Solve for the branch currents and show actual current directions. |. a loe loov oVse gov 32 P.

Q: A coil that con sists of 450 windings is wound around a bakelite rin g. The mean diameter of the…

A: We are authorized to answer only 1 question at a time since you have not mentioned which question…

Q: Hiw.si-A-skeel.Fod.im. Long. and. lomm* 20-mm.incross Section.is..subjecked..to atensile…

A: According to the question we have to find the value of elongation of the rod.

Q: he resistance of the copper field winding of a dc machine at 40 degree Celsius is 0.40 ohms. After…

A: GIVEN, R1=0.40ohm                                    t1=40∘C               α=0.00393 ( for cu field…

Q: -A series generator dellvers a current of 90 A at 240 V. Its armature and series fleld resistances…

A:

Q: 11. The eddy current loss of a given solid core is 80 W at 50 Hz. What would be the loss of 60 Hz if…

A:

Q: The flux linking to 200 turns coil changes from 2 mWb to 5 mWb in 1ms to 3 ms. Determine the induced…

A:

Q: A current Ip5A flows through an infinitely long regular wire in emty space. A Second square side…

A: Given data,

Q: Two coils wound on a common core have L1=0.2 H, L2=0.5 H, and M=0.1 H. The currents are…

A: Given data, The value of inductor L1 = 0.2 H. The value of inductor L2 = 0.5 H. The value for…

Q: A E₂ R2 R₁ F E E D₁ S с R3 E3 Equating E3 C Ec HH R₂

A: Anderson's bridge:- It is a type of AC bridge which is used to determine self inductance of…

Q: 1-Choose the correct statement for pure resistor connected across single phase AC supply. a.…

A: Resistance  Voltage and current are in same phase I=V/R So both are in same phase.

Q: A DC current I flows in a long solenoid with n coil-turns per unit length. The core is made of iron…

A: The solution can be achieved as follows.

Q: was established or he ban, Dam based on the below in Formati. Height of dam)=2 lom Flow rate)= 80…

A: It is given that: Height of dam=h=210 mFlow rate=Q=80 m3/sg=9.81 m/s21 m3 of water=1000…

Q: In the system shown in the below figure, the switch is closed at t = 0. a Determine voltage…

A: “Since you have posted a question with multiple sub-parts, we will solve the first three subparts…

Q: Write down the differential equations describing the loop currents of the given circuit. Assume…

A:

Q: Asquaro magnotic cora has e moan peth length 55:m and x-soctional eres of 150zm A 200 turns coil of…

A:

Q: Body) A A B I U D Av A m<而 三| &| 回 ... 5. A coll consists of 750 turns. A current of 10A In the coll…

A:

Q: UIN: 14V = 6A in the direction shown. choice of node or loop I = 6A R=20 R= 1O 1ER, = 10 R- 10 R- 20…

A:

Q: + + ww R₁ I IO

A: In this question we need to draw a waveform of the current flowing through the load resistor and…

Q: 0. 10. Two coupled colls of self-inductances 0.6 H and 0.16 H have a coefficient of coupling 0.8.…

A:

Q: A two-legged core is shown in figure below. The winding on the left leg of the core (N) has 800…

A: We have given the following problem A two legged core is shown below the winding on the left leg of…

Q: Choose the supply voltage for a step down chopper circuit which drives the resistive load 4.80 with…

A:

Q: W Discuss B-H curve of a ferro-magnetic material..

A: In this question we discuss B-H curve of ferromagnetic material.

Q: HW.sA long solenoid that has loo0 turns distributed overalenyth of a-4 m producesanaguetic field of…

A:

Q: نقطة واحدة A shunt generator can be self- excited only if the resistance of the field circuit is…

A: In this question, we have to tell about when shunt generator can be self excited ..

Q: A long shunt compound generator supplies 29 A at 420 V. If the field resistance is 246 Q, the series…

A:

Q: A load is operating in a chopper circuit as shown in the figure. It has a duty cycle of 0.4…

A: Given: Duty cycleD=0.4Chopping frequency=150 HzE=?

Q: A two-legged core is shown in figure below. The winding on the left leg of the core (N,) has 600…

A: Given that, N1=600 N2=200 i1=0.5 A i2=1 A μ=1000 We have to find total flux

Q: The actual impedance of a load is 30 OHM. The per-unit impedance of the load is 0.5 pu when Base…

A:

Q: The sinewave has a peak voltage of 7 A and a Half cycle value of 9.3333 ms. What is the frequency?

A: Given Sine wave , peak value A peak =7 A Half cycle time = 9.3333 ms  f= frequency

Q: An AC circuit is shown in the diagram. The source of emf has a peak voltage of 9.00 V and a…

A:

Q: a) A sinewave is having a frequency of 50 Hz and instantaneous value of 150 Volts at 1.2 milli…

A:

Q: Amagnetic field is being generated by a current of 2.0A flowing through 180 turns of wire on a core…

A: flux = MMFreluctance MMF = No. of turns * current in the coil .  Given current in the coil = 2 amps…

Q: Design a Bridge FWR to supply a load of (1002) with the waveform shown in figure from the main power…

A: Full Wave rectifier Given Vm=Vout=12VVm=12 V(1) Turns ratio V1 rmsV2 rms=N1N2V1 rms=220 VV2…

Q: 8. At what velocity must a conductor 75 mm long cut a magnetic field of flux density 0.6 TIf an…

A:

Q: If E = 1.05 p.u. leading by 25 degrees, feeding infinite bus bar through a reactance of 0.35. Find…

A: Simple problem on powrt system stability. Look below for solution:-

Q: 1-Explain the principle of commutator in d.c generator.

A:

Q: A flux of 0.0016 Wb flows in a silicon sheet steel coil/core. The arrangement appears as shown below…

A:

Q: A 500 MVA synchronous machine has H, = 5.6 MJ/MVA and a 1200 MVA machine has H₂ = 2.0 MJ/MVA. The…

A:

Q: a) A sinewave is having a frequency of 100 Hz and instantaneous value of 150 Volts at 1.4 milli…

A: Sine wave given