Shown below in the figure is a link supporting assembly carrying a load P. The assembly consist of horizontal bar namely CBD with a length of 2.2m and a vertical bar link member AB that has a cross-sectional area of 500mm². Find the value of the load P that will result to a normal stress equivalent to 100 MPa for member AB. Note that a hinge pin at point B is connecting the horizontal and vertical bar with a diameter of 15 mm and assume to be subjected to "Double shearing". Also find the shear stress in the hinge pin.

Q: The state of stress at a point is the result of two loadings as shown in figure. When acting alone,…

A: For the two loadings act simultaneouslythen resultant (absolute) shear stress at that point with…

Q: For the stress block shown, what is OP2 if OP1 = 140 MPa (T)? A.60 MPa (T) 40 MPa B.60 MPa (C) C.20…

A: Calculations:σx=+120mpaσy=-40Mpaσ1=140mpagivenσ1=σx+σy2+σx-σy2+ζxy2140=120-402+120+4022+ζxy2140=40+8…

Q: - 150 mm - 3 mm B 200 mm A 3 mm

A: shear strain  is defined as the angular deformation of the object when subjected to  shear force…

Q: For the sets of given stresses on an element given in Table below, draw a complete Mohr's circle,…

A: Hi! Thank you for the question As per the honor code, We’ll answer the first question since the…

Q: A prismatic bar has a cross-section of 25 mm by 50 mm and a length of 2000 mm. Under an axial load…

A: Width B=25 mm Depth D=50 mm Length L=2000 mm Load P=100 kN Elongation ∆L=2 mm Tensile stress & %…

Q: (A) he figure below shows three metal cubes A, B, C of side 100 mm in direct contact, resting on a…

A:

Q: The member is loaded as shown. The diameter of the member is 32 mm. 1) Calculate all internal…

A:

Q: 2.22 Given o xx = 20 MPa, o y = -10 MPa, and oxy =-20 MPa, find the principal stresses and principal…

A:

Q: 1. Establish stress equations for both bars in the two-bar assembly shown below which isloaded with…

A: The objective of the question is to establish stress equations for both bars in a two-bar assembly…

Pressure and Stress