Answered: Situation 5. Determine the resultant of… | bartleby

Related questions

Question

Situation 5. Determine the resultant of the three forces acting on the gusset plate of a truss.
6200 N
3800 N
4000 N
45°
50°

Expert Solution

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Blurred answer

Similar questions

A 1140-N uniform beam is attached to a vertical wall at one end and is supported by a cable at the other end. A 1960-N crate hangs from the far end of the beam. Using the data shown in the figure, find (a) the magnitude of the tension in the wire and the magnitudes of the (b) horizontal and (c) vertical components of the force that the wall exerts on the left end of the beam. 50.0° 30.0% Beam 1960 N
A horizontal plank 4.00 m long and having mass 20.0 kg rests on two pivots, one at the left end and a second 1.00 m from the right end. Find the magnitude of the force exerted on the plank by the second pivot.
Determine the force in member BE of the loaded truss. Enter a positive number if in tension, negative if in compression. 11' B 14' 15° 15° F E 11' 15° 1.0 L 1.7L 15° 45° A Answer: BE = i !L 45° D
A 25-ft crane supported at its lower end by a pin is elevated by a horizontal cable. A 250-lb load is suspended through the cable. The center of gravity of the crane is 10 ft from the pin, and the crane weighs 200 lb. Hint: You don't have to convert the unit since they cancel out on both sides. 25. Find the tension in the cable. T $25016 26. Find the total force acting on the pin. y 27. Find the direction of the force acting on the pin, o = ? 60⁰° W(2001b)
Two builders carry a sheet of drywall up a ramp. Assume that W = 2.10 m, L = 3.20 m, 0 = 25.0°, and that the lead builder carries a (vertical) weight of 187.0 N (42.0 lb). What is the (vertical) weight carried by the builder at the rear? The builder at the rear gets tired and suggest that the drywall should be held by its narrow side. What is the weight (in N) he must now carry?
To get up on the roof, a person with a mass m = 71 kg leans an aluminum ladder (mass 10.5 kg and length 6.0 m) against the house on a concrete pad with the base of the ladder 2.00 m from the house. The ladder just overhangs a plastic rain gutter, which we can assume to be frictionless, so the force from the gutter on the ladder acts perpendicularly to the ladder. As a result, the top of the ladder experiences a normal force at an angle, while the bottom of the ladder experiences both a vertical normal force and a horizontal friction force. The center of mass of the ladder is 2 m from the bottom. The person is standing 3 m from the bottom. a.) What is the magnitude of the net force on the ladder at the top? Give your answer in newtons b.) What is the magnitude of the net force on the ladder at the bottom? Give your answer in newtons
Structural member AB is to be supported by a strut CD. Determine the smallest length CD may have, and specify where D must be located for a strut of this length to be used. Take x= 120 mm. 60 mm D. y 20 mm E The smallest length CD may have is mm. The coordinates of point Dare ( and Imm.