In the circuit of the figure below, the battery emf & is 75 V, the resistance R is 150 , and the capacitance C is 0.500 pF. The switch S is closed for a long time interval, and zero potential difference is measured across the capacitor. After the switch is opened, the potential difference across the capacitor reaches a maximum value of 150 V. What is the value of the inductance? H ε R L =C Ⓡ

In the circuit of the figure below, the battery emf & is 75 V, the resistance R is 150 , and the capacitance C is 0.500 pF. The switch S is closed for a long time interval, and zero potential difference is measured across the capacitor. After the switch is opened, the potential difference across the capacitor reaches a maximum value of 150 V. What is the value of the inductance? H ε R L =C Ⓡ

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Related questions

Q: 6. In the pictured LRC circuit, the capacitor was charged by the 25.0 V battery for a long time. The…

A: Given:-

Q: 2100 turns of wire are wrapped in a solenoid that is 5.0 cm long, with a cross sectional area of 2.2…

Q: A circuit is constructed with four resistors, one inductor, one battery and a switch as shown. The…

Q: In a series RLC circuit, the amplitude of the voltage source must be greater than the amplitude of…

A: The amplitude of the inductor's voltage is VL = IXL = IωL where I is current ω is angular frequency…

Q: Two resistors, R₁1 = 125 2 and R₂ = 325 £2, an inductor L = 3.7 mH, a 16 V battery, and a switch are…

Q: E R M switch In the circuit shown in the figure above a generator supplies a voltage of E(t) = 60…

A: Voltage Inductance Resistance At , current Current after seconds

Q: A AV 41.0 V power supply fully charges a capacitor with capacitance C= 1.35 µF. The capacitor is…

Q: E R switch In the circuit shown in the figure above a generator supplies a voltage of E(t) = 60…

Q: A coiled telephone cord forms a spiral with 90.0 turns, a diameter of 1.30 cm, and an unstretched…

A: Given that,Nymber of turns (N) = 90Diameter of coiled telephone (D) = 1.30 cmRadius of of coiled…

Q: In an oscillating LC circuit, L = 4.19 mH and C = 3.65 pF. At t = 0 the charge on the capacitor is…

Q: e. The peak current for this circuit at any frequency w is given by: Eo I R² + (X, – X )² - Explain…

Q: A charged capacitor (C=1μF) is connected in a single loop circuit with an inductor (L = 3mH). Part A…

Q: In an RC circuit supplied with AC power, a 500 ohm resistor is used to create a system with a…

A: Disclaimer: “Since you have asked posted a question with multiple sub-parts, we will solve the first…

Q: The current in an RL circuit increases to 98 % of its final value 2.29 s after the switch is closed.…

Q: In the circuit, the capacitor is fully charged when switch S is closed. Calculate the time nee the…

A: GivenC=20 mFL=55 H

Q: The figure(Figure 1) shows voltage and current graphs for an inductor. Figure VL IV- 0 0.00 s -IV-…

Q: The current I flowing rightward through inductor L is at a steady rate of 0.1280 A/s. The magnitude…

A: GivenThe steady rate of flow of current ,dIdt=0.1280 A/sεL=0.0160 V

Q: The values for the components of the circuit shown in the figure are V = 15 V, C = 3.5 μF, and L =…

Q: The circuit shown in the diagram has a switch which is turned on at time t = 0, and it is known that…

A: Given, Q0=2.0 μCC=1.0 nFL=10.0 μH

Q: An oscillating LC circuit, with L = 1.5 mH and C = 0.01 µF, stores a maximum energy of 10 uJ. al…

Q: After you disconnect the DC power supply from an LC circuit, it oscillates at a frequency of f. Now…

A: The LC oscillation frequency is given by : f=12πLC When the circuit is cooled, L and C are kept…

Q: The current in a coil drops from 4.2 A to 2.8 A in 0.51 s. If the average emf induced in the coil is…

A: Given: The initial current in the coil is 4.2 A. The final current in the coil is 2.8 A. The time…

Q: The figure below shows a conducting sheet bent into a tube of width W = 0.586 m and radius R =…

A: Let's assume the tube as solenoid.Now we imagine dividing the tube (or solenoid) into 𝑁 small…

Q: The figure shows an R-L circuit with a switch, a 166.7- resistor, an inductor and a 13.1-V battery.…

Q: In the circuit, the capacitor is fully charged when switch ?S is closed. Calculate the time needed…

A: Energy stored in the inductor UL = 12Li2 Energy stored in the…

Q: In the figure you have a RL circuit with direct current. All resistors have resistance 40.0 £2, the…

A: Calculate the current in the resistor R2At t = 0, L and R3 does not allow current,current through R2…

Concept explainers

Voltage Across Inductor

An actor is a passive electrical component that consists of a coil bent in the form of wire which uses electromagnetism to produce electric current through the coil. When the electric current flows through a conductor that is the coil, a magnetic flux is developed around the conductor. This flow of current through the coil creates a magnetic field based on Fleming's Right-hand thumb rule. If there is any decrease in the current passing through the inductor, then the magnetic field will also decrease and energy is released through the generation of electric current. There is also a secondary voltage inducing in the same coil due to the magnetic flux, since it opposes any changes in the electric current flowing through the circuit. An inductor is also called choke, coil, or solenoid. A choke is designed to block certain frequencies when the DC current passes. A winding coil is coated with insulation to give extra insulation and protect the circuit. They are usually tightly wrapped around a central core which is cylindrical in nature so that the magnetic flux can be induced. The solenoid is a three-dimension coil that is used to exhibit electromagnetism when the magnetic field is developed due to the current flowing through the coil. The sign convention of the inductor is the same as the power dissipating device. When the current flows into the positive side of the voltage across the inductor, the value is positive and the inductor dissipates power whereas when the inductor releases the power back to the circuit, the current has a negative sign convention. 

Question

100%

In the circuit of the figure below, the battery emf & is 75 V, the resistance R is 150 02, and the capacitance C is 0.500 pF. The switch S is closed for a long time interval, and zero potential difference is measured across the capacitor. After the switch is opened, the
potential difference across the capacitor reaches a maximum value of 150 V. What is the value of the inductance?
H
R
ww
S

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1: Determine the given data in the step :

VIEW

Step 2: Determine the current in the step :

VIEW

Step 3: Determine the formulation for inductance in the step :

VIEW

Step 4: Determine the inductance through calculations in the step :

VIEW

Solution

VIEW

Step by step

Solved in 5 steps with 5 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

The figure below shows a circuit with a battery of & = 3.78 V, a resistor with R = 2.97 2, and an inductor with L = 2.09 H. If the battery is connected at t = 0, at what time will the rate of energy stored in the inductor be equal to the power dissipated in the resistor? i S R 0000 EL
A resistor and inductor are connected to a 9.0 V battery by a switch as shown. The moment the switch is closed, current flows through the circuit. The resistor has a resistance of R = 440 Ω and the inductor has an inductance of L = 150 mH. a) write an equation that relates the current as a function of time i(t) to the maximum current, imax. Express the equation in terms of imax and α, where α = -t/T (time constant). b) determine the time, in seconds, at which the current has a value of i(t50) = 50% of imax. c) determine the time, in seconds, at which the current has a value of i(t99) = 99% of imax.
Please asap
#j03
An inductor of L = 7.75 H with negligible resistance is placed in series with a 8 = 12.1 V battery, a R= 3.00 2 resistor, and a switch. The switch is closed at time t = 0 seconds. Calculate the initial current at i = 0 seconds. I(t = 0 s) = A R Calculate the current as time approaches infinity. Imax A Calculate the current at a time of 2.07 s. I(t = 2.07 s) = A Determine how long it takes for the current to reach half of its maximum.
A 1µf capacitor is charged by a 30.0-V power supply. The fully charged capacitor is then discharged through a 10mH inductor. Find the maximum current in the resulting ocillations. Select one: A. 0.50 A B. 0.45 A O C. 0.30 A O D. 0.35 A O E. 0.40 A
Tarik winds a small paper tube uniformly with 191 turns of thin wire to form a solenoid. The tube's diameter is 5.59 mm and its length is 2.47 cm. What is the inductance, in microhenrys, of Tarik's solenoid? inductance: µH
The current in a coil drops from 3.4 A to 2.1 A in 0.48 s. If the average emf induced in the coil is 12 mV, what is the self-inductance of the coil? mH
In the L-C circuit in the figure, the ammeter reads a maximum current of I = 5.19 mA. The capacitance is 1x10-12 F, and the inductance is 0.57x10-3 H. a) What is the maximum energy stored in the magnetic field of the inductor? b) What is the maximum charge, Q, on the capacitor? c) If the capacitor has this charge at a time t=0, at what time will the charge first fall to the value q=0.3Q?
The current in a coil drops from 3.4 A to 2.4 A in 0.49 s. If the average emf induced in the coil is 12 mV, what is the self-inductance of the coil? mH
An inductor and a capacitor are connected in series. It is found that it takes takes 2 microsecond for the total energy to be converted from electric energy in the capacito to magnectic energy in the indutor. If at t = 0 the capacitor is fully charged. What is the earliest time at at which the current in the circuit is maximum?
An emf of 121.5 mV is induced in the windings of a coil when the current in a nearby coil is increasing at the rate of 1.04 A/s. What is the mutual inductance of the two coils in mH?