Answered: 4. In a certain circuit current flowing…

4. In a certain circuit current flowing through a resistor 330k ± 5% is measured as 0.01515 A with uncertainty of 0.0000144A. Calculate the voltage drop across the resistor with uncertainty.

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter12: Batteries And Other Sources Of Electricity

Section: Chapter Questions

Problem 14RQ: 14. A 6-V lead-acid battery has an A-hr rating of 180 A-hr. The battery is to be load-tested. What...

See similar textbooks

Related questions

Q: Determine: Branch currents and power in each resistor Kirchhoff's Laws

A: It is given that:

Q: For the op-amp shown in the following figure, the voltage gain is equal to------- 500 kfM Vout 50 kN…

Q: If a = 1cis120°, solve 1 + a + a?. O -1 O 2 O 1

A: From given a find a2 and than evaluate given expression.

Q: Explain what is CAN BUS.

A: according to the question we have, Explain what is CAN-BUS.

Q: Probability method

A: Probability Method: Probability is a method of describing uncertainty in numerical form. It can be…

Q: What is power dissipation in the Zener diode in Fig. P3.77 for (a) RL = 2 ks2 (b) R₁ = 4.7 k (c) RL…

A: Given, The circuit diagram,

Q: What is the reason for using numerical methods?

A: Reason for using numerical.methods

Q: A platinum resistance sensor has a resistance of 100 2 at 0 °C and a temperature coefficient of…

A: Given: Resistance R0=100Ω Temperature co efficient α0=4×10-3°C-1 R3R2=100 Vout=0 at 0°C

Q: Design a feedback shift register encoder for an (7, 3) cyclic code with a generator g(x) =1 + X² +…

A: According to the question, we need to design a feedback shift register encoder for a (7, 3)cyclic…

Q: 3) For a circuit described by the state diagram of figure: 0/0 1/0 00 01 0/1 0/1 0/1 1/0 10 1/0 1/0…

Q: An alternating voltage, given by v = 100 sin 314t is connected in series with a diode. The average…

Q: What is/are the significance of using Tinkercad? Why do we need Tinkercad? Explain. What are the…

Q: To compute: * = Ax-b Substitute values to get, ř II 0.780 0.563] 0.999 0.913 0.659 -1.001 [0.215657]…

A: Given, We need to compute r̅

Q: For which region of your experimental diode curve does the diode look like an o (á) Diode voltages…

A: (1) a diode looks like an open circuit when diode voltage less than barrier potential.…

Q: Could you explain this question in details, please. Embedded System (Electrical & Electronic…

A: we need to explain the meaning of Embedded System and its subpart.

Q: In the circuit shown below, R1 = 49 Q and R2 = 45 Q. Find the equivalent resistance seen by the…

A: From the given circuit Starting form the right side, the resistances 6 Ω+14 Ω∥15 Ω∥20 Ω∥4 Ω∥12 Ω So,…

Q: Could you explain this question in details, please. This question is about the Embedded System…

A: we need to explain the Arbitration in CAN BUS

Q: Basic problems 9.18 A deflection bridge has a supply voltage of 10 V. Find the bridge output voltage…

Q: 5- What is the effect of increasing k in First Order Systems Analysis on time constant & error ?…

A: The effect of increasing K in the first-order system is in step-2.

Q: Could you explain this question in details, please. This question is about the Embedded System…

A: we need to explain the meaning of vetronics

Q: B. Determine the overall gain of cascaded amplifier with the following specifications: a. 3-…

Q: What are linear and nonlinear data sets?

A: A linear data set is a VSAM informational index with a control stretch size of 4096 bytes to 32 768…

Q: Q5: Explain the function of three Forces Involved in A Deflection Instrument illustrate the…

A: The other name for the deflection instrument is the indicating type instrument. The indicating…

Q: + switch 240 V 4 Ω ΖΩ 0.5 F 2 H The switch has been closed for a long time. It is opened at t = 0.…

Q: What capacitance must be placed in series with an inductance of 0.05 H so that at 100 Hz, the…

Q: Figure 9.11 Strain gauge bridge connected to differential amplifier. Rf R1 |R2 D AOL Vs B, V2 R4 |R3…

A: Given data Strain is e = 0 to 10-3 Strain gauge resistance is R = 120 ohm. Gauge factor is G = 2.1…

Q: design a two-way traffic light system with prototype using 4-bit down counter circuit. use 7-segment…

A: According to the question, we need to design a two-way traffic light system with prototype using…

Q: Explain RTD with necessary diagram and equations.

A: A Resistance Temperature Detector (also known as a Resistance Thermometer or RTD) is an electronic…

Q: 12)If the sampling frequency is 1 KHz, then the number of samples in 5 minutes is equal to…

A: The solution can be achieved as follows.

Q: design a two-way traffic light system with prototype using 4-bit down counter circuit. use 7-segment…

A: It is asked to design the circuit of a two-way traffic light system on Tinkercad using 4-bit down…

Q: Two impedances Z1 = 2+j6 Q and Z2 = 6-j12 N are connected in series. What is the resultant impedance…

A: If both impedance are in series then total impedance will be added

Q: O By using the Kirchoff Laws, determine the loop currents i, to i, in the electrical network shown…

A: We have four loop currents to be determined in four loops. Write KVL equations for each loop and…

Q: Simplify the following, leaving exponents in the ans ((1)/(9))^(2) Full explain this question very…

Q: Apply Superposition theorem to determine the circuit I in the circuit of Fig. 15.29

A: Using super position theorem Current I?

Q: please answer in hand written i dont understand where i can put the exponent..

Concept explainers

Electrical Heating Unit

The conversion of electrical energy to heat energy is known as electric heating. The heating system that converts the electrical energy to heat energy for various application is called electrical heating unit. Electricity is employed as the firing mechanism in electric heating systems, which transforms electric current to heat. Electric heaters have heating elements in the form of electric resistors.

Question

100%

I need help with this uncertainty calculation. Thanks.

4. In a certain circuit current flowing through a resistor 330k ± 5% is measured as 0.01515
A with uncertainty of 0.0000144A. Calculate the voltage drop across the resistor with
uncertainty.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Trending now

This is a popular solution!

Step by step

Solved in 4 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

14. A 6-V lead-acid battery has an A-hr rating of 180 A-hr. The battery is to be load-tested. What should be the test current, and what are the maximum permissible amount and duration of the voltage drop?
For solar cell the Open Circuit Voltage (Voc) occurs when O a. voltage is minimium f O b. voltage is zero ion O C. current is maximium O d. current is zero page
Nichrome ribbon resistor elements each has a resistance of 1 ohm. The element is made from sheet of nichrome alloy, 0.025 cm thick. If the width of the ribbon is 0.3 cm, what length is required per element? [centimeters, 1 decimal place]
PS1 (1) Determine the voltage and current meter indications in each circuit. R6 .3kOhm R5 .7kOhm T D7 IN4001GP Use Si diodes D3 XM15 D4 D2 X2014 X2017 R4 22.7kOhm R2 m 2.2kOhm D6 D5 X0013 X2016 XINIU VT -20 V R3 SkOhm R1 3kOhm x2011 X2018 2012 D1 X019 :: ...
Solev this question it has 4 parts confusing me alot and X=167 and in part c there's a bit tricky with X by providing a condition so please check
Determine the following
1. Please respond to question in attached image. Thank you.
1. Answer
Four cells each of 2.10 volt internal emf are parallel connected together to make a battery. The internal resistances are 0.004, 0.005, 0.003 and 0.0025 ohm. Calculate for parallel connections: (a) internal emf and resistance of the single equivalent cell (b) current for a terminal voltage of 1.95 volts, (c)current in each cell
An ammeter has been designed by indirect method with current ranges 1A, and 5A, if PMMC meter have internal resistance of 50 (2 and half scale current of 0.5 mA. Ra and Rb will be --- ohm Ra= 0.05005 , Rb=0.01001 Ra = 0.04004 , Rb = 0.01001 Ra= 0.05005 Rb= 0.04004
A resistor has a resistance of 20 ohms at 30 degrees Celsius and 32 ohms at 90 degrees Celsius. Find its resistance at 125 degrees Celsius. Determine also the temperature coefficient at 100 degrees Celsius. (Please Show Complete solution and write properly) (Round off the final answer to the 4th decimal if possible and box the final answer)
What are some of the reasons that some (perhaps all) of your readings do not match the calculated values? Electrochemical Cell 1. Observed Voltage: +0.859 V, Calculated Eo for cell: 1.1 V Electrochemical Cell 2. Observed Voltage: -0.379 V, Calculated Eo for cell: -0.47 Electrochemical Cell 3. Observed Voltage: +0.031 V, Calculated Eo for cell: -0.31 V Electrochemical Cell 4. Observed Voltage: +0.200 V, Calculated Eo for the cell: +0.19 V