sub-transient reactance of 8% and G3: 110 MVA, 30 KV, sub transient reactance of 12%. reactance of G3 in per unit on a base of 100 MVA, 35 KV is Your answer reactance of G1 in per unit on a base of 200 MVA, 35 KV is Your answer reactance of G2 in per unit on a base of 50 MVA, 35 KV is Your answer

sub-transient reactance of 8% and G3: 110 MVA, 30 KV, sub transient reactance of 12%. reactance of G3 in per unit on a base of 100 MVA, 35 KV is Your answer reactance of G1 in per unit on a base of 200 MVA, 35 KV is Your answer reactance of G2 in per unit on a base of 50 MVA, 35 KV is Your answer

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: 10 minute presentation on Tidal renewable energy

A: Tidal Renewable Energy PresentationSlide 1: IntroductionTitle: Harnessing the Power of Tides: An…

Q: Which of the following cannot be said for Channel capacitance? a) All b) it is formed as a result…

Q: Redo it again with full details..

A: Given: 3:8 Decoder To find: we have to form the truth table for 3:8 decoder.

Q: reactance of G3 in per unit on a base of 100 MVA, 35 KV is ооо ΟΟΟΟ Three generators rated as…

Q: Which of the following is not a boundary condition for an SLG fault on phase 'a' of a power system?…

A: Since the single line to ground fault occurs on the phase a of the system the fault current of phase…

Q: 2 LOAD1 Sy= 75 MVA cosp=0.95 back XH = j 144,4 ohm 125 MVA LOAD2 Sy= 25 MVA cosp=0.9 back 150 MVA…

Q: A split-wye capacitor bank is made up of two 4500-kVAR, 13.8-kV sections, for a total installed…

A: This problem is based on the concept of a balanced 3-phase system and power calculations in AC…

Q: Given a single phase inductance Lm.1) ,1phase = 12 mH, what is the mutual inductance between stator…

A: Given:Single phase inductance Lm,1 phase=12 mH

Q: The below table shows all the combinations considered when solving a unit commitment problem…

A: Given Data: The table of all the possible combinations of three thermal units explains, The cost…

Q: In a 10 km long three phase conductor diameter of 2.5 mm the conductors are arranged symmetrically…

Q: What is the significance of reactive power in electrical grids, and how is it managed?

A: The question is about significance of reactive power.

Q: /hat does it mean when the power factor is leading? rue or false: 1) A load with a leading power…

Q: A 3 phase 200 MVA capacitor bank is to be switched off (disconnected) the grid that operates at…

A: Restriking voltage: It refers to the transient voltage that appears across the contacts of a…

Q: a string of 2 suspension insulators, each unit has a self capacitance X and a pin to earth,…

A: Given a string of 2 suspension insulator has, Self capacitance, Cs=X. Mutual capacitance, Cm=0.1X.…

Q: 64. A 50 Hz, 11 kV, 3-phase alternator with earthed neutral has a reactance of 5 ohms per phase and…

A: Given, A 50 Hz, 11 kV, 3-phase alternator with earthed neutral has Reactance = 5 ohms per phase The…

Q: Three synchronous generator are connected in parallel to a an infinite s. G1 only provides active…

Q: 8 - What is the time it takes to complete a cycle in AA? A) Positive alternans B) Period C)…

A: What is the time it takes to complete a cycle in AA?

Q: need the answer as soon as possible

Q: If the peak to peak voltage is equal to 20 . How much the RMS value of the voltage!?

A: The circuit this is excited the use of alternating supply is referred to as an AC Circuit. The…

Q: A Single Area consists of 3 generating units (G1/G2/G3) with the following characteristics: G1: 200…

A: In this question we need to choose a correct option

Q: Three generators rated as follows: G1: 100 MVA, 33 KV, sub-transient reactance of 10%; G2: 150 MVA,…

Q: A 20 Ohm resistor is in series with a 30 Ohm Inductive reactance. If they are connected to a 40 Volt…

A: In this question, we need to determine the angle between phase voltage and voltage across inductive…

Q: the slip-rings replaced by separated segments In order to generate a bidirectional Voltage true /…

A: This statement is true or false? "the slip-rings replaced by separated segments In order to…

Q: The circuit shows an unbalanced electrical installation powered by a positive sequence symmetrical…

A: Given: Load-1:P1=950Wcosϕ1=0.5 LaggingLoad-2:P2=1.14Wcosϕ2=1Load-3:P3=760Wcosϕ3=0.5 leadingline…

Q: For the first question, is the statement true or false: "The load is not absorbing nor generating…

A: It is given that:unity power factor i.e., .

Q: Q2/ Find Yous for the power system all reactance on a common base. Bus 3 j0.25 j0.10 j0.25 Bus 2…

A: Impedances of the network branches on a common base are given. Z12=j 0.125 puZ13=j 0.125 puZ14=j0.…

Q: A sinusoidal current has a rms value of 3 amperes, its maximum value will be ______.

Q: The sequence components of the fault current are as follows: Ipositive = j 2 p.u., Inegative = -j0.5…

A: Given, The sequence components of the fault current are, Ia1=j2 puIa2=-j0.5 puIa0=-j1.5 pu

Q: A 13.2 kV, 60 Hz, 3-phase synchronous generator is connected in star and its neutral point is…

A: Given, The supply voltage (E)= 13.2 kV(rms) Frequency (f)= 50 Hz Per phase inductance (L)= 0.02 H…

Q: A star connected Alternator excitation voltage and terminal voltages per phase respectively are 180V…

A: Alternator: It is used to convert the mechanical energy to electrical power in the form of…

Q: please include the request below with the phasor diagram C ii) Construct the new phasor for E’…

Q: Crosstalk Glitch Example and Analysis Aggressor Victim Victim Net, V OM Aggressor Net, A Coupling…

Q: Three generators rated as follows: G1: 100 MVA, 33 KV, sub-transient reactance of 10%; G2: 150 MVA,…

Q: Choose [T]rue or [F]alse for the following statements. a) F b) T c) T d) F e) T

A: (a) False. The peak-to-peak value represents the difference between the highest positive peak and…

Concept explainers

Three-Phase Transformers

Three-segment transformers are a type of transformer used to transform voltages of electrical systems into three ranges. Two type transformers are shell-type transformer and core type transformer. In brief, it could be described because of the exquisite kinds of configurations.

Transformer

Ever since electricity has been created, people have started using it in its entirety. We see many types of Transformers in the neighborhoods. Some are smaller in size and some are very large. They are used according to their requirements. Many of us have seen the electrical transformer but they do not know what work they are engaged in.

Question

Three generators rated as follows: G1:
100 MVA, 33 KV, sub-transient
reactance of 10%; G2: 150 MVA, 32 KV,
sub-transient reactance of 8% and G3:
110 MVA, 30 KV, sub transient reactance
of 12%.
reactance of G3 in per unit on
a base of 100 MVA, 35 KV is
Your answer
reactance of G1 in per unit on a
base of 200 MVA, 35 KV is
Your answer
reactance of G2 in per unit on
a base of 50 MVA, 35 KV is
Your answer

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

what will be the total and unit for impedance if the given is 8mA and 9mV?
Please solve Q7
The ACSR conductor Falcon is used in a 3-phase equidistant configuration with D = 42 feet. The per kilo feet inductive reactance will be: O A. 0.1537 B. 0.8117 O C. 0.1475 O D. 0.1148 O E. None of choices are correct
powe system Q8
A Single Area consists of 3 generating units (G1/G2/G3) with the following characteristics: G1: 425 MVA rating, R1 = 0.015 pu (on the 425 MVA base), initial output P1 = 300 MW. G2: 300 MVA rating, R2 = 0.02 pu (on the 300 MVA base), initial output P2 = 200 MW. G3: 300 MVA rating, R3 = 0.03 pu (on the 300 MVA base), initial output P3 = 200 MW. The frequency of the system is 60 Hz. Assuming D = 0 pu and using a common base of 1000 MVA, what is the new steady-state frequency for a load increase of 100 MW? Select one: O a. None of these O b. 59.96 Hz O c. 58.75 Hz O d. 59.88 Hz
Problem 4
5
A Single Area consists of 3 generating units (G1/G2/G3) with the following characteristics: G1: 200 MVA rating, R1 = 0.025 pu (on the 200 MVA base), initial output P1 = 150 MW. G2: 300 MVA rating, R2 = 0.01 pu (on the 300 MVA base), initial output P2 = 200 MW. G3: 400 MVA rating, R3 = 0.02 pu (on the 400 MVA base), initial output P3 = 300 MW. The frequency of the system is 60 Hz. Assuming D = 0.75 pu on a common base of 1000 MVA, what is the new generation output for G1 for a load increase of 150 MW? Select one: O a. None of these O b. 252.12 MW O c. 155.45 MW O d. 170.42 MW
Electronic ballasts and PCs are the most significant sources of triplen harmonics True False
The circuit shows an unbalanced electrical installation powered by a positive sequence symmetrical three- phase network of 380 V compound voltage. The loads are single phase. Load 1 absorbs an active power of 950 W with f.d.p. 0.5 inductive. Load 2 absorbs an active power of 1,140 W with f.d.p. Unit. Load 3 absorbs from the network an active power of 760 W with f.d.p. 0.5 capacitive. Taking the network voltage URN as the phase reference, calculate: a) complex expressions of the line currents IR. Is. and IT RO- SO- To- : IR Is IT UL-380 V CARGA 1 P₁ = 950 W cos p1=0,5 ind. CARGA 2 P₂=1.140 W cos p₂=1 CARGA 3 P3=760 W cos p3=0,5 cap.
Could you solve this with clear steps ?!
A Single Area consists of 3 generating units (G1/G2/G3) with the following characteristics: G1: 250 MVA rating, R1 = 0.02 pu (on the 250 MVA base), initial output P1 = 200 MW. G2: 350 MVA rating, R2 = 0.015 pu (on the 350 MVA base), initial output P2 = 300 MW. 0.03 pu (on the 300 MVA base), initial output P3 = 150 MW. G3: 300 MVA rating, R3 = The frequency of the system is 60 Hz. Assuming D = 1 pu on a common base of 1000 MVA, what is the new generation output for G3 for a load increase of 75 MW? Select one: O a. 190.55 MW O b. None of these O c. 203.38 MW d. 166.01 MW