Required information A painter (mass 61.0 kg) is walking along a trestle, consisting of a uniform plank (mass 18.3 kg, length 6.00 m) balanced on two sawhorses. Each sawhorse is placed 1.40 m from an end of the plank. A paint bucket (mass 4.00 kg, diameter 0.280 m) is placed as close as possible to the right-hand edge of the plank while still having the whole bucket in contact with the plank. -1.40 m 6.00 m m -0.280 m -1.40 m How close to the right-hand edge (distance from the RH edge) of the plank can the painter walk before tipping the plank and spilling the paint?

Required information A painter (mass 61.0 kg) is walking along a trestle, consisting of a uniform plank (mass 18.3 kg, length 6.00 m) balanced on two sawhorses. Each sawhorse is placed 1.40 m from an end of the plank. A paint bucket (mass 4.00 kg, diameter 0.280 m) is placed as close as possible to the right-hand edge of the plank while still having the whole bucket in contact with the plank. -1.40 m 6.00 m m -0.280 m -1.40 m How close to the right-hand edge (distance from the RH edge) of the plank can the painter walk before tipping the plank and spilling the paint?

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

2
Two children of mass 21 kg and 26 kg sit balanced on a seesaw with the pivot point located at the center of the seesaw. If the children are separated by a distance of 2 m, at what distance from the pivot point is the small child sitting in order to maintain the balance? m
A gardener is using a tool as shown in the figure to pull weeds. 24 cm You will notice that the tool is designed with a built-in pivot point about which the torques are applied. If the gardener applies a 1.77 Nm torque (about the pivot point) in order to pull a weed, determine the resistive force (in N) the weed exerts on the weed puller. N
Answer all questions
6. A 1.5 m long board with a mass of 4.2 kg sits on top of a 3.0 m long board with mass of 1.5 kg that is balanced on a pivot, as shown in Figure. What is the distance d? d Figure 1
Two toddlers Anne (12.0 kg) and Bob (15.0 kg) sat on both ends of a uniform 5.00-m see-saw supported at the center. If Anne sites on the leftmost edge of the see-saw, where should Bob sit from the right edge to keep the system horizontal and in equilibrium? A. 2.50 m from the right edge B. 1.50 m from the right edge C. 2.00 m from the right edge D. 0.500 m from the right edge
Item 3 Hide Timer 01: 3 of 2 You are pushing an 80.0 N wheelbarrow as shown in (Figure 1). You lift upward on the handle of the wheelbarrow so that the only point of contact between the wheelbarrow and the ground is at the front wheel. Assume the distances are as shown in the figure, where 0.50 m is the horizontal distance from the center of the wheel to the center of gravity of the wheelbarrow. The center gravity of the dirt in the wheelbarrow is assumed to also be a horizontal distance of 0.50 m from the center of the wheel. Suppose that the maximum total upward force that you can apply to the wheelbarrow handles is 75 lb. Cons Part A If you apply this estimated force, what is the maximum weight of dirt that you can carry in the wheelbarrow? Express your answer in pounds. w = 6.42 lb Submit Previous Answers Completed Part B If the dirt has the weight you calculated in part A, what upward force does the ground apply to the wheel of the wheelbarrow? Figure Provide Feedback DII 888 19…
The uniform seesaw shown below is balanced on a fulcrum located d1 = 3.5m from the left end. The bigger boy on the left end has a mass m1 =75 kg. The smaller boy on the right end has a mass of m2 = 55 kg and is a distance d2 = 4.5 m from the fulcrum. The mass of the board is mb. Draw all forces acting on the seesaw board showing their directions and locations. Where would you draw the weight of the board? Identify and show the direction of rotations caused by the torques provided by all forces about the fulcrum. If the seesaw is in static equilibrium, write down the two conditions of static equilibrium symbolically using the forces and distances in the figure. Solve for the mass of the board. Calculate the force of fulcrum on the board.
The diagram above shows a 3.00 m long uniform beam. The left end of the beam is attached to a wall by a frictionless pivot. The beam is supported by a string that keeps the beam horizontal. The string makes an angle of 35.0° relative to vertical. The beam has a mass of 7.00 kg. A 2.00 kg mass is located at the end of the beam. A 6.00 kg mass is located 1.00 m from the 2.00 kg mass, as shown in the diagram. a. What is the tension in the string? b. What is the y-component of force applied to the beam by the pivot?
A 32.0 kg child sits on one end of a long uniform beam having a mass of 18.0 kg, and a 40.0 kg child sits on the other end. The beam balances when a fulcrum is placed below the beam a distance 1.20 m from the 32.0 kg child. How long is the beam? A. 1.93 m B. 2.20 m C. 2.07 m D. 1.97 m E. 2.12 m
A 70kg adult sits at one end of a 9.0m long board. Their 23kg child sits on the other end. A. Where should the pivot be placed so the board is balanced (as distance from adult). Ignore the boards mass. B. Find the pivot point if the board is uniform and has a mass of 15kg.
Don't Use Chat GPT Will Upvote And Give Handwritten Solution Please