Question 3Problem 2 (a):Two loads are connected in parallel across a 120 V rms, 60 Hz single-phase supply.Load 1: 5 KVA at 0.4 power factor (lagging)Load 2: inductive load, 6 kVA, and 5 kWVrsm=120 VLoad #1Problem 2 (b):|S₁|= 5 kVAPf₁= 0.4 laggingLoad #2(inductive load)|S₂| = 6 KVAP₂= 5 kWa) Determine the total load in apparent power (Stotall) in KVAQuestion 4Two loads are connected in parallel across a 120 V rms, 60 Hz single-phase supply.Load 1: 5 kVA at 0.4 power factor (lagging)Load 2: inductive load, 6 kVA, and 5 kWb) Determine the power factor of the total load.

Answered: Image /qna-images/answer/d72276ba-8166-4ddc-a8f4-2f9f2b145c89.jpg

Answered: Problem 2 (a): Two loads are connected…

Problem 2 (a): Two loads are connected in parallel across a 120 V rms, 60 Hz single-phase supply. Load 1: 5 kVA at 0.4 power factor (lagging) Load 2: inductive load, 6 kVA, and 5 kW

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: ductive or tor of the ower cons consume

A: Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: Three phase power supply load R is 1699 VA, S is 15584 VA and T is 12818 VA. Find (a) the…

Q: 1. What is the main direct cause of reactive power in AC system? A. Resistance of transmission lines…

Q: Two power system areas operating at a nominal frequency of 60 Hz are connected with a tie line, and…

A: Step-1->

Q: Q2/A/ The 2MW load operating with 0.8 lagging power factor. To improve the power factor to 0.95 a…

Q: A three-phase alternator generating unbalanced voltages is connected to an unbalanced load through a…

Q: There are two loads connected in parallel and powered from a 7200-V source. The first load is 50-kVA…

Q: For a 3 phase 975 KVA generator.... if the voltage rating is 2400V what is the current rating at…

A: The power factor is calculated as follows, From figure the general formula for power factor is,…

Q: Why the efficiency is same in both questions of single phase half wave the first is R load and the…

A: Here asking about the efficiency of the single phase half wave rectifier with R load, single phase…

Q: Three single phase loads are connected to the 400 V, three phase lines, 60 Hz. Load 1 operating at 3…

Q: When a generator fails, its power output is lost, and the result is an imbalance between total load…

Q: A tree-phase generator has a load 100 kw per phase at a power factor 80 percent,lagging what is the…

A: The active power consumed by a 3ϕ load is equal to the sum of active power consumed by each load.…

Q: Given: 1. 2 wye-connected loads per phase to a 3 phase power source 2. first load consists of a…

Q: Problem 4: A three phase motor draws 30 kVA at 0.80 power factor lagging from a 480 V three phase…

A: The data are given as KVA ratingS1=30kVA,Power factorpf1=cosϕ1=0.8 laggingso, ϕ1=36.87°.1) Without…

Q: Three single-phase transformers are connected into a three-phase bank. The primary is connected as a…

A: In this question we need to find a phase voltage of primary.

Q: If a load is leading, which statement is NOT true? a. The load is capacitive. b. It’s reactive…

A: We are given a MCQ and we need to select the correct option out of four given option.

Q: single phase circuit has an apparent power of 5 kVA and a reactive power of 4 kVAr. Then find (i)…

A: We need to find out power factor and active power and resistor for given apparent power

Q: j 20 ll a b 100/20° V -j 5 2 Figure 04 Q4. (a) Find the Thevenin equivalent circuit looking from the…

A: "Since you have asked multiple question , we will solve the first question for you if you want any…

Q: low voltage systems In the reverse phase, a 1000 kw powerful load under 0.5 power factor is fed…

Q: resistance of 20 Ω, an inductance of 0.2H and a capacitance of 100μF are connected in series across…

A: In this question , series RLC circuit is given....We have to find out impedance , current , voltage…

Q: There is an installation with two identical three-phase motors, 50 HP each and a power factor of 0.9…

A: Given: There is an installation with two identical three-phase motors, 50 HP each and a power factor…

Q: A three – phase load of 2.0 MW with P.F of 0.8 lead is connected to a 12.46 kV grid. Find the…

Q: A three phase load has a rating of 200 KW, 4000 volts, 0.7 power factor lagging and a frequency of…

A: The solution can be achieved as follows.

Q: In class B chopper, which of the given statement is true The power flows always from load to source…

A: The power flows always from load to source

Q: 6. Determine the peak and average power delivered to RL in figure. 2:1 RL 220 N 120 V rms alll lelll

A: In this question, We need to determine the peak voltage Across the load and average power P? We…

Q: The actual impedance of a load is 30 OHM. The per-unit impedance of the load is 0.5 pu when Base…

A: In this answer let us try to find the base power used in order to get the given per unit impedance…

Q: A 415 V, 56 Hz 3-phase supply is connected to a 3-phase star connected balanced R-L load each of…

A: To find the value of inductance L in each phase

Q: A 11 KV source is connected to a 12 MVA load with a 0.83 lagging power factor. How much capacitive…

Q: Three single phase loads are connected to the 400 V, three phase lines, 60 Hz. Load 1 operating at 3…

A: “Since you have posted a question with multiple sub-parts, we will solve first three subparts for…

Q: A three-phase 400 V, 60 Hz delta connected load has three equal impedances each of (10+j50) 2. What…

A: Given, A three phase 400 V, 60 Hz delta connected load has, Three equal impedances, Z=10+j50 Ω.…

Q: An electrodynamometer type wattmeter is used to measure power in 1-o circuit. The connected load…

A: The solution is given below

Q: A motor is connected to a 240volt, three phase line. The true power of the motor is 2793Watts. The…

A: Line voltage is given VL=240 V Current drawn is given, IL=12 A Apparent power is given by,…

Q: Two 300-VA parallel-connected transformers can supply a maximum load of a. 150 VA b. 300 VA C. 450…

A: Two 300 VA parallel connected transformer can supply a maximum load of, equal to the sum of their…

Q: 7. Two 440V, 60Hz, 6 pole, 30 AC generators are running in parallel. The first supplies the busbars…

A: It refers to the connection of multiple generators in a way to supply a common load. This…

Q: Three load units A, B and C are connected in parallel and take currents that are respectively 12, 10…

A: In this question, 3 loads are connected in parallel then find the total current IT ? If Three…

Q: -Calculate and draw the load current for the first two-period interval b-Calculate and draw the…

A: Rectifier: Because nearly every electrical appliance runs on DC (Direct Current), the rectifier…

Q: If a A-connected load has a balanced impedance ZA 94 -17° 2 and a voltage = Z VBC = 265 / 82° V rms,…

A: The 3-phase system,The impedence,The voltage,

Q: What is the KW rating of a three phase 975 KVA generator at A) unity power factor B) 80% power…

Q: The apparent power in a three-phase balanced circuit is 150 VA, and the active power is 100 W. What…

A: Given, Apparent power, S=150 VA Active power, P=100 W

Q: A single – phase load of 96 kW with PF of 0.6 lag is connected to a 4.16 kV single – phase network.…

A: In this question, we need to determine the magnitude of current of this load in ampere. We know,…

Q: + 120/45° V rms B

Q: 1. A 440 V, 60 Hz generator supplies two parallel-connected loads A and B,. Load A draws an apparent…

A: Total apparent power supplied is simply the algebric sum of the individual apparent powers Here add…

Concept explainers

Single Phase AC Circuit

Alternating Current (AC) is a type of electric power in which the electric current changes, both in magnitude and direction, at regular intervals. This AC Circuits can deliver power in either a Single Phase system or a Three Phase system.

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Analysis of Single Phase and Three Phase System

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A three – phase load with 1.8 1.7 MVA and 0.92 0.85 leading power factor is connected to a 13.47 kV grid. What is the magnitude of the current of this load in Ampere?
Three loads are connected in parallel to a 240-V, 60 Hz supply. Load 1 is composed of three 600-W heaters, Load 2 is a 3 HP, inductive motor with an efficiency of 90% and a p.f. of 0.88, while Load 3 has an impedance of 12-j16 ohms. Determine the following: a) The apparent power of each load b) The Total Power, Total Reactive Power, Total Apparent Power, Power Factor c) The source current
If the load is connected to the generator thgrough an inductive line and the voltage at the load side is the same as the voltage at the terminals of the generator, which of the following must be true? O A. The reactive power is flowing from the generator to the load and from load to the generator at the same time. O B. The load is disconnected, and no power is delivered to the load. O C. The load has a poor power factor and it's absorbing too much reactive power. O D. None of the other choices are correct O E. The generator is unable to produce reactive power; therefore, the reactive power is flowing from the load to the generator.
A 415 V, 55 Hz 3-phase supply is connected to a 3- phase star connected balanced R-L load each of resistance 14 ohm and impedance 82 ohm. Find the value of inductance in each phase. 41.00 80.80 0.23 8.25
A 415 V, 58 Hz 3-phase supply is connected to a 3-phase star connected balanced R-L load each of resistance 17 ohm and impedance 81 ohm. Find the value of inductance in each phase. O 8.00 79.20 O 40.50 O 0.22
A load has a leading power factor. a) Is it a capacitive or inductive load? b) Is the reactive power positive or negative? c) Repeat for a load with lagging power factor
A three-phase alternator generating unbalanced voltages is connected to an unbalanced load through a 3-phase transmission line as shown in figure. The neutral of the alternator and the star point of the load are solidly grounded. The phase voltages of the alternator are Ea = 1020º, Eb = 102-90°, Ec = 10/120⁰ E E E The positive sequence component of the load current is (A) 1.3102-107⁰ A (B) 0.3322-120° A (C) 0.9962-120º A (D) 3.5104-81⁰ A +) + j1.002 0000 j1.002 0000 j1.0Ω vovo j1.0Ω 0000 j2.002 voor j3.002 oooo
In three phase power meassurement, current coil is connected in series and potential coil is connected parallel to the load. Select one: True False
In 3-phase balanced delta connected system, the voltage induced in each coil is called
A 440 V, 60 Hz generatorsuppliestwo parallel-connected loads A and B,. LoadA draws an apparent power of 100 KVA at 0.8 pf lagging and load B draws anapparent power of 70 KVA at unity pf. Determine the KVA supplied by the generator.
1- Your example deduced the total strength of the following three loads: the first load 1200VA at a power factor of 0.7 late, the second load 350VA at a power factor of 0.5 was late, and the third load 3275VA at a power factor of 1.0.
Q4 a) A three-phase system has a rms phase voltage of 6.3 kV. What is the line voltage?