QUESTION 8 The 3 eastbound lanes of a rural freeway segment have 11 ft lane widths. There is a 3 ft lateral clearance on the right side of the road. There are no ramps within the influence area. What is the estimated FFS (mph)? Provide your answer to the nearest tenths.

QUESTION 8 The 3 eastbound lanes of a rural freeway segment have 11 ft lane widths. There is a 3 ft lateral clearance on the right side of the road. There are no ramps within the influence area. What is the estimated FFS (mph)? Provide your answer to the nearest tenths.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: What is the safe stopping distance for a section of rural freeway with a design speed of 80 mi/h and…

Q: ON 6 An old 6-lane (3 lanes each direction) rural freeway segment has 11 ft lanes and frequent…

A: Free flow speed (FFS): FFS = BFFS - fLW- fLC- fN- fID Where: Base free flow speed for rural freeway…

Q: If the weaving configuration below has four lanes and 2000 feet between the ramps, propose the…

A: Lanes = 4 Ramp Distance = 2000 ft PHF = 0.92 trucks = 10 % FFS = 65 mph Lane capacity = 2350 pcph…

Q: A two-lane highway along the border has a horizontal curve segment with radius of 656 ft (measured…

Q: QUESTION 2 An intersection has a speed limit of 35 mph and the intersection is 33 ft wide. Our…

Q: A freeway is being designed to carry a heavy volume of 5000 veh / h on a regular weekday in rolling…

A: Given data:- The freeway is designed to carry a heavy volume of, 5000 veh/h The given PHF is, 0.9…

Q: A four-lane urban freeway segment has a peak demand volume of 3,500 vehicles per hour for the two…

A: Freeway:Freeway is a roadway without any signals or intersections. A freeway does not have any…

Q: Determine the adjustment factor

Q: The 3 eastbound lanes of a rural freeway segment have 11 ft lane widths. There is a 3 ft lateral…

A: Lanes:The lanes are the part of the roadways which determines the direction of the roadway. The…

Q: FFS on Freeway Given: Six-lane urban freeway (3 in each direction) Lane width = 11 ft Right-side…

Q: determine the maximum number of large trucks and buses that can be prersent in the peak hour traffic…

Q: A one lane loop ramp at the northwest quadrant of an interchange, this loop ramp is for northbound…

A: Given- Friction factor f=0.095, Design speed V=35 mph, Radius R=545 ft,

Q: A six-lane freeway (three lanes in each direction has regular weekday users and currently operat at…

A: Given:- peak hour factor=0.90 wide=11ft right side shoulder=4ft wide To find:- hourly volume

Q: A freeway section is estimated to carry an annual average daily traffic (AADT) of 40,000 vehicles…

A: Annual average daily traffic, AADT = 40,000 veh / day Directional factor , D = 0.6 , DDHV = 2640 veh…

Q: A westbound section of freeway currently has three 12-ft wide lanes, a 6-ft right shoulder, and no…

A: LOS: LOS is referred to as the Level of Service in Highway. It explains the quality of the traffic…

Q: If a four legged roundabout has 8 conflict points, how many does a 3 legged roundabout?

A: Roundabout is circular intersection which allows slow and safe traffic flow around the central…

Q: As SR361 enters Middletown from the NW, it must curve to the south between two historic buildings.…

A: Given:Design speed (V) = 60 mph = 88 ft/sSuperelevation rate (e) = 0.06 inches per inch = 0.06/12 =…

Q: Evaluate the level of service (LOS) on a selected section of class I two-lane highway segment with…

Q: A segment of rural freeway is being designed for a FFS of 65 mph using 11 ft lanes in a mountainous…

A: The given data is shown below:

Q: A 2-lane highway has lane widths of 9ft (2.75 m), with 6ft (1.83 m) clear hard shoulders. There are…

A: The quality of traffic service is related to the flow rate using the concept known as level of…

Q: A segment of rural freeway is being designed for a FFS of 65 mph using 11 ft lanes in a mountainous…

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1: Introduction

VIEW

Step 2: Calculation of Free Flow Speed

VIEW

Step 3: Final Answer

VIEW

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

Problem 3: Highway segment is going under planning review. Given the following facts: Lane Width = 3.4 m Number of Lanes (N) - 2 (in cach direction) Total Lateral Clearance = 3.0 m Median No Median The 85th % Speed was found to be 100 km/hr (i.e. BFFS = 100 km/hr) PHF - 0.83 Terrain Type: Rolling You are asked to: A. Determine the maximum peak-hour volume that the segment can serve at a LOS C. B. Make suggestions on how to increase the total capacity while maintaining the LOS at C without major investments.
A new basic freeway segment will have 3 lanes in each direction. The left and center lane each has a width of 12 ft while the width of the right lane is 13 ft. The left shoulder is 4 ft while the right shoulder is also 4 ft. There are 2 interchanges within 6 miles (3 miles upstream and 3 miles down stream).The site has level terrain, the design speed is 80 mph the hourly design volume is 5250 veh/h, which includes 9.0% trucks and buses. The peak hour factor is 0.870. Calculate FHV, VP, FFS, LOS Show all work
i need correct solution asap in 20 mins
Problem 2. Consider a freeway section with three lanes in each direction and with a length of 1.25mi (2km) and a +5% grade. In this freeway, the directional peak-hour volume is 3,800 veh/h, from which 76 are trucks and 152 are transit buses. The maximum 15-min volume within the hour of analysis is 1,055 vehicles. The lane widths are 12 ft (3.6m), and shoulder widths are 10 ft (3.1m). There are 2 exit ramps and 1 entrance ramp in the 3 miles in the upstream section and 1 exit ramp and 2 entrance ramp in the 3 miles in the downstream section (consider the same ramp density if using international (km) units). All transit buses will be removed from traffic since the transit service will be replaced by a commuter rail service. However, by removing buses, new additional passage car demand is expected. It is estimated that for each removed bus, 7 new passenger cars will be added to the original traffic volume of 3,800 veh/h. Question: Determine the change in speed and traffic density before…
QUESTION 7 The 4 northbound lanes of a rural freeway segment have 13 ft lane widths. There is no lateral clearance afforded on either side of the road. There are no ramps within the area of influence. What is the estimated FFS (mph)? Provide your answer to the nearest tenths.
A class IIl two lane highway in rolling terrain services a small built-up area. It has a base free flow speed of 50 mph., the highway has 11 foot lanes and 4 foot clear shoulders on both sides. There are 12 access points/mile, and 85% no passing zones. Current traffic is 525 vehicles per hour, with 12% trucks, 3% RVs, and a PHF of 0.89. The directional distribution is 60-40. What LOS is expected on this facility?
An old 6-lane (3 lanes each direction) rural freeway segment has 11 ft lanes and frequent roadside obstructions located 10 ft from the right edge of the pavement. What is the estimated FFS (mph) for the 3 northbound lanes? Provide the answer to the nearest tenths.
A four-lane freeway with 12 ft lanes and 5 shoulders is on a 2% grade for the 1.25-mi analysis stretch. There are 2 ramps in this section. If the traffic mix is generally 6% heavy vehicles with a 70/30 SUT/TT split and a PHF of 0.8, how many vehicles can the freeway carry in the peak hour without dropping below Level of Surface (LOS) C?
A segment of rural freeway is being designed for a FFS of 65 mph using 11 ft lanes in a mountainous area. The lateral clearance is nominal (1 ft). The directional (i.e. one-way) design flow rate is expected to be 2,400 passenger cars per hour. How many lanes in one direction will be needed to provide at least a LOS B? Response Feedback: When FFS=65 mph and flow rate=2400 pcphpl the density=36.9 pcpmpl which translates to a LOS E. When FFS=65 mph and flow rate=1200 pcphpl the density=18.5 pcpmpl which translates to LOS C. When FFS-65 mph and flow rate=800 pcphpl the density=12.3 pcpmpl which translates to LOS B.
The 4 northbound lanes of a rural freeway segment have 13 ft lane widths. There is no lateral clearance afforded on either side of the road. There are no ramps within the area of influence. What is the estimated FFS (mph)? Provide your answer to the nearest tenths. Response Feedback: The BFFS of 75.4 mph is adjusted by 1.2 mph for the lack of lateral clearance.
Transportation Engineering
Note: Don't copy from other experts solution. Please do it your own.. Make sure your calculations clearly.