Quize (3): A soil sample is subjected to an all-round pressure of 100 kN/m, the pore water pressure was 93 kN/m. With the drainage valve remains closed an increment of principal stress difference (o-0,) was applied causing the pore water pressure to increase to 133 kN/m. Knowing that A-0.4, determine B and (o, -o,).

Quize (3): A soil sample is subjected to an all-round pressure of 100 kN/m, the pore water pressure was 93 kN/m. With the drainage valve remains closed an increment of principal stress difference (o-0,) was applied causing the pore water pressure to increase to 133 kN/m. Knowing that A-0.4, determine B and (o, -o,).

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Ty =c'+o'tan o' 20 e Figure 8.2 Inclination of failure plane in soil with major principal plane Normal stress, o' (b) According to the failure plane shown in figure, prove that: 1) 0 = 45 + 2 2) o = o; tan( 45 + + 2c' tan 45 + Shear stress, t
7.12 A sand specimen was subjected to a drained shear test using hollow cylin- der test equipment. Failure was caused by increasing the inside pressure while keeping the outside pressure constant. At failure, o, = 193 kN/m² and o; = 264 kN/m². The inside and outside radii of the specimen were 40 and 60 mm, respectively. (a) Calculate the soil friction angle. (b) Calculate the axial stress on the specimen at failure.
Also, determine the effective stress at a depth of 7 ft. on the below ground surface. (10) Determine the pore water pressure at a depth of 5 ft. below the ground surface. (10) Problem 1: of s 19 Ground Surface 3' Y = 112 pcf 4' Y sat = 120 pcf
Problem 2 Plot the stress profile for total stress, effective stress, and pore water pressure. Show all calculation. Diy sand 0.61 Saturated sand 0.48. G-267 Clay
x 18 The effective shear strength equation (S = T₁ = 25+5 tam 30); expressed for a saturated clayey soil. In undrained test on a sample of the same soil using the shear box apparatus, the following data at failure were recorded :. Shear Stress = 90 kPa a) What and Normal stress = 180 kPa pore water pressure in the specimen at time of was the failure (assume Øu= 0). Find the Unconfined compressive strength (Od max) for the same soil an Unconfined. when tested in Compression test. c) Find the major principal stress when a sample of the same soil is tested in Ul test with confining pressure of (200 kPa).
1.A dry sand is known to have an angle of internal friction of 29. A triaxial test is planned, where the confining pressure will be 41 kPa. What is the maximum axial stress, in kPa, (major principal stress) that can be applied? Calculate the value to 1 decimal place. Do not provide units in your answer. 2.A clay soil is subjected to a triaxial test under unconsolidated-undrained conditions. At failure, the major and minor principal stresses are 8401 psf and 4875 psf, respectively. What is the shear strength of this soil if the confining pressure is doubled? Provide your answer in psf with no decimals.
Question 20 A soil profile consists of sand (5-m thick) which overlies a layer of clay (9-m thick). Ground water table is located at the interface of the sand and clay. The effective stress at the bottom of the clay layer was determined. If the water table rises to the top of the ground surface, what is the change in the effective stress (in kPa) at the bottom of the clay layer? For sand layer: Void Ratio = 0.82, Specific gravity = 2.68, Degree of Saturation = 0.6 For clay layer: Void Ratio = 0.92, Specific gravity = 2.86 Round off to two decimal places.
a) A CU triaxial test was carried out on a silty sand soil sample. The cell pressure was equal to 200 kPa. At failure the deviator stress was equal to 410 kPa and the pore pressure was equal to 73 kPa. i) Assuming that the cohesion intercept is equal to 0, calculate the friction angle of the soil. ii) If the friction angle was equal to 35°, calculate the cohesion intercept of the soil. iii) Calculate the angle of the failure plane relative to the horizontal plane for the soil shear strength parameters in Question 4 a i and 4 a ii.
A sand sample is subjected to direct shear testing. Two tests areperformed. For test 1, The sample shears at a stress of 2500 psf whenthe normal stress is 4000 psf.Test 2, The sample shears at a stress of 3500 psf when the normalstress is 6000 psf. Determine the following:a) Angle of Internal frictionb) Value of cohesionc) Compute the shear stress at a depth of 12 ft. if the unit weight ofthe soil is 150 pcf
A soil specimen is subjected to a tri – axial test. The soil specimen is cohesionless. If the shear stress that causes failure is 300 kPa. and the normal stress at failure is only 500 kPa 5. Determine the angle of shearing resistance in degrees 6. Determine the angle that the failure plane measured from the major principal plane. 7. Determine the total axial stress in kPa at which failure is expected to occur.
c. An undisturbed soil sample, 110 mm in diameter and 220 mm in height, was tested in a triaxial machine. The sample sheared under an additional axial load of 3.35 kN with a vertical deformation of 21 mm. The failure plane was inclined at 50° to the horizontal and the cell pressure was 300 kN/m². i. Draw the Mohr circle diagram representing the above stress conditions, and from it determine: - Coulomb's equation for the shear strength of the soil, in terms of total stress; - the magnitude and obliquity of the resultant stress on the failure plane. ii. A further undisturbed sample of the soil was tested in a shear box under the same drainage conditions as used for the previous test. If the area of the box was 3600 mm² and the normal load was 500 N, what would you expect the failure stress to have been?
In a drained triaxial test on consolidated clay the stress and angle are as follows: Deviator stress is 20 lb/in2 and friction angle is 21°. Calculate the effective confining pressure at failure.? a) 21 lb/in2 b) 22.2 lb/in2 c) 25.4 lb/in 2 d) 17.9 lb/in2