SallySue (BillyBob's long suffering wife) is watering the goats in the back 40 acres, and has to cobble together a couple of old garden hoses to make the distance from her outside water tap. Assume that the ground is perfectly flat and there is no change in elevation. Yes, Billy Bob and SallySue Huckaby live on a flood plain and get flooded out regularly. But I digress. Connected to the tap, there is a 2.00cm-d hose, and that is connected to a 3.00cm-d hose which reaches the water trough for the goats. Assume that the holes in the pipe have been properly mended with duct tape so there are no leaks. If it takes 2.50minutes to fill up the 20.0gallon water trough (old bathtub), determine the difference in pressure between the second hose and the first.

SallySue (BillyBob's long suffering wife) is watering the goats in the back 40 acres, and has to cobble together a couple of old garden hoses to make the distance from her outside water tap. Assume that the ground is perfectly flat and there is no change in elevation. Yes, Billy Bob and SallySue Huckaby live on a flood plain and get flooded out regularly. But I digress. Connected to the tap, there is a 2.00cm-d hose, and that is connected to a 3.00cm-d hose which reaches the water trough for the goats. Assume that the holes in the pipe have been properly mended with duct tape so there are no leaks. If it takes 2.50minutes to fill up the 20.0gallon water trough (old bathtub), determine the difference in pressure between the second hose and the first.

Name: 4. SallySue (BillyBob's long suffering wife) is watering the goats in
Uploaded: 2024-03-20T06:56:55.000Z
Channel: Bartleby
Description: 4. SallySue (BillyBob's long suffering wife) is watering the goats in the back 40 acres, and has tocobble together a couple of old garden hoses to make the distance from her outside water tap.Assume that the ground is perfectly flat and there is no

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

A truck carried an open rectangular tank that is 5-m long, 2-m wide, and 2.5-m high and is filled with water leaving a 0.5-m allowance from the rim. Determine the following: a.) maximum acceleration that the truck can achieve without spilling any water. b.) accelerating force on the water mass. c.) volume of water spilled out if the acceleration is increased to 6 m/.2.
Water flows through a horizontal pipe of cross sectional of 20 cm2. Atone section, the cross sectional area is 4 cm2. the pressure difference is29.4 psi. How many cubic meters of water will flow out of the pipe in 1min? (can you show the diagram or illustration if possible. thank you!) Choices: a. 0.008 b. 1.208 c. 0.493 d. 0.0185
The pump delivers water from the lower to the upper reservoir at the rate of 2.0 ft. The head loss S between the suction pipe inlet and the pump is 6ft and that between the pump outlet and the upper reservoir IS 12ft. Both pipes 6 inches Schedule 40 steel pipe. Calculate a)The pressure at the pump inlet in Psi,b) The pressure at the pump outlet in Psi,c) The total head on the pump in ft, andd) The power delivered by the pump to the water in Hp
Imagine you are sitting in a Canoe with your friend in Lake Conroe north of Houston. There is a piece of rock inside the canoe. Your friend then gently throws the rock inside the lake. After the rock has completely sunk in the water, do you think the water level in the lake Conroe a) stays the same, b) decreases, c) increases (ever so slightly)? back up answer with calculations
Given: A pipe connecting two reservoirs as shown in Fig. 1. Absolute roughness of both pipe sections is 0.5 mm. Calculate: a) Equivalent pipe loss coifficient b) Equivalent pipe length which can replace the secondary losses c) Discharge in the two pipes (ignore secondary losses) d) Equivalent pipe diameter required to replace the two pipes in series (Leq = 2500m) e) Sketch EGL ( solid line) and HGL (dash line) H= 50 m L = 1000 m 2000 m- %3D Water 20°C 70 m-t D= 200 mm Valve D =300 mm Figure 1 (Half closed)
Kindly answer correctly. Please show the necessary steps. Thank you so much
2. A car is traveling on a highway at 28 m/s. a) What is the pressure at the bottom of a car's gas tank. that is a cube with side lengths of 0.5 meters? Assume the tank is full of gasoline with a denisty of 800 kg/m^3. b) How much pressure does a pump need to supply in order to draw gasloine from the bottom of the tank to the top of the tank? The velocity of the gasoline once it is pumped out of the tank should be 1 cm/s; the gas at the bottom of the tank is at rest. c) The gasoline from part b flows through a tube (cylinder) of radius lcm before entering a larger tube of radius 10cm. What will the velocity of the gasoline be in the larger tube? d) The tires on the car have an outer radius of 0.2 meters. How many complete rotations did the tires go through in one hour? Hint: Determine how far the car travels in one hour. e) How many hours can the car travel before running out of gas? f) During your journey. you hit a pothole and have to change your tire. You get your spare…
Given the following system setup, determine the value of h. Q-0.1 m^3/s 0.15 diameter 1m Water 0.3m diameter
1) A plot of pump net head is shown below. Two curves are drawn: blue color curve and red color curve. Which one is called pump performance curve? Will the location of pump performance curve change if the velocity of the fluid at pump outlet changes? a) red curve; No, the location will not change b) blue curve; yes, the location will change c) red curve; yes, the location will change d) blue curve; No, the location will not change 2) In a turbine system, states A and B are homologous. If the net head ratio HA/HB =16 , volume flow rate ratio VA˙/VB˙=9. What is the diameter ratio DA/DB ? a) 3/2 b) 6 c) 12 d) 2/3
Please explain all intermediate steps. Thanks you
Convert
A gardener feels it is taking too long to water a garden with a 0.40 in. diameter hose. By what factor will the time be cut using a 0.53 in. diameter hose instead? Assume nothing else is changed.