Small packages traveling on the conveyor belt fall off into a 1-m-long loading car. If the conveyor is running at a constant speed of vc = 3 m/s, REQUIRED: Determine the smallest and largest distance R at which the end of A of the car may be placed from the conveyor so that the packages enter the car.

Q: A 10 b weight is held abducted at the shoulder horizontal to the floo. The total length of the arm…

A: To determine the force that the deltoid is required to exert to hold the given weight.     Given,…

Q: Sandbags are place on a beam. Each bag is 1 ft wide and weight of 70 N. What is the simplest…

A: A resultant force is a single force obtained by combining a system of forces. The resultant force…

Q: The A-36 steel W 6 x 20 column 6 m in height is pin connected at its ends and is subjected to the…

A:

Q: Determine the moment ereated by the weight of the traffic light about point O The dimensions of the…

A:

Q: Determine the value of work done if force applied on crate is 12.5 N and displacement of crate is 2…

A: Introduction : The given question is related with mechanics . In this question we are provided with…

Q: To calculate the components, magnitude, and direction of the resultant force of three coplanar…

A: Answer let us first resolve the forces into their components as shown in figure below Calculation…

Q: points A 5.0 kg object is to be given an upward acceleration of 0.30 m/s2 by a rope pulling straight…

A: We need to consider acceleration due to gravity effect in addition to the upward acceleration.

Q: Project 3: Part (1): Crankshaft mechanism is one of the most important mechanical system used to…

A: Solution

Q: There are 6 boys who enter a boat with 8 seats, 4 on each side. In how many ways can a) they sit…

A:

Q: The frame structure is constructed with structural steel I-beams of given cross-section dimensions…

A: A beam or frame is subjected to transverse loadings, The three possible internal forces that are…

Q: ++ 0.3 m S2 3.15 m ++ 0.3 m B. 7.0 m ++ 0.3 m 1.2 m 0.3 m 4.2 m 0.3 m 1.4 m 300 mm #+ +1 140 mn 360…

A: Hi! Thank you for the question As per the honor code, We’ll answer the first question since the…

Q: 904-1 1. The wheel loads on a jeep are given in the figure shown. Determine distance x so that the…

A: Given data  Find x value so that reaction at support A is twice as greater as reaction at B.

Q: A beam is loaded as shown in the figure. What is the equivalent concentrated load on the beam? ...…

A:

Q: The length of the cable segment AB is 10 ft (Eigure 1) The angle a = 30° Figure 57°F 10 ft 1 of 1 >…

A: Determine the value of T required to support the 650 lb crate.

Q: 3 4 10 9

A:

Q: In (Figure 1), the tension developed in cables AB and AC cannot exceed 330 lb. Figure 5.5 ft J11 2…

A: Tension developed in AB and AC cant exceed 330 lb .

Q: For the load diagram shown below, identify the corresponding shear and bending moment diagrams.

A:

Q: A crate of weight 100 N is pushed along a floor with a force of 40 N for a distance of 350 cm.…

A: The work done is given by the product of force applied and displacement.

Q: which bar is stronger A or B? assume that the given load are the maximum load each can carry.

A:

Q: For :4 100 lb! Given the space force below, What is its y-component? 8. O A. 9.16 upward O B. 43.7…

A:

Q: nat are Calculate blocking dimensions for outriggers of a crane based on the following given data.…

A: Crane weight - 50,000 lbs load weight -40,000 lbs weight of accessories- 900 lbs rigging weight -…

Q: The crate shown has a mass of 50 kg and the coefficient of static friction between the crate and the…

A: m=50kg u=0.25

Q: 12. Situation 4 - A block of wood 0.6 m x 0.6 m x “h” meters in dimension was thrown into the water,…

A:

Q: A steel rod, 2 m in length, 40 mm in diameter, is subjected to a pull of 70 kN as shown in the…

A:

Q: Lloukle Integr ation Meth od Lletermine the :). LDeyle etion at e). Mope at C

A:

Q: T = 370 N-m and T = 560 N-m. (Figure 1) Part A Determine the magnitude of the torque at section AB…

A:

Q: cantiliver shown in the diagram has a length L1=9 m and subjected to a uniformly distributed load q2…

A:

Q: What is the reaction force at the fixed support at O? (Figure 1) Enter the x, y, and z components of…

A: Given : F = 260 i - 130 j   N Reaction forces at fixed support O

Q: Your direct manager has called you for a meeting and provided you with the below schematic design…

A: Note:- As per our company guidelines we are supposed to answer only first 3 sub-parts. Kindly repost…

Q: A crate is given an initial speed of 2.5m/s up the 20.0° plane. If the plane has a kinetic friction…

A:

Q: 10. Which among the following is a formula for force when it acts perpendicular to the direction of…

A: Which among the following is a formula for force when it acts perpendicular to the direction of…

Q: P 150⁰ B O 1m A 2m O

A: Now we have to find the ratio of extension of rod A to that of rod B

Q: A 100 m tape is suspended between two ends under a pull of 165 N. The weight of the tape is 25 N.…

A: Given data : Applied pull (P)=165 N Weight of Tape (W)=25 N Length of tape supported between support…

Q: DESIGN DESCRIPTION To construct a warehouse, the frame system shown in Figure 1 has been adopted. As…

A: the warehouse frame system, here's how to calculate the maximum bending moment in the middle frame…

Q: Problem 5.48 If rope BC will fail when the tension becomes 75 kN. (Figure 1) Figure 1 AT of 1 26 kN…

A: Given : To Find :  Fmax , FA ?

Q: In (Figure 1), k = 180 N/m. Figure Tc- 2 m- -3 m- wwwww 1 of 1 > Part A Determine the unstretched…

A: Mass of the crate = m= 40kgSpring constant= k = 180N/mFree body diagram:-

Storm Sewers and Detention

The storm drains system transports rainwater or stormwater and other runoff from roads, parking lots, and roof downpipes directly to nearby creeks, rivers, or the sea without any treatment.