Q3: Tikrit University has been implemented a project of an electrical portable station. This project includes installing two towers cach of them has a hight of 39 m to cary the overhead transmission line from outside to inside the University. And the distance between the towers is 300 m. But, the transmission line flow-through a ground has a gradient (slope) of 1/15. After calculating the sag, find the distance (clearance) between the orginal point and the ground. The tensile strength in the wire is 2500 N/cm2. The weight of one meter of the conductor is 9 N. The cross-section area of the conductor is 4 cm2.

Q3: Tikrit University has been implemented a project of an electrical portable station. This project includes installing two towers cach of them has a hight of 39 m to cary the overhead transmission line from outside to inside the University. And the distance between the towers is 300 m. But, the transmission line flow-through a ground has a gradient (slope) of 1/15. After calculating the sag, find the distance (clearance) between the orginal point and the ground. The tensile strength in the wire is 2500 N/cm2. The weight of one meter of the conductor is 9 N. The cross-section area of the conductor is 4 cm2.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

"In medium transmission line modeling, which of the parameter is considered to be lumped?" Resistance Inductance Capacitance All options are correct
one circuit of a sinlge phase transmission line is composed of three solid 0.5 cm radius wires. the return circuit is the composed of two solid 2.5 cm radius wire . the arrangement of conductors is as shwon in figure below. applying the concept of GMD and GMR , find the inductance of the complete line in millihenry per kilometer
The following figure illustrates the configuration of a two-bundle and completely transposed transmission line system operating at 50 Hz. The transmission line length is 100 km, and each bundle consists of conductors with a diameter of 6.0 mm. The resistance of each bundle is 0.12 22 per kilometer. Answer the following questions. a) The inductance in H/m for each phase of the transmission line. b) The total inductive reactance in 2 for each phase of the transmission line. c) The capacitance in F/m for each phase of the transmission line. d) The total capacitive reactance in 92 for each phase of the transmission line. e) Sketch the nominal- circuit of the line 3m 3m 0.06 m 8m
Consider a scenario with 2 different Tx lines of length 45 km and 90 km connected at a common bus transmitting energy from two different sources to a centralize load centre containing industrial and residential load as shown in the figure below. TL 1 Wind Power System Vsi ??? Load Centre TL 2 Thermal Power Station VS2 TL 1: Delivers 4000 kW at 30 kV with 0-8 p.f. lagging. Here, the line parameters concentrated or lumped instead of being distributed. The total resistance, inductive and capacitive reactance of line is 60, 8 Q and 2 2 respectively. TL 2: Delivering 10,000 KW at 0.8 p.f lagging with the receiving end voltage of 66kV. Considering Resistance, Inductances are lumped and capacitance is concentrated at the load end. The total resistance, inductive and suseptence of line is25 2, 802 and 14x10a1 respectively. Model the respective transmission lines and calculate i. Sending end voltages ii. Transmission efficiency iii. Voltage regulation Note: Use the Phasor diagram where it is…
The capacitance between the line to neutral of a three-phase 50 Hz, 66KV overhead line conductors with horizontal configuration is 8.5 x 10- Farad/ph/m. Then the line to line capacitive reactance in 2/km is ..
d) Calculate the per unit voltage drop on the transmission line e) Calculate also the sending end voltage Use an overall base of 100 MVA.
A single circuit 60 Hz transmission line. the conductors are Linnet type with flat horizontal spacing of 17.46 feet between conductors. Determine: (a) Assume that the line is short with a length of 50 miles, calculate the parameters of the line and draw the equivalent circuit. (b) Assume that the line is average with length of 150 miles (Pi-nominal model). draw the pi-nominal circuit for the transmission line and calculate its parameters (Z and Y/2 values, where Z is the series impedance of the transmission line and Y is the shunt admittance).
Compute up to 4 decimal places but only encode your final answers with only 3 decimal digits
1. The transmission system has two types; 2. For the extra high voltage transmission 3. ACSR stands for and and are usually used, 4. In case of the unsymmetrical spacing, the line is transposed in symmetrical spacing, the line is transposed in 5. Main components of a transmission line are ..... .. times, where in the times. ...... ..... and
b) Ghana Grid Company (GRIDCo) designed a short transmission line using the A, B, C, D line constant of a transmission line parameters in its analysis. The engineering planning department came up with the design and said that when they computed the line performance using the equation AD – BC the answer was equal to 1.As an employee at the Ministry of Energy (MoEn) having oversight responsibility over GRIDCo, how would you accept the answer and recommend the Government of Ghana (GoG) to go ahead to implement the short transmission line?
1. Following are types of Transmission Lines EXCEPT A. Medium Line B. Long Line C. Capavitive Line D. Short Line 2. What is the theory used to express the voltage and current relations? A. Per-Phase B. Equavalent Transmission Line Model C. Two Ports Network 3. A 300km transmission line is considered as A. Long Line B. Medium Line C. Short Line 4. For a short transmission line, values for element A B C and D are A. A=1, B=0, C=Z, D=1 B. A=1, B=Z, C=0, D=1 C. A=0, B=Z, C=1, D=1
please help solve this question A 100 km Three-Phase 50 Hz transposed transmission line is composed of bundle of three ACSR, 1,431,000 cmil, 47/7 Bobolink conductors as shown in Figure 2 (a). The Three-Phases (bundled Conductors) have flat horizontal spacing of 11 meters as shown in the Figure 2(a). The conductors have a diameter of 3.8 cm and a GMR of 1.5 cm. The Line is going to be replaced with a six conductor bundle of ACSR, 477,000 cmil, 26/7 Hawk conductors. The conductors have a diameter of 2.5 cm and a GMR of 0.9 cm. The new line will have a horisontal phase spacing of 14 meters as it is going to be operated at higher Voltage rating. The new line is shown in Figure 2 (b). The spacing between the bundles in Figure 2 (a) and (b) is 45 cm. Determine,a) The capacitance for each case and the percentage change in capacitanceb) The inductive reactance for each line and the percentage change.c) The inductance for each case and the percentage change ininductance