A 3m deep sand layer has a specific gravity of 2.68 and a void ratio of 0.60 Under this layer is a 2.5m deep clay profile with a specific gravity of 2.7 ar moisture content of 30%. The water table is observed at 1m below the gro surface. Determine the effective soil pressure at the midweight of clay.

Q: A saturated soil specimen has w = 36% and ᵞd = 85.43 lb/ft3. Determine: Void ratio

A: Given: Water content, w = 36% = 0.36 Dry unit weight = 85.43 lb/ft3 Degree of saturation, S = 100% =…

Q: A 3m deep sand layer has a specific gravity of 2.68 and a void ratio of 0.60. Under this layer is a…

A: step 1-

Q: A silty sand fill 4.5 meters thick and an estimated density of 20 kN/m³ is to be placed over 4.0 m…

A: eo = 1.255Cc = 0.29Cr = 0.035Cv = 0.79 m2/yrNOTE : As per guidelines, first 3 parts are solved.…

Q: A 3m deep sand layer has a specific gravity of 2.68 and a void ratiodf 0.60. Under this layer is a…

A: Compression index is CC=eo-eflogσ1+Δσσ1soFind inital void ratio of claySeo=woG1eo=0.32.7eo=0.81

Q: The profile at a site consists of 5m of sand overlying 10m of compressible clay, which in turn…

A: The excess pore water pressure is developed in the clay layer by immediately placing the surcharge…

Q: Q1) Triaxial un drained tests were performed on clay samples taken from stratum shown below (point…

A: Given: Triaxial undrained tests were performed on clay samples taken from stratum shown below Find…

Q: Q.23 A normally consolidated clay settled by 2cm when the effective stress was increased from 100kPa…

A: Given data,  Normally consolidated clay settle = 2 cm Effective stress increases from 100 kPa to 200…

Q: A 5 m thick soil stratum has coefficient of permeability of 3 × 10-7 m/sc. A separate test conducted…

A:

Q: A 3m deep sand layer has a specific gravity of 2.68 and a void ratio of 0.60. Under this layer is a…

A: step 1-

Q: A horizontal stratified soil deposit consists of three layers, each uniform in itself. The…

A:

Q: Q.23 A normally consolidated clay settled by 2cm when the effective stress was increased from 100kPa…

A: Given data- A normally consolidated clay- Settlement ∆H=2 cm, Initial effective stress -  σ'o=100…

Q: Q- 10 m below sea water is the bed of the sea. Take the unit weight of water = 9.81 kN/m². Take the…

A: Given,height of water level=10 mγw=9.81 kN/m3G=2.67Gsea=1.03ID=20%emax=1emin=0.5To…

Q: N.C soil overlaying on previous sand layer has a compression index Cc of 0.31, its void ratio at an…

A: compression index, Cc = 0.31 initial void ration , σo = 125 KN/m2 permeability coefficient, k = 4×…

Q: The soil profile at a site for a proposed office building consists of a layer of fine sand 10.4 m…

A: For Clay wGS=See=0.432.71e=1.161Saturated unit weight of…

Q: Given Well graded sand Specific gravity of soil = 2.65 %3D Void ratio = 0.57 Porosity = 36.5% %3D…

A: To Determine Dry unit weight of the soil.

Q: The top 500 m of a site consists of a clayey sand with void ratio of 0.90 and water content of…

A:

Q: The soil profile presented in Figure Q3 shows a borehole at a site where the water level is at 4m…

A: Calculate the unit weight of every soil layer to calculate stress: Step 1: Calculating unit…

Q: A normally consolidated clay sample is subjected to a tri-axial test where pore water measurements…

A: We have to find the value of pore water pressure u in kpa.

Q: A stratified soil deposit consists of four layers of equal thickness. The coefficient of permeabilit…

A: A stratified soil deposit consists of four layers of equal thickness. The coefficient of…

Q: A 3m deep sand layer has a specific gravity of 2.68 and a void ratio of 0.60. Under this layer is a…

A:

Q: Q1) Triaxial un drained tests were performed on clay samples taken from stratum shown below (point…

A: Given: Triaxial undrained tests were performed on clay samples taken from stratum shown below   a)…

Q: A horizontal stratified soil deposit consists of three layers, each uniform in itself. The…

A:

Q: A 10 meter soil profile consists sand overlying 3.50 m thick clay layer with porosity of 48.718% and…

A:

Q: 18-m thick soil has water table 5 m. below the ground surface. The soil has a void ratio of 0.52 and…

A:

Q: /

A:

Q: 16 The degree of saturation of a soil is 55% and the moist unit weight is 16.66 kN/m When the moist…

A: To find void ratio(e) and specific gravity (Gs)

Q: The wet weight of 500cm³ of soil is 7.2 N and its dry weight is 6.19N. Determine the: a. the water…

A:

Q: The soil profile at a site for a proposed office building consists of a layer of fine sand 10.4 m…

A: Given : Water content of clay, wc = 38%Initial height, Ho = 2 mVoid ratio of sand, eo = 0.76Vertical…

Q: an

A:

Q: A 3m deep sand layer has a specific gravity of 2.68 and a void ratio of 0.60. Under this layer is a…

A: For this problem we dont need to use the Coeff of consoldiation formula , as the final void ratio is…

Q: A saturated soil specimen has w = 36% and ᵞd = 85.43 lb/ft3. Determine: Void ratio

A: Given: Water content, w = 36% = 0.36 Dry unit weight = 85.43 lb/ft3 Degree of saturation, S = 1

Q: QUESTION: 5 Water is flowing in an upward direction through a stratum of sand, 4 m thick, under a…

A: Given data- thickness of sand=4 mtotal head difference=2 mSG=2.65void ratio e=0.065To Find-The FOS

Q: A sandy soil has in place unit weight 18.5 kN/m3 and water content 12%. The void ratio at the…

A: Objective: To determine the relative density and the maximum wet unit weight of the soil.   Given:…

Q: b) For a normally consolidated clay, given o = 20° and ø' = 28°. If a CU triaxial test is conducted…

A:

Calculation of Settlement

The vertical displacement of the structural foundation due to the loading from the superstructure is known as settlement. It is due to the reduction of air voids present in the soil. The amount of vertical displacement depends on the bearing capacity of the soil on which the foundation is laid. The effect of the settlement depends on the magnitude of settlement, uniformity, and the structural design of the structure. The maximum allowable settlement for residential and office buildings should be less than 18 mm, for industrial buildings, it is 38 mm and for commercial buildings, it is 25 mm.