QY A Soil profile consists of a surface layer of Line Sand 6m thick with unit weight of 16-5 KN/m³ and clay layer of 8m thick beneth the Sand layer. the water table is located at adepth of 4m below the ground surface: submergend for line sand is 10.4 kN/m², Gs love clay layer is 2.78 wc %. 30% = calculate the effective stress at the middle of clay layer. t 6m 8m 4M -#-DW.T Fine Sand clay 8=165& sub = loy tu tw M2 63=2-7 w;. = 30%.

Q: The profile at a site consists of 5m of sand overlying 10m of compressible clay, which in turn…

A: The excess pore water pressure is developed in the clay layer by immediately placing the surcharge…

Q: Example 22 se For a normally consolidated clay (c' = 0) these are the results for a consolidated…

A: Deviator stress = sigma1 - Sigma3 Chamber pressure = Sigma3

Q: 1. Compute the effective stress at the mid-height the clay layer. a. 80.21 kPa c. 51.30 kPa b. 84.58…

A: All the given data presented in the figure itself below asneed to find The effective stress in the…

Q: Ground surface n = 13.2 kN/m 2. The soil profile for a proposed construction site is shown. The…

A:

Q: A soil element is subject to an overburden pressure equal to 100 kPa. The maximum shear stress…

A: Given data in question  Overburden stress 100 kPa Maximum shear stress 30 kPa To find out  Lateral…

Q: The profile at a site consists of 5 m of sand overlying 10 m of compressible clay, which in turn…

A: The excess pore water pressure developed immediately after placing the stress of 200 kPa is…

Q: A 3 meter thick fill was placed over a 9 meter thick compressible clay. Underlying the clay layer is…

A: Thickness of fill = 3 mUnderlying the clay layer is a very hard impermeable clay.The diameter of the…

Q: effective stress (kPa) at the base of each soil layer listed below. Assume the water table rest 4 m…

A: The given data is shown in the diagram as below.To determine the total stress, pore water pressure…

Calculation of Settlement

The vertical displacement of the structural foundation due to the loading from the superstructure is known as settlement. It is due to the reduction of air voids present in the soil. The amount of vertical displacement depends on the bearing capacity of the soil on which the foundation is laid. The effect of the settlement depends on the magnitude of settlement, uniformity, and the structural design of the structure. The maximum allowable settlement for residential and office buildings should be less than 18 mm, for industrial buildings, it is 38 mm and for commercial buildings, it is 25 mm.