Questions 1-4 are based on the SLI battery (one battery module) in a car with specifications: Open Circuit Voltage (OCV): 12 V Resistance: 0.01 ohm Discharge Capacity: 50 Ah You are building an electric go-cart battery pack using 4 of these battery modules connected in series. 1. What is this battery pack open circuit voltage?   2. What is this battery pack capacity?   3. What is this battery pack energy?   4. Now connecting this battery pack with a traction motor, what is the battery pack voltage if the motor draws 200 A?

Q: List 5 examples of devices using DC Voltage and 5 examples of devices using AC Voltage. Don't give…

A: The device using the DC voltage has a constant supply voltage. The example of these devices are…

Q: What is the total internal resistance of an ohmmeter with a 1mA meter movement and having a 5VDC…

A: Given data: I=1 mAVB=5 V

Q: 500 Ω 6V -fi 600 Ω] 100 Ω Figure 1. Schematic Diagram

A:

Q: 4. The solar energy can be converted directly into: A. Mechanical energy. B. Electrical energy. C.…

A: Solar Energy- Solar power is converted into thermal and electrical energy. Solar technologies…

Q: Which of the following increases its resistance if the temperature increases? I. Conductors II.…

A: I. Conductors - A conductor readily carries electricity because it provides minimal  resistance to…

Q: An ammeter with range 0 to 2 mA has internal resistance of 10 N. What is the value of shunt…

A:

Q: The capacity of a battery is expressed in terms of A. Current rating B. Voltage rating C. Ampere…

A: Battery Capacity - The amount of active material contained in the battery determines the capacity of…

Q: 4. A battery may be rated in ampere-hours (Ah). An lead-acid battery is rated at 160 Ah. (a) what is…

A: In this question,  We need to calculate the maximum current if time t= 40h and how many days it last…

Q: Replace electrons with protons and solve

A: Given, Charge (Q)= 1 coulomb.

Q: The most prevalent type of primary battery in use today is _____.

A: Here it is asked that which is the most prevalent type of primary battery use today.

Q: -) In the following circuit using Kirchhoff's find: a) The current in each branch of the circuit. b)…

A:

Q: potential difference. Using the last 3 digits of your student number, (i.e. 190555) - 555 microohms…

A: Given: Resistance value is 11Ω each.

Q: Given: R1 = 9.4 N R2= 8.6 N R3= 7.6N R4= 9.7 N R5= 7.3 N R6= 3.1 2 When a 2.6 - volt battery is…

A: To find the voltage and current of each resistance, Nodal analysis is best suitable for the complex…

Q: Explain the charging system from Supply system to the battery in detail

A: In an Electric Vehicle (EV), the charging system is responsible for transferring electrical energy…

Q: 1. How can you calculate electrical power of a device for DC circuit: a. By multiplying voltage by…

A:

Q: 4. In a certain circuit current flowing through a resistor 330k ± 5% is measured as 0.01515 A with…

A: Given,Resistor value, R=330kΩ±5%Current, I=0.01515 with 0.0000144 A

Q: Kirchhoff's Law Pls each question based on the table. 1. What can you say about the current (I)…

A: “Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: None

A: Batteries are essential for storing electrical energy, and different types cater to various needs…

Q: Of the Type A electrical resistors produced by a factory, 85.0% have resistance greater than 41…

A: The answer is  14.1%

Q: The terminals of a certain battery are labeled a and b. The battery voltage is v ab = 12 V. To…

A: Energy stored in battery is given E = 600 J Voltage across the terminal ab is Here a is positive…

Q: An electric current is a of charged particles called flowing through the wires and electronic . It…

A: The solution is achieved as follows.

Q: Determining the ohmic value and tolerance of resistors using the color code.

A: As per Bartleby guidelines we are allowed to solve only one question, please ask the rest again.

Q: Discuss the types of Renewable Energy in 300

A:

Q: Part A2: Set R1 to 19 ohms. What battery voltage is required to achieve approximately 1.86 A

A: Given R1 = 19 ohm, Current I = 1.86 Amp To find battery voltage

Q: A 6-V Lead-Acid battery has and Amp hour rating of 180 Amp hours. The battery is to be load tested.…

A: Voltage of the lead-acid battery = 6V A-hr of the battery = 180 A-hr

Q: (ii) (iv) Explain how you would take a voltage measurement with a multimeter at a given point in a…

A: The above questions are based on different modes of a multimeter.

Q: Question: Given a 6.8k 5% resistors, in what range can the actual value of the resistance be and…

A: According to questions, we need to find actual range of resistor .

Q: How would you construct a battery pack that could supply 6V and 7A using D or AA alkaline batteries?

A: It is asked to construct a battery pack that could supply 6 V and 7 A using D or AA alkaline…

Q: provide specific values for the resistor, power source, and Red LED

A: Power Source: Typically a battery or a DC power supply.LED (Light Emitting Diode): A semiconductor…

Q: 2. A voltmeter shows a voltage drop of 0.5 V when a 10 kQ resistor is placed in series with a circui…

A:

Q: 1. Two identical zinc-carbon batteries are available. When connected in series, they supply 0.5…

A: The basic problem on battery is solved here

Q: 4S LiPo • 5100 mAh • charge rate 1-3C • discharge rate: 35C Complete the following questions as…

A: Since there are multiple questions uploaded so solving the relevant questions accordingly. Kindly…

Q: 1. Always include all the figures of your

A: Firstly finding R equivalent :- Req=R5+R6∥R3R4R3+R4+R2∥R1Putting given values we get,Req=4.758Now…

Q: Bulb A Sockets Battery + Bulb B Battery + Bulb C Resistor

A: As here two batteries are connected in series, three bulbs, and one resistor R is available.

Q: having an internal resistance of 100 ohm is used to convert into multirange ammeter having the…

A: Rating of ammeter 1 mA Internal resistance Rm=100 Ω Range is given 0-10 mA m=101=10 Shunt resistance…

Q: rules to find the electric current in each resistor of the

A:

Q: 4. A 1-cm by 2-cm solar cell has a conversion efficiency of 9%. Determine the maximum power rating…

A:

Q: (ii) A battery has an unknown internal resistance r's and an unloaded terminal voltage of 12 V as…

A: Give Data: A description of a circuit as, Battery voltage Vb=12 V Series internal resistance =rs…

Q: If we were to connect a voltmeter directory to an ohmmeter, what would you expect to see

A: If we were to connect a voltmeter directory to an ohmmeter, what would you expect to see changes in…

Q: 3. WHAT IS THE RESISTANCE AND WHICH COLOR CODES ARE GREE (VALUE 10%) 4.DETERMINE THE RESISTANCE O…

A: The solution is given below

Q: Match the property of electric circuits with the variable- representation in an equation.

A: To solve any electric circuit problem, one should know about the basic rules of electric circuit,…

Q: Which of the following does not work for Ohm's law? O a. Current value changes O b. Resistance value…

A: We need to tell which option is correct for the given statement.

Power Measurement

According to Blondel's theorem, the total power is measured with one less number of wattmeters than the number of wires present in the system. So, a single-phase and two-wire system will require one wattmeter and a single-phase and the three-wire system will require two wattmeters, and a three-phase and the three-wire system will also require two wattmeters and a three-phase and the four-wire system will require three wattmeter devices. The wattmeter is a device that measures power using one voltage and one current input as shown in the above figure. Multiple current or voltage input pair cables are used by many power analyzers and digital storage oscilloscopes (DSOs) for measuring watts, in effect within a single instrument acting as multiple wattmeters. It is possible to measure three-phase and four-wire power with one correctly specified power analyzer.