Required information The rigid bar AD is supported by two steel wires of -in. diameter (E = 29 × 106 psi) and a pin and bracket at A. The wires were initially taut when a 240-lb load P was applied at D. S in. 10 in. 12 in. 12 in. 12 in. Determine the additional tension in each wire when the load P is applied. The additional tension in wire BE is The additional tension in wire CFI | | lb. lb.

Q: ber AB consists of a single C130 x 10.4 steel channel of length 2.5 m. Knowing that the pins A ross…

A:

Q: surrounded by a 304 stainless steel tube. Before the load is applied the gap between these two parts…

A: To find greatest axial load P  Ebr=101GPa Est=193GPa

Q: B D 3 600 lb

A:

Q: н 12ft х C +9+-+-34 B D 101b 40lb

A:

Q: The pipe ACDE is supported by ball-and-socket joints at A and E and by the wire DF. Determine the…

A:

Q: igure A. 4 m B C * 2m- 2m ap 2m D 500 N 700 N 2 of 2 > ▼ Part B Identify the zero-force members in…

A:

Q: 490 mm 200 mm 640 N B 480 mm 160 mm 240 mm PROBLEM 4.152 The pipe ACDE is supported by…

A: The objective of this problem is to determine the tension in the wire DF when a load of 640 N is…

Q: If a force of F = 50 lb is applied to the pads at A and C, determine the smallest dimension d…

A:

Q: "1-80. Determine the maximum allowable torque T that can be transmitted by the joint. The shear pin…

A: Given:- The diameter of the shear pin is 25 mm  The failure shear stress of the material (τtail) =…

Q: Determine the magnitude of the pin force at A. Assume W-620 lb, a-4.6 ft, b- 3.1 ft.r-8 in. B b W…

A: The size of a force is measured by its magnitude. It's the sum of all the forces operating on a…

Q: 1-7. Determine the resultant internal loading on the cross section through point D of the pliers.…

A:

Q: ure A 2m B 2 m C 2 m D 4 m 500 N 700 N Part B Identify the zero-force members in the truss shown in…

A:

Methods to Determine Vertical Stress

The load applied to the soil is transferred to the underground. The presence of water at soil pores and solid grains above the soil are the primary components that are responsible for the effective load transfer. Due to the load acting, the internal component of the soil or the underground formations undergoes deformations or a tectonic shift. The amount of deformation depends upon the amount of load acting on the soil surface, which indeed, depends on the weight of everything present above the soil. Due to this, the underground soil element develops internal stresses which try to resist the tectonic changes.