QUESTION 1 "The gage pressure in a pipe is measured by a manometer containing mercury (density: 13,600 kg/m^3). The top of the mercury is open to the atmosphere and the atmospheric pressure is 105 kPa. If the mercury column height is 24 cm, the gage pressure (in kPa) in the pipe is ?" 32.03 QUESTION 2 "The pressure in seawater where a submarine is sailing is measured to be 1400 kPa (absolute pressure). The submarine is in a water depth of (in meters, take the density of water to be 1050 kg/m^3 and the atmosphere pressure at 105 kPa.) ?" QUESTION 3 "The atmospheric pressure in a location is measured by a mercury (density: 13,600 kg/m^3) barometer. If the height of mercury column is 770 mm, the atmospheric pressure (in kPa) at that location is ?"

QUESTION 1 "The gage pressure in a pipe is measured by a manometer containing mercury (density: 13,600 kg/m^3). The top of the mercury is open to the atmosphere and the atmospheric pressure is 105 kPa. If the mercury column height is 24 cm, the gage pressure (in kPa) in the pipe is ?" 32.03 QUESTION 2 "The pressure in seawater where a submarine is sailing is measured to be 1400 kPa (absolute pressure). The submarine is in a water depth of (in meters, take the density of water to be 1050 kg/m^3 and the atmosphere pressure at 105 kPa.) ?" QUESTION 3 "The atmospheric pressure in a location is measured by a mercury (density: 13,600 kg/m^3) barometer. If the height of mercury column is 770 mm, the atmospheric pressure (in kPa) at that location is ?"

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: Q3: A U-tube containing mercury is used to measure the pressure of an oil of specific gravity 0.82…

Q: A one-third scale model of an airplane is to be tested in water. The airplane has a velocity of 900…

Q: Find the differential mercury manometer gauge reading shown in the given figure if the pressure…

Q: 2. Both a gage and a manometer are attached to a gas tank to measure its pressure. If the reading on…

Q: -The cross-sectional area of one limb of a U-tube manometer is made 500 times larger than the other…

Q: An air-filled, hemispherical shell is attached to the ocean floor at a depth of 9.1 m as shown in…

Q: Consider oil flowing through a horizontal pipe at a rate of 3 liter/s. There are two sections of the…

Q: 6. A differential manometer is attached to a pipe, as shown in figure below. Calculate the pressure…

Q: Oil 45 kPa SG = 0.72 75 cm Air Water 30 cm -Mercury SG = 13.6

Q: A differential U-tube manometer is used to measure the change in pressure between two points in a…

Q: If the gauge pressure and atmospheric pressure at a point are observed as 70 mm of mercury and 750…

A: Absolute Pressure = Gauge Pressure +Atmospheric pressure =70+750= 820 mm of mercury Absolute…

Q: A manometer is connected to a water pipe as shown in the figure below. There are three liquids in…

Q: Question- A pressure gauge reads 62.3 kPa and 90 kPa respectively at heights of 7 m and 4 m fitted…

A: Pressure gauge readings at 7 m & 4 m are 62.3 kPa & 90 kPa as shown below- To Find- The…

Q: PROBLEM 10: For the manometers shown, Determine the 18 in difference in pressure between A and B in…

Q: Meriam red oil, SG=0.827 P2.32 Water A 18 cm H 35 cm B Mercury

A: Given data:- The PB-PA=89.5 kPa=89500 Pa The specific weight of water is, Wwater=9790 N/m3 The…

Q: A mercury manometer used for measuring pressure difference indicates 50 cm head of Hg. This pressure…

A: Given- Pressure difference=50 cm head of Hg, Pressure difference in meters of water is required.

Q: Manometer with three liquids as shown. SGs are given. Calculate gauge pressure for oil. 20 KPa Water…

A: Given, to determine, Gauge pressure for oil.

Q: If the pressure (in psi) measured at the center of the pipe (+) is 0.12 psi, what should be the…

Q: 1. The pressure in an automobile tire depends on the temperature of the air in the tire air…

Q: An organic solvent (SG=0.86) flows up in a pipe as shown in the figure. A manometer filled with…

Q: A tank contains gasoline and glycerine with open piezometer tubes attached as shown. The depths of…

Q: Question 1 5 Marks The air-oil-water system shown below is at 21°C. Gauge A reads 11 kPa and gauge B…

Q: Question 3:-A tank with 100.58 kPa pressure is connected with manometer to measure the pressure. The…

Q: Consider oil flowing through a horizontal pipe at a rate of 3 liter/s. There are two sections of the…

Q: (5) As shown in the image, an air space above a long tube is pressurized to 50 kPa vacuum. Water…

A: Given Initial Pressure in air space=50 kpa Final Pressure in air space=25 kpa Assume Atmospheric…

Q: -oil(sg.30.85) 680 mm 1700mm water

Q: Q2:- Calculate the absolute pressure at point B as shown in fig.(2). Neglect the density of air (25…

Q: Question 3:- A tank with 100.58 kPa pressure is connected with manometer to measure the pressure.…

Q: Determine the height h in m of substance X in the manometer. The height of the water is hw = 0.35 m.…

Q: -Oil SG 0.79 P = 260 kPa gage Gasoline SG = 0.70 Pipe Air- 45 cm 50 cm 22 cm 10 cm Water Mercury SG…

Q: Aceite 65 kPa SG = 0.72 75 cm Aire Ageua 30 cm -Mercurio h frgua SG = 13.6

Q: See the sketch below from our textbook (not to scale!), where the liquid in the open-top tank and…

Q: a manometer is a device that measures pressure. a common simple manometer consists of a U shaped…

Concept explainers

Unit Conversion

Standard units are also called SI units. SI units are used for measuring a physical quantity satisfying certain conditions. There are two types of units: fundamental units and derived units. Fundamental units are physical quantities that are independent, that is, they do not depend on other quantities like mass, length, or time. There are plenty of quantities in our lives which need to be measured and compared. Measuring is the comparison of a particular physical quantity with its reference value. A unit is a measure of a fixed physical quantity. A physical quantity is the product of a unit and the numerical value we need to compare with.

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Question 1: Introduction

VIEW

Question 1: Calculation

VIEW

Question 2: Introduction

VIEW

Question 2: Calculation

VIEW

Question 3: Introduction

VIEW

Question 3: Calculation

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 6 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

Consider oil flowing through a horizontal pipe at a rate of 3 liter/s. There are two sections of the pipe with diameters 10 cm and 7 cm and the two sections are connected by a smooth reducing section as shown in the schematic. We use a manometer with glycerin as the manometer fluid (with glycerin density of Pglycerin 1,260 kg/m³) to measure the pressure difference between the two pipe sections. Assume that frictional effects are negligible and consider specific gravity of oil as SGoil = 0.76. What is the manometer reading, h (i.e. differential height of glycerin between the two arms of the manometer)? 10 cm I h T 7 cm-
I need the answer as soon as possible
As shown in the figure, determine the gage pressure on the bottom of the tank in kPa. Considering the total gage pressure at the bottom of the tank what will be the absolute pressure if the barometric pressure if 725 torr?
The pressure drop of water in a pipe is measured by a manometer using a liquid of density 2000 kg/m³. The difference in height of the liquid in the limbs is 10 cm. Then, the pressure drop is
Question 3:- A tank with 100.58 kPa pressure is connected with manometer to measure the pressure. The specific gravity of fluid was 0.85 and the atmospheric pressure is 96 kPa find the manometer column height "h". Pam = 96 kPa P=100.58 kPa h=? SG = 0.85
1. The reading of an automobile fuel gage is proportional to the gage pressure at the bottom of the tank. The tank is A deep and is contaminated with B of water. The specific volume of gasoline is 0.00147076 m /kg and that of air is 0.0008313 m³/kg. Unit weight of water is 9790 N/m3 a. Determine the gage reading when the tank is full of gasoline b. How many cm of air remains at the top when the gage indicates full if the tank is A deep and is contaminated with B of water. c. Determine the pressure at the interface of the gasoline and water when the gage indicates full A = First name in inches Vent B = A/10 in inches Air h A Gasoline Pgage Water B
3. Situation 1 - The pressure on a closed tank reads 58.86 kPa. What is the equivalent height, in meters, in terms of mercury? Round off to three decimal places.
Consider oil flowing through a horizontal pipe at a rate of 3 liter/s. There are two sections of the pipe with diameters 10 cm and 7 cm and the two sections are connected by a smooth reducing section as shown in the schematic. We use a manometer with glycerin as the manometer fluid (with glycerin density of Pglycerin 1,260 kg/m³) to measure the pressure difference between the two pipe sections. Assume that frictional effects are negligible and consider specific gravity of oil as SGoil = 0.76. What is the manometer reading, h (i.e. differential height of glycerin between the two arms of the manometer)? 10 cm I h T 7 cm-
A pressure gage 13.31 m. above the bottom of a tank containing a liquid reads 58.93 kPa; another gage at height 2.54 m. reads 82.68 kPa. Determine the density of the liquid. Round off to three decimal places.
If your blood pressure is measured as 119 mm Hg (i.e., mercury column height), what is the corresponding absolute pressure in kPa? O 85.2 kPa O 117.3 kPa O 16.0 kPa O 101.3 kPa
The figure below shows a manometer connected to a pipeline containing oil of specific gravity 0.8. If the specific gravity of mercury is 13.6, the pressure head of oil in terms of height of the water will be: Oil Mercury 0.75 m 0.25m
A pressure gage 10.52 m. above the bottom of a tank containing a liquid reads 58.5 kPa; another gage at height 3.16 m. reads 85.83 kPa. Determine the density of the liquid. Round off to three decimal places.