! Required information Two portions of member AB are glued together along a plane forming an angle 0 with the horizontal. The ultimate stress for the glued joint is 3.4 ksi in tension and 1.7 ksi in shear. NOTE: This is a multi-part question. Once an answer is submitted, you will be unable to return to this part. 2.4 kips 1.25 in. 2.0 in. Determine the value of 0 for which the factor of safety of the member is maximum. (Hint: Equate the expressions obtained for the factors of safety with respect to the normal and shearing stresses.) The value of 0 for which the factor of safety of the member is maximum is

Q: Two intersecting lines A-B and C-D have azimuths A-B= 45deg. 33' 45", C-D= 309deg 11'20". What is…

A: The azimuth of line AB is 45deg 33'45" and the azimuth of line CD is 309deg11'20", Line AB and CD…

Q: Two points, A and B, are 3143.50 meters apart. From a Third Point , C, an instrument is set up on…

A: The elevation difference between the points is calculated by the following equation  tanθ=hd where…

Q: 3. From Figure 3.1, describe why we have to keep distance from level to back sight equals level to…

A: To describe why we have to keep distance from level to backsight equal to foresight.

Q: Ø7/8 2 holas R 1.780+0.020 .0.000 0.375t0.002 -0.000 ROCKER ARM %3D

A: How to input units in such a way in Autocad.

Q: 1. The interior angle of a six-sided closed traverse were measured as follows: A 36 54' 23 B = 145…

A: Given  6 sides polygon  Interior angles of the polygon

Q: Create a plot of the curvature and refraction corrections for sightlines going from 0 ft to 5000 ft…

A: Given:- Refraction corrections = 0 ft to 5000 ft 500 ft increments To find:- plot of the curvature…

Q: Compute and draw the equivalent Azimuths and Bearings. Equivalent Azimuths and Bearings Azimuth…

A:

Q: Define the term 'shear centre' of a thin-walled open section and determine the position of the shear…

A: Shear Centre is the point in a beam cross-section  through which shear loads must be applied for…

Q: QUESTION. Using angles to the right, calculate the bearings and azimuths of the lines North South…

A:

Q: = 1150 feet. Compute 4. Given: PI @ 10+71.78, Delta = 36° 10' 30", to the right, Radius the…

A:

Q: 4. What is the interior angle at A? This is angle CAB - note that this angle is an angle to the…

A: Given- Angle CAB=?

Q: Given the open traverse ABCD with coordinates of A, B, C and D as shown. measurements are in ft.…

A: To find bearing and length

Q: Find the stations and chainages of PC and PT. Ch= 2742.60 A = 120° TP1 R = 500 TP2

A: Step 1: Given data. Step 2: Calculation for the Tangent length and the length of curve. Step 3:…

Q: Two points A and B are in the HP. Point A is 30 mm in front of the VP, while B is behind the VP. The…

A:

Instruments for Surveying

Surveying is the practice that determines the relative three-dimensional positions of many different points on the earth’s surface. There are various instruments used in Surveying like Theodolites, Total station, Tripod stands, Plane table, etc. for measuring horizontal angle, vertical and sloping angle, which are very useful for giving accurate and precise measurement.