DIAMTER IS 50mm IS LOADED BY AN ALUMINUM SHAFT WITH A COSNTANT TORQUES APPLIED TO GEARS ATTACHED TO IT AS SHOWN ING THE FIGURE. USING G = 28 GPa, DETERMINE THE RELATIVE ANGLE OF TWIST OF GEAR D RELATIVE TO GEAR A. 600 N-m 900 Nm 1100 Nm 2m 800 N-m 3 m 2m

Q: It's important to define concepts like "repository" and "modeling tool" as well as "documentation…

A: Repository: It is a storage room or place, where the construction materials are stored. The…

Q: What is the C constant for Cemented Carbide to cut steel? 0.125 0.1 0.6 600-ft/min 2000-ft/min…

A: The C constant is a parameter used in the calculation of cutting speed.

Q: : State the commands used to draw the following GROUND FLOOR PLAN FIRST FLOOR PLAN LEFT ELEVATION…

A: Assuming that drawing has been drawn in AutoCAD, following are the commands would have been used :-…

Q: i need all parts of question on the right hand corner solve I STATED FILL IN THE BLANKS.

A: Only 3 subparts can be answered at a time according to guildlines. Please resubmit the question…

Q: 41 45 us 41 6as 9 Jolnt Foc Joint G Fer EM=0, FAB=-1825 08 (c) Foe sincus)- Ga5 =0 FOE= 883.983 08…

A:

Q: What are the three-dimensional models used by BIM?

A: Three dimensional modelling is a form of BIM. It is the process of gathering graphical and…

Design of structures using FEA

An arrangement, in which various members are interconnected with their constrained relative motion, the whole arrangement is then known as a structure. The degree of freedom of such a structure is zero. In such a structure, the load can act throughout the length of the structure or at the joints.