Reg.No/100

Q: QUESTION 5 A pipe system has a flow of 4.6 cfs. Section 1 has a diameter of 12" and Sectoin 2 has a…

A:

Q: For this diagram of an industrial pressure washer system, x = 2 ft, y = 5 ft, z = 9 ft, Q = 3.4…

A: Given data - Q = 3.4 ft³/s dh  = 1 in dn = 3 in hL = 4 ft Find out - Pressure at point 2.

Q: A schematic of the branched pipes is shown in Figure 3. Unit 1 requires a pump placed in line to…

A:

Q: without rupturing. Determine the maximum length, 1, allowed if the roughn 00015 ft and the flowrate…

A:

Q: pump is used to draw water from an open reservoir to an open tank on the top of a building. The…

A: a) To find the total dynamic head, we need to find the sum of the static head, velocity head, and…

Q: A pump is used to draw water from an open reservoir to an open tank on the top of a building. The…

A: Given,  Flow rate (Q) = 50 L/s or 0.05 m3/s Static head (Hs) = 6 m  Static discharge head (Hsd) = 20…

Q: Determine the available NPSH for the system shown in Fig. 13.38 (b). The fluid is water at 80°C and…

A: Given, Atmospheric pressure Patm=101.8 kPa Water level in the tank hs= 2 mFlow rate Q= 300 L/min…

Q: Oil flows at a flow rate of 0.030 (m³/s) in two pipes Connected in Series upwards from point No. (1)…

A: Flow rate, Q = 0.03 m3/s Length , L1 = 700 m  Length, L2 = 1 km or 1000m

Q: Válvula de globo abierta 50% de 4 in Elev=140 ft Codo regular de 90° de 4 in Elev=40 ft Codo Tubería…

A:

Q: ISTINYE ISU UNIVERSITY Question 2: A steel pipe is used to drain water from a reservoir that is 50 m…

A:

Q: Problem 3. A 30 cm pipe is connected by a reducer to a 10 cm pipe. Points 1 and 2 are at the same…

A:

Q: Prob. # 3 (a): A 90° horizontal reducing elbow carries a flow of 12 cfs (i.e., cubic feet per…

A:

Q: 11. From the figure shown, the tank contains oil having a sg = 0.82. Oil flows at a certain rate…

A: specific gravity of oil(s) =0.82fluid head = 2.8 m power (P) =9 hpDiameter of orffice =80…

Q: Water is pumped from a supply reservoir to a ductile iron water transmission line. The high point of…

A:

Q: (Flow through Single Pipes). Determine the flow in each pipe and the pressure at the junction node,…

A: g= 9.81m/s2 =32.19ft/s2

Q: H.W(2):Water flows steadily from a large tank through a pipe that splits into two smaller pipes as…

A: Given data in question  Water Depths Diameter  To find out  Pressure at point 1 Discharge through…

Q: 2. A 20mm diameter commercial steel pipe, 30m long is used to drain an oil tank. Determine the…

A:

Q: In the branched pipe system shown in Fig. 12.8, 1350 gal/min of benzene (sg = 0.87) at 140°F is…

A: Given: The length of each branch of the pipe is L=500 ft. The specific gravity of benzene is…

Q: The figure shows a portion of a hydraulic circuit. The pressure at point B must be 250psig. When the…

A: Given data: Pressure at point B, PB=200 psig   Volume flow rate, Q=80galmin   Specific gravity…

Q: Oricul Q3: Three pipes (A, B and C) are interconnected as shown in figure (3). Determine the flow…

A:

Q: 1) Determine the flow in Ips on the orifice between the 2 tanks shown below AIR 25kPa AIR 10kPa OIL…

A:

Q: 2. A tank and piping system are shown below. The total length of PVC pipe is 2500 ft and discharges…

A: We have to find the pressure at A in the mid point of the pipeline according to the given data like…

Q: Q1) Given is a three-pipe series system, as in Fig. 150,000 Pa, and the elevation drop is ZA - ZB…

A: The pressure drop is PA - PB = 150000 Pa zA - zB = 5 ρ = 1000 kg/m3 ν = 1.02 × 10-6 m2/sec

Q: A pipeline 200 meters long delivers water from an impounding reservoir to a service reservoir with…

A: Given- L=200 mH=20 md=400 mm d=04mf=0.013Korifice=2.5Kchk=2Kentry=0.5Kexit=1

Q: 3. For the piping system shown, the flow rate is 18 ft³/s of water (p = 1.94 slugs/ft³). Compute the…

A: Calculation of Pressure drop between junction point and Discharge in Each pipe####

Q: Situation 1: In the pipe system shown, the velocity of water in pipe A is 1 m/s. The friction factor…

A: As per guidelines, first three sub parts have been solved.

Q: Q=300 liters/sec.1 D-202.7 mm of L₁=300 m D₂=202.7 mm Ø L₂=150 m BY D3=202.7 mm Ø L₁=75 m D-381 mm Ø…

A:

Q: Water is pumped from a supply reservoir to a ductile ron water transmission line. The high point of…

A: Given ;

Pressurized pipe flow

A 15-kilometer-long pipe with a pipe diameter of one meter transports water at a speed of one meter per second. The pipe has a friction coefficient of 0.005. Calculate the frictional head loss?