Q4, bend. When the gauge pressure is E psi, F = 2000 lb to hold the bend in place. Determine a) the flowrate and b) F, anchoring force required to hold the bend in place. 9: Water discharges into the atmosphere after flowing through the below horizontal Note that the flow is not inviscid. Please find the value of the gauge pressure reading E from Table 1 at the end of the questions. The density of water is 1.94 slugs/ft. E Psi Bend Q=?- Fe = 2000lb Water Area= 0.3Pt? 145° Area= 0.1f+²

Q: A brand of toothpaste is made using a mixture of white and red paste. During the manufacturing…

A:

Q: Figure shows a pipe system. At the entrance to the pipe (point 1), the diameter is d₁ and it is a…

A: Given: p1 =ϕ1

Q: A brand of toothpaste is made using a mixture of white and red paste. During the manufacturing…

A:

Q: 10. A 20-in³ sample of oil is compressed in a cylinder until its pressure is increased from 50 to…

A:

Q: Consider a business jet, like the Gulfstream G550, flying at a standard altitude of 30,000 and V1 =…

A: "from properties of atmosphere at high altitude" at 30000 ft , the density will be ,  ρ=0.02866 lbm…

Q: du Water flows past a flat plate that has a length L = 5 m and a width w = 2 m, as shown in Figure…

A: Given Data: Water flows past a flat plate  Plate Length L=5 m Plate Width w=2 m shear stress at the…

Q: From pump 1.0 m 1.5 m a. Using a vertical bar chart, plot the pressure drop (i.e. P₁-P₂) for these…

A:

Q: Problem 3. Outcome 5. Please show all work. Air at standard pressure but with T = 50°C flows through…

A:

Q: 4. A formula for estimating the volume rate of flow, Q. over the spillway of a dam is Q=C √2g B…

A:

Q: The branching of a blood vessel is shown. Blood at a pressure of 100mg Hg (13.3kPa) flows in the…

A: Solution:

Q: The water of a 14’ × 48’ metal frame pool can drain from the pool through an opening at the side of…

A: Given:Size of the pool, =14 ft×48 ftPosition of the opening below the water level, h=1.05 mCapacity…

Q: Crude oil flows at the same rate out of each branch of the wye fitting. (Figure 1) B 20 mm 45% A 45…

A:

Q: 4. As depicted in the figure, water at 20 C flows through a pipe bend and exits as an open jet.…

A:

Q: A brand of toothpaste is made using a mixture of white and red paste. During the manufacturing…

A:

Q: Q1: Water is flowing from tank A to tank B as shown in the following figure. The flow is steady so…

A: To findFind out the distance..given Height, Diameter, diameter,

Free undamped vibrations

Whenever an object/system displaces in either side of its equilibrium position with the help of an external/internal means, then the object/system moves regularly or randomly on both sides of its equilibrium position. This motion is called vibration. Generally, there are three types of vibration: longitudinal vibration, transverse vibration, and torsional vibration.