A 220 2 resistor, a 0.925 H inductor, and a 5.00 μF capacitor are connected in series across a voltage source that has voltage amplitude 32.0 V and an angular frequency of 250 rad/s.

Q: A low-PRF radar has a PRF of 350 pps and an illumination pulse width of 5.0 us. The range bins are…

A: Option b

Q: Two coherent waves have intensities I1=25.0 mW/m^2 and I2= 15.0mW/m^2 at a certain location in…

A:

Q: My answer I am getting is 1.58. please help me Water waves with parallel crests 4.3 cm apart pass…

A: So the relative angle is 1.38.Explanation:Step 1: Step 2: Step 3: Step 4:

Q: A 1.06 kg metallic mass increases 4°C for every 1000 J of heat applied to it. The sample shows some…

A: Given data: The mass of metal is m=1.06 kg. Heat transfer is Q=1000 J. Change in temperature is…

Q: What is the fundamental wavelength of an air column 80 cm long open at both ends? 40 cmO80 cmO20 cmO…

A: It is the case of column open at both ends. The formula for fundamental wavelength is given as…

Q: SWI-1 Two speakers are in phase and are both playing a tone with a frequency of 250.0 Hz. A listener…

A: Given:  Frequency of the sound = 250 Hz Speed of the sound = 343 m/s We have to find at what three…

Q: Given the following information about the Diamond; lattice constant 3.56 A. the speed of sound in…

A:

Q: wo speakers, speakers 1 and 2, located 0.750 m apart from each other, are creating sound waves with…

A: d = 0.75 m f = 686 Hz v = 343 m/s To find = a) Sound intensity                 b) Sound intensity…

Q: The analysis of any two-point source interference pattern and a successful determination of…

A: The Young’s equation can be expressed as

Q: Suppose that the two waves in the figure have wavelength 454 nm in air. What multiple of A gives…

A:

Q: Part 1. The metal Na has a threshold frequency which corresponds to green light. What will happen…

A: The threshold frequency of the metal correspond to the minimum energy required to emit an electron…

Q: The figure shows a loud speaker A and point C where a listener is. AC= 1m and the angle is 40…

A: Given data *The given distance is AC = 1 m *The given frequency is f = 65 Hz *The given angle is…

Q: (a) What voltage should be applied to an electrode to accelerate an electron from zero velocity such…

A: Given  Wavelength of  a photon=0.87μm

Q: QUESTION 47 A one-dimensional linear atomic chain contains two types of masses m1 and m2 (where m2 >…

A: Given Data: At the first Brillouin zone boundary, which statement is correct?

Q: Q2/ Consider a confocal resonator of length L=1m used for Ar+ laser at wavelength 514.5 nm.…

A:

Q: Q. 5: A wave coming out of page, consists of two linearly polarized components E, = m cos wt Ey =n…

A:

Q: Q2: A: a laser resonator contains a convex mirror with radius 120 cm and another one is concave with…

A:

Q: The values of a, b So that the the transformation is canonical Q:9°Cosbp Sin bp are %3D I. = 2 b:/2…

A:

Q: 3. A radar is attempting to detect a point target in the presence of ground clutter. The parameters…

A:

Q: n your summer internship at an optical products company, you need to measure the wavelength λ of the…

A: Since the relationship is given by, △y=xλd Where, d= distance between slits x= distance from slit to…

Q: 6. Two speakers, emitting identical sound waves of wavelength 4.0 m in phase with each other, are…

A:

Q: IL-2 101 speakers with a spacing of one meter between adjacent speakers form a line 100m long on the…

A: Given :                                  β=120dBl=OX+OY=100m     Using :…

Q: w.9-20 The radius of the Moon is 1.737 Mm and the distance between Earth and the Moon is 384.5 Mm.…

A: The radius of the Moon is The distance between the Earth and the Moon is The intensity of the…

Q: encoder

A: A) The MPEG-2 Encoder with SNR :

Q: Solve the following Weber fraction problems. a.lf Joshua Oswald is jamming to Blank Space at 62 dB,…

A:

Q: 15-MCQS Two interfering waves y1 (x,t) = 0.05 sin(kx - wt) and y2 (x,t) = 0.05 sin(kx - wt + p)…

A: If two waves of equal wavelengths are in phase, they form either a new wave with an increased…

Q: Problem 4. Use the method of phasors to find the resultant wave E(t) of the following waves: E, sin…

A: Given: E1=EosinωtE2=Eosin(ωt+60o)E3=Eosin(ωt-30o)

Q: 3. A lossy medium is with a refractive index n=1.5+0.0015*i. If the initial power intensity of a…

A: The intensity of radiant energy is the ability to transfer the power in a unit area. In this radiant…

Q: A thin film of oil (n = 1.25) is located on a smooth, wet pavement. When viewed perpendicular to the…

A:

Q: A solid sphere of radius 'a' contains a total charge 'q' uniformly distributed within its volume.…

A: The radius of sphere is R and uniform charge q is distributed within it's volume.Find the electric…

Q: Sketch appropriate wave patterns for  I.  y1 (X, t)  = Asin(3x-6t) 2. y2 (X, t)  = Asin(4x - 8t)…

A: The given waves are both functions of x and t. So we will try to sketch the x dependence at…

Q: Two loudspeakers, A and B, are to be set-up at a distance, x, apart from each on opposite ends of a…

A:

Q: Using the complex notation for waves can be a handy tool. Let E₁ = A₁ exp[i(k₁ r-w₁t+₁)]+c.c. and E2…

A: Disclaimer: Since you have posted a question with multiple sub-parts, we will solve first three sub…

Q: A Moving to another question will save this response. Question 6 What is the Brewester's angle for…

A: The refractive index for glass is μ=1.5

Q: The index of refraction of a certain type of glass is expressed by the relation: 4825 nm? n(1) =…

A: Given: The wavelength (λ) of the pulse is 400 nm. The index of refraction (n) for the glass is…

Q: A film material with n = coating is 380nm thick. White light is incident perpendicularly to the…

A: Given data: Refractive index of flat glass = 1.55 Refractive index of a film material = 1.25 Film…

Q: fog deep watey Ten Vy - de - %3D Vp = W = %3D Up = 2 TT %3D Vg + Up dispersime wove, deep watey…

A: Phase Velocity(VP It's the rate at which a wave of particular frequency i.e monochromatic wave…

Q: Question 49 At the headend, the transmit DFB LASER reads 4.4 mW, what is 4.4 mW in dBm? 05.44 O 6.43…

A: Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: 6. We have a signal x(n) = xa(t)]t=nTi where T1 7 msec, and we wish to convert x(n) to y(m) such…

A: In this question answer is given below. It is helpful for you ?

Q: Two point sources are 9. 00 cm apart and operating in phase with a common frequency of 9. 50 Hz. The…

A:

Q: Two separate coherent sources produce waves with wavelengths of 3.20 m. One of the sources Si is…

A: When light or sound waves pass through each other they will experience interference. The waves will…

Voltage Across Inductor

An actor is a passive electrical component that consists of a coil bent in the form of wire which uses electromagnetism to produce electric current through the coil. When the electric current flows through a conductor that is the coil, a magnetic flux is developed around the conductor. This flow of current through the coil creates a magnetic field based on Fleming's Right-hand thumb rule. If there is any decrease in the current passing through the inductor, then the magnetic field will also decrease and energy is released through the generation of electric current. There is also a secondary voltage inducing in the same coil due to the magnetic flux, since it opposes any changes in the electric current flowing through the circuit. An inductor is also called choke, coil, or solenoid. A choke is designed to block certain frequencies when the DC current passes. A winding coil is coated with insulation to give extra insulation and protect the circuit. They are usually tightly wrapped around a central core which is cylindrical in nature so that the magnetic flux can be induced. The solenoid is a three-dimension coil that is used to exhibit electromagnetism when the magnetic field is developed due to the current flowing through the coil. The sign convention of the inductor is the same as the power dissipating device. When the current flows into the positive side of the voltage across the inductor, the value is positive and the inductor dissipates power whereas when the inductor releases the power back to the circuit, the current has a negative sign convention.