Answered: Suppose that a rectangular toroid has… | bartleby

Related questions

Question

Suppose that a rectangular toroid has 3000 windings and a self-inductance of 0.05 H.
If h = 20 cm, what is the ratio of its outer radius to its inner radius?
da

Expert Solution

Step by step

Solved in 4 steps with 4 images

SEE SOLUTION Check out a sample Q&A here

Blurred answer

Similar questions

A large superconducting magnet, used for magnetic resonance imaging, has a 65.0 H inductance. If you want current through it to be adjustable with a 1.50 s characteristic time constant, what is the minimum resistance of system?
A loop of wire has a self-inductance of 5.5 mH. You pass a current of 9.0 Amps though the loop, and then drop the current to 0 at a contastant rate over 3.5 seconds. What is the EMF generated?
What is the self-inductance (in mH) of a solenoid 31.6 cm long having 397 turns of wire and a cross- sectional diameter of 14.7 cm? mH
Tarik winds a small paper tube uniformly with 173 turns of thin wire to form a solenoid. The tube's diameter is 7.95 mm and its length is 2.07 cm. What is the inductance, in microhenrys, of Tarik's solenoid? inductance: µH
A solenoid with 465 turns has a length of 7.50 cm and a cross sectional area of 2.70×10^-9 m^2. Find the solenoids inductance and the average emf aroumd the solenoid if the current changes from +2.50 A to -2.50 A in 5.33×10^-3 s.
I would like this done as fast as possible before 10:50 please
An inductor has an inductance of 0.120 mH. Calculate the number of turns per unit length (meter) of this inductor if it has a total of 719 turns in it. The cross-sectional area of the solenoid is 2.83 cm². Take Ho = 4TT x 10-7 T.m/A. X Submit your answer after rounding off to zero decimal place. You are required to show your work in the file you submit.
Your RL circuit has a characteristic time constant of 21.5 ns, and a resistance of 5.40 MΩ. A. What is the inductance (in H) of the circuit? B. What resistance (in MΩ) should you use (instead of the 5.40 MΩ resistor) to obtain a 1.00 ns time constant, perhaps needed for quick response in an oscilloscope?