Refer to the galvanic cell below (the contents of each half-cell are written beneath each compartment): Pt Cr 0.10 M MnO4 0.40 M Cr*+ 0.20 M Mn²+ 0.30 M Cr2O7²- 0.010 M H* 0.010 M H* The standard reduction potentials are as follows: MnO4¯ + 8H* + 5e Cr2072 + 14H* + 6e → Mn+ + 4H2O, ɛ° = 1.51 V 2Cr3+ + 7H2O, ɛ° = 1.33 V %3D 5. In the balanced cell reaction, what is the stoichiometric coefficient for H*? a. 5 b. 6 c. 30 d. 22 e. 2

Refer to the galvanic cell below (the contents of each half-cell are written beneath each compartment): Pt Cr 0.10 M MnO4 0.40 M Cr+ 0.20 M Mn²+ 0.30 M Cr2O7²- 0.010 M H 0.010 M H* The standard reduction potentials are as follows: MnO4¯ + 8H* + 5e Cr2072 + 14H* + 6e → Mn+ + 4H2O, ɛ° = 1.51 V 2Cr3+ + 7H2O, ɛ° = 1.33 V %3D 5. In the balanced cell reaction, what is the stoichiometric coefficient for H*? a. 5 b. 6 c. 30 d. 22 e. 2

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Similar questions

› Calculate the cell potential for the galvanic cell in which the given reaction occurs at 25 °C, given that [Ni²+] = 0.00100 M and [Au³+] = 0.834 M. Standard reduction potentials can be found in this table. 3 Ni(s) + 2 Au³ +(aq) — 3 Ni² †(aq) + 2 Au(s) E = 1.72 Incorrect V
Subject: chemistry
A certain half-reaction has a standard reduction potential Ered=-0.64 V. An engineer proposes using this half-reaction at the cathode of a galvanic cell that must provide at least 1.20 V of electrical power. The cell will operate under standard conditions. Note for advanced students: assume the engineer requires this half-reaction to happen at the cathode of the cell. ロ→ロ 7² 0 Is there a minimum standard reduction potential that the half-reaction used at the anode of this cell can have? yes, there is a minimum. = v If so, check the "yes" box and calculate the minimum. Round your answer to 2 decimal places. If there is no lower limit, check the "no" box. no minimum X S ? Is there a maximum standard reduction potential that the half-reaction used at the anode of this cell can have? O yes, there is a maximum. ☐v If so, check the "yes" box and calculate the maximum. Round your answer to 2 decimal places. If there is no upper limit, check the "no" box. no maximum By using the information in…
What is the standard cell potential for a galvanic cell made up of Ni and Zn?
Use the standard reduction potentials given below to predict if a reaction will occur when Mg metal is put into a 1 M aqueous Cd²+ solution. Cd(s) Eº = -0.403 V red Eº → Mg(s) Fred = -2.370 V Cd2+ (aq) + 2e → 2+ Mg²+ (aq) + 2e If a reaction will occur, write a balanced net ionic equation for the reaction. If no reaction will occur, leave all boxes blank. (Use the lowest possible coefficients. Be sure to specify states such as (aq) or (s). If a box is not needed, leave it blank.) +
Given the following electrochemical cell, calculate the potential for the cell in which the concentration of Ag+ is 0.0765 M, the pH of the H* cell is 2.700, and the pressure for H₂ is held constant at 1 atm. The temperature is held constant at 55°C. Ag Ag+ H+ Standard reduction potentials: 2H+ +2e¯ → H₂ Eº = 0 V Ag+ le - H₂(g) → Ag Eº=0.800 V
A galvanic cell is made of a Ni2+/Ni half cell with [Ni²+] = 1.00 × 10-3 M and a Ag*/Ag half cell with [Ag*] = 5.00 x 10-2 M. Calculate the electromotive force of the cell at 25 °C. F= 96500 C/mol, R=8.314 J/mol.K The reduction potentials for the two half cells are: Ni2+ (aq) + 2e →Ni(s) E° = -0.24 V Ag*(aq) + e¯ →Ag(s) E° = +0.8 V %3D O a. 1.09 O b. 1.04 O c. 1.06 O d. 0.98 O e. 1.12
A non-standard state galvanic cell is constructed at 25.00°C as described here. The Fe(s) anode is immersed in a 0.040 M Fe(NO3)2 solution. The Cu(s) cathode is immersed in a 0.0060 M Cu(NO3)2. The circuit is completed with a salt bridge containing 1.0 M KNO3. The standard Fe/Fe2+ reduction potential is –0.44 V. The standard Cu/Cu2+ reduction potential is +0.34 V. Calculate the non-standard-state cell potential for this galvanic cell and determine if the reaction described is spontaneous under these conditions.
Is there a minimum or maximum standard reduction potential that the half-reaction can have. Then write the balanced equation
A galvanic cell has copper cathode and zinc anode. Given the data below, calculate the standard cell potential of this galvanic cell. * Reduction Half-Reactions Cu*2 (ag) + 2e → Cu (s) Zn*2 (ag) + 2e → Zn (s) Reduction Potential 0.340 V - 0.763 V Your answer
Which of the following pairings is CORRECT? Obronze - compound gravel - homogeneous mixture Osolid iodine - atom Obromine gas - molecule white wine - heterogeneous mixture