Situation 2: A four cornered lot has the following azimuth and distances with unknown non-adjacent sides. BOUNDARY AZIMUTH DISTANCE 1-2 12° 300 m 2-3 128° 3-4 192° 150 m 4-1 260° - Compute the missing side 4-1 - Compute the area of the lot in acres

Q: I have been over this problem several times I believe the issue may be in my equilibrium equations.

A: F=590N To find value of F2, F3 ,F1

Q: P (Ib) -A (ft) B (ft) -A+B (ft)

A: structure is said to be externally indeterminate if all the support reaction can not be found using…

Q: The door has a weight of 220 lb and a center of gravity at G. (Figure 1) Figure 3 ft 6 ft- 4. G 6 ft…

A:

Q: For the beam in the figure, there is a distributed load with the following equation f (x) =…

A: Solution Draw the diagram

Q: In the figure below, the weights of the top, middle, and bottom blocks are are follows: • top block…

A:

Q: The shaft shown in the figure below is subjected to axial loads as illustrated. The diameters of…

A:

Q: A dam is subjected to a varying load as shown w1 kN/m w1 w2 w3 X y X (x+3) m 6 15 25 10 12 w2 kN/m y…

A:

Q: The 62-mm-diameter steel shaft is subjected to the torques shown. (Figure 1) Figure 1 of 1 400 mm B…

A: Angle of twist The angular distortion of an item caused by a few twisting torques is known as the…

Q: E A В F 3 in. 2 in. G -2 in.

A: The force G does not cause any torque at D when resolved. It only creates a moment 2G and a direct…

Q: 2000 lb 1000 lb –12 ft - -12 ft – B 8 ft D E –12 ft- 6 ft 6 ft

A:

Q: Figure -2 ft- F₁ -3 ft- F₂ 30 -2 ft- X F3 ▼ Part B Determine. Express y 0= Submit ▼ Part C…

A:

Electric Circuit and Components

An electrical circuit or electrical network is a pre-determined pathway to make the electrons flow in the desired direction. The flow of electrons will set up a current flow in the circuit. Normally, the flow of electrical current is opposite to the flow of electrons. An electron is a fundamental sub-atomic particle of an atom possessing a negative charge. To initiate the flow of current and achieve the desired output, the electrical circuit should necessarily be composed of closed pathways. The pathways are made-up of good conductors of electricity such as aluminium and copper.