransmitting immediately after it has finished receiving the packet. (b) Same as (a) but with three switches. (c) Same as (a), but assume the switch implements "cut- through" switching; it is able to begin retransmitting the packet after the first 200 bits have been received.

Calculate the latency (from first bit sent to last bit received) for the following: (a) 100-Mbps Ethernet with a single store-and-forward switch in the path and a packet size of 12,000 bits. Assume that each link introduces a propagation delay of 10 us and that the switch begins retransmitting immediately after it has finished receiving the packet. (b) Same as (a) but with three switches. (c) Same as (a), but assume the switch implements "cut- through" switching; it is able to begin retransmitting the packet after the first 200 bits have been received.

Database System Concepts

7th Edition

ISBN:9780078022159

Author:Abraham Silberschatz Professor, Henry F. Korth, S. Sudarshan

Publisher:Abraham Silberschatz Professor, Henry F. Korth, S. Sudarshan

Chapter1: Introduction

Section: Chapter Questions

Problem 1PE

See similar textbooks

Similar questions

Compute the propagation delay in this case.
Within Ethernet protocol, which address type is most significant?
2. In the Ethernet packet, the "Data" part is used to contain data send from source to destination and vice versa. The minimum number of data bytes is 46; what if the data is less by 2 bytes
# Write four functions of the data link layer. What is the importance of calculating minimum hamming distance?
A CSMA/CD LAN has minimum frame size 100 bytes and is running at 100 Mbps. The signal speed in the cable is 200,000 km/sec and the delay generated by the repeaters can be ignored. What is the maximum size the bus can have? (Note: ignore signal attenuation).
A planet located far from Earth is around 9 x 1010 meters away. If a stop-and-wait protocol is employed for frame transmission on a 64 Mbps point-to-point link, what is the channel utilization? Assume that the speed of light is 3 108 m/s and that the frame size is 32 KB.
What distinguishes a network that changes between circuits from one that switches between packets is the way in which the data is sent.What is it that TDM accomplishes better than FDM in a network that uses circuit switching?
Calculate the delay x bandwidth product for the following links. Use one-way delay, measured from first bit sent to first bit received. (a) 100-Mbps Ethernet with a delay of 10 μs. (b) 100-Mbps Ethernet with a single store-and-forward switch like that of Exercise 16(b), packet size of 12,000 bits, and 10 μs per link propagation delay. (c) 1.5-Mbps T1 link, with a transcontinental one-way delay of 50 ms. (d) 1.5-Mbps T1 link between two groundstations communicating via a satellite in geosynchronous orbit, 35,900 km high. The only delay is speed-of-light propagation delay from Earth to the satellite and back.
Assume there is a 1 Mbps shared connection (e.g. Ethernet bus). How long (in microseconds) does it take to send a 1000-bit frame over this link?
In the context of Ethernet, what is full-duplex operation?
Show clearly all working explaining detailly each step
Please provide the justification on the answers. why you decide to use the formula you applying to part b.