r=5m 5m 30 30 Fv A 2 meter wide sluice gate is in the form of a circular arc of radius 5 m as shown. Compute the horizontal forces acting on the gate. Unit of the Correct Answer: kN Decimal Places required in the final answer: 2

r=5m 5m 30 30 Fv A 2 meter wide sluice gate is in the form of a circular arc of radius 5 m as shown. Compute the horizontal forces acting on the gate. Unit of the Correct Answer: kN Decimal Places required in the final answer: 2

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: From the figure shown, consider 1 unit width of gate. W.S. 6 feet 6 feet 8. Compute the horizontal…

Q: 5/195 In the linkage shown OC has a constant clockwise angular velocity w = 2 rad/s during an…

A: Given Angular velocity= 2rad/s

Q: A

Q: nd the magnitude and location of the net horizontal force _0 m 11 Water 11.0 m A 45° B-2.0 m KN 2.0…

Q: The gate shown in the figure is in raised position but initially is not filled with water (a.) If…

A: Center of pressure: The mean position of all the pressure applied on a fluid moving body is…

Q: Figure shows the side view of a tank with a curved gate. The gate width into the page is 18 in. The…

Q: Problem I. In a road construction along the CaviteX expressway, a wedge of weight (W; =552 N) is…

Q: Q5: Calculate the force exerted by the piston at A to hold the curved gate in the position shown in…

Q: The gate AB is 4.60 m long and 2.4 m wide perpendicular to the paper and is hinged at A with a stop…

Q: The pipe elbow below discharges water at rate of SN/100 (m3/s) into the atmosphere at section 2 .…

A: Consider the given data

Q: to The 6-m-wide rectangular gate shown in the figure is hinge making an angle of 45° with the…

Q: In the given figure, rectangular gates AB and CD are shown. If the width of both gates is 3m,…

Q: shown, a gate has a parabolic shape that follows the equation y=C?32x2, where C = 6.00ft . (Figure…

Q: Q2// Gate AB weights 180 kg and 1.2 m wide, Determine the water height in the right side of the gate…

Q: omponent of the hydrostatic force (in N) acting on the gate. Indicate the direction by putting an R…

Q: Q1: How high (h) will the water on the right side have to rise to open the gate shown in the figure…

A: Given data,gate width=2mS=specific gravity of gate material =2.5h=water level right side of…

Q: The gate in the diagram below is roughly a quarter of a circular cylinder and opens automatically…

A: Gathering Information: The gate has a radius of R=1 m. H=4 m m is the height of the water. Assume a…

Q: :In Figure below, find the hydrostatic force on the curve AB Oil S=0.9 Tank Cylinder r=1.5m B 2.25 m…

Q: Gate AB is 1.0 m wide perpendicular to the paper and open to let fresh water out when the ocean tide…

A: Determine the eccentricity of the hydrostatic force exerted by the fresh water upon the gate AB in…

Q: a) Determine the hydrostatic force (in kips) acting on the dam. b) Determine the moment of inertia…

A: We will solve this question in step no. 2

Q: 3. For the gate shown, α = 45°, y₁ = 1 m, and y₂ = 4 m. Will the gate fall or stay in position under…

A: Given :

Q: The motor draws in the cable at C with a constant velocity of Vc = 4 m/s. The motor draws in the…

A: vc=4 m/saD= 3.5 m/sec2VD=0 when , t=0

Q: the

Q: A cylindrical gate with surface XY is supported by a hinge at point 1. The length of the gate…

A: Find horizontal component of force,Fx=?

Q: Calculate the horizontal and vertical force acting on the covariate gate in the figure. Calculate…

A: Horizontal force Fh will be equal to the force on the projected area of the curved surface on a…

Q: Consider the 3-m long gate shown in the figure. Determine the following: Y, = 9.79 kN/m Sm. 5m Fv or…

Q: Determine the total hydrostatic force (N) in an inclined, rectangular gate 563.19 mm width with…

A: First find the depth of centroid. Then using this value calculate the pressure at centroid. Finally…

Q: *Exercise 1: The gate 90° is subjected to water pressure as shown in figure. Find (Fy and Fy) Water…

A: Given data: the gate is 90° R = 5m we have to find Fh and Fv

Q: A crest gate shown in Figure 1. consists of a cylindrical surface of which AB is the base, supported…

Q: Quarter-circle WATER Hinge

Q: A quarter circular gate, 4 meters long (perpendicular to paper) hinge about its upper edge, controls…

A: To Determine Horizontal and vertical forces acting on the curved surface.

Q: Shown in the figure below. Determine the velocity in the pipe opening (d=50mm DIA) in m/s ELEV = 50m…

A: ● Solution:- As per the given data :- diameter (d) = 50 mm Elevation at water surface h1= 50 m…

Q: A rectangular gate of width "a", length "b" and inclined at an angle "A", with water on one side is…

A: width a=9.5 ftlengthb=5 ftz=6.5 ft∠A=55°depth of centroid of the rectangular…

Q: Solve for the minimum tension on the cable necessary to open the circular gate AB. Neglect the…

Q: SITUATION D. From the figure shown, consider 1 unit width of gate. ws WS. 6 feet 6 feet 8. Compute…

Q: A cylindrical gate with surface XY is supported by a hinge at point 1. The length of the gate…

A: 2. 63 is the correct answer.

Q: A rectangular gate 1.4 m in base and 1.8 m high is placed on the face of the water reservoir, as…

A: b=1.4mh=1.8mm=20 kgD=2mm gate= 50 kgH=4mTo find:-Height of buoyancy below the water surface

Q: hydrostatic

Q: Q2. The rectangular AB gate whose width is 2.2 m shown in the following figure is hinged at point A.…

Q: A cylindrical gate with surface XY is supported by a hinge at point 1. The length of the gate…

Q: Compute the location of the center of pressure from B for a gate 1.70 m wide and 2.0m high has a…

A: Compute the location of the center of pressure from B for a gate

Q: Gate -Hinge 6.30m to 2.80 m PICURE A

A: b=2.2m

Q: 5.44 Assuming frictionless, incompressible, one-dimensional flow of water through the horizontal tee…

A: Velocity at section 1 , V1=6 m/s pressure at section-1 , P1=200 kPa=200×103 Pa Diameter of each…

Q: The pipe elbow below discharges water at rate of SN/100 (m3 /s) into the atmosphere at section 2.…

A: The given data is: Discharge rate, Q=0.21 m3/s Total volume of passage, V=0.2 m3 Total mass of elbow…

Q: Given: Figure Find: External reactions in x and y directions needed to hold fixed vane. Solution: s…

Question

r=5m
5m
30
A 2 meter wide sluice gate is in the form of a circular arc of radius 5 m as shown. Compute the horizontal forces acting on the gate.
Unit of the Correct Answer: kN
Decimal Places required in the final answer: 2

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

Determine the weight of the gate per meter of width (in/out of plane of paper) so that it is about to open up and rotate clockwise when the depth of water is 4m. The gate is a quarter circle of uniform material. 1 m Pivot 4 m
In the figure given below, determine the vertical reaction at points A, C, and E.
Take F = 320 N and d = 1.0 m. (Figure 1) Figure 1.5 m B C -2 m D F 1 of 1 > Part A Determine the force in cable AC needed to hold the 21-kg ball D in equlibrium. Express your answer to two significant figures and include the appropriate units. FAC = Submit Part B Value Request Answer Submit O ▼ Determine the force in cable AB needed to hold the 21-kg ball D in equlibrium. Express your answer to two significant figures and include the appropriate units. μA FAB = Value Units Request Answer wwwww Units ? ww ?
The 1.55x10-Ib pipe is supported in equilibrium by three cables as shown in (Figure 1). Figure 135 IR Stasking 240 PD 1 of 1 Y Determine the force in cable AB for equilibrium of the hook at A. Express your answer in kilopounds to three significant figures. FAB= 3.331 IVE ΑΣΦΗ Submit Previous Answers Request Answer Part B X Incorrect; Try Again; 2 attempts remaining FAC= vec Determine the force in cable AC for equilibrium of the hook at A. Express your answer in kilopounds to three significant figures. VG ΑΣΦ41 vec Submit Request Answer ? kip kip
If the gate was designed to withstand a maximum force of 6,000 lbs, verify the gate will not break when the tank is filled with gas.
Show complete solution and Write legibly.
In the figure below, Gate A/B/C is 1 m square and is hinged at B. Calculate the depth of water above the top of the gate (h) at which the gate will begin to open.
Consider the tank shown in the figure. The gate is rectangular in shape with width into the paper of 2.0ft. Given: h=4.1ft B=4.2ft Angle,sg= 0.70 Calculate the eccentricity(inches) of the hydrostatic force on the gate.
Water flows at a rate of 107L /s round a 1510 contracting pipe bend which lies in a horizontal plane. The diameter at the bend entrance is 771mm and at the exit 418mm. If the pressure at the entrance to the bend is 256kN/m2, determine the resultant force in the Horizontal direction (taking to the Left as positive) exerted by the fluid on the bend, correct to the nearest N. (Use π = 3.14)
Determine the magnitude of the hydrostatic force acting on gate AB, which has a width of 1 \rm m
(a) Compare the resultant force acting on the gate if we change the shape of the gate from a triangle to an equivalent circle. (b) Compare the line of actions, as well. The initial location of the 0.7-m-high and 0.7-m- wide triangular gate is shown in the figure below. 0.9 m Water 0.3 m B 0.7 m 0.7 m
A vertical gate keeps water from flowing in a triangular irrigation channel. The channel has a 65 m top width and a 48 m depth. If the channel is full, what is the depth, Yp, of the hydrostatic force on the triangular gate in m? Use the formulas: I. Yp Aỹ h 3 1 -bh3 36 I.