Q3:Multiple Choice Questions:1. An ideal operational amplifier hasA. zero input impedanceC. infinite bandwidthB. infinite output impedanceD. All2. If ground is applied to the (+) terminal of an inverting op-amp, the (-) terminal willB. be virtual groundD. not invert the signal3. A non-inverting closed-loop op-amp circuit generally has a gain factor:A. greater than oneB. less than oneC. of zeroD. equal to oneA. not need an input resistorC. have high reverse current4. Ideal op-amp has infinite voltage gain becauseA. To control the output voltageB. To obtain finite output voltageD. None of the mentionedC. To receive zero noise output voltage5. Which factor determine the output voltage of an op-ampA. Positive saturationC. Both positive and negative saturation voltageB. Negative saturationD. Supply voltage

Given:Here, we are given multiple statement based questions.Required:We need to mark correct answer…

Q3: Multiple Choice Questions: 1. An ideal operational amplifier has A. zero input impedance B. infinite output impedance C. infinite bandwidth D. All 2. If ground is applied to the (+) terminal of an inverting op-amp, the (-) terminal will A. not need an input resistor B. be virtual ground C. have high reverse current D. not invert the signal 3. A non-inverting closed-loop op-amp circuit generally has a gain factor: A. greater than one B. less than one C. of zero D. equal to one 4. Ideal op-amp has infinite voltage gain because A. To control the output voltage B. To obtain finite output voltage D. None of the mentioned C. To receive zero noise output voltage 5. Which factor determine the output voltage of an op-amp A. Positive saturation C. Both positive and negative saturation voltage B. Negative saturation D. Supply voltage

Q3: Multiple Choice Questions: 1. An ideal operational amplifier has A. zero input impedance B. infinite output impedance C. infinite bandwidth D. All 2. If ground is applied to the (+) terminal of an inverting op-amp, the (-) terminal will A. not need an input resistor B. be virtual ground C. have high reverse current D. not invert the signal 3. A non-inverting closed-loop op-amp circuit generally has a gain factor: A. greater than one B. less than one C. of zero D. equal to one 4. Ideal op-amp has infinite voltage gain because A. To control the output voltage B. To obtain finite output voltage D. None of the mentioned C. To receive zero noise output voltage 5. Which factor determine the output voltage of an op-amp A. Positive saturation C. Both positive and negative saturation voltage B. Negative saturation D. Supply voltage

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

TRUE OR FALSE1. Due to the infinite open-loop volatge gain of an ideal op-amp, its diferrential input voltage should approach zero for the output voltage to be finite.2. An op-amp is a voltage amplifier circuit with very high gain, very high input resistance, and a very high output resistance.3. The input resistance of an ideal op-amp is infinite resulting to the simplifying condition that the voltage at the non-inverting input is essentially equal to the voltage at the inverting input.4. For an op-amp differentiator circuit, if the input voltage is a sine wave then the output is also a sine wave that is in-phase with the input.5. The gain of a non-inverting amplifier can be adjusted to values less than 1 or greater than 1 by using appropriate values of the external resistors.
Q.3 (a) Figure Q. 3(a) shows a basic op amp circuit. (i) State current and voltage assumptions that are used to analyse the op amp circuit. (ii) Explain the function of +Vcc and -Vcc in the linear op amp operation. (iii) Give one advantage of using op amp compared to a single BJT transistor in amplifier circuit. +Vc V+ I- Vo V- - Vec Figure Q. 3(a) SITI NOLOC
4. PD FB IN- 1 2 3 IN+ 4 8 VS+ 7 6 5 OUT NC VS- Using the Op-Amp diagram shown above, draw a line to create: 4.a. non-inverting amplifier 4.b. Inverting amplifier
1. The upper critical frequency of an op-amp's open-loop response is 200 Hz. If the midrange gain is 175,000, answer the following: a. What is the ideal gain at 200 Hz? b. What is the actual gain? c. What is the op-amp's open-loop bandwidth? 4 (Ctrl) - 44
3G Problem 1. (P1) Three op-amps are connected in cascade configuration. An 80 microVolts signal is connected to the non-inverting input of the first op-amp. Both the 2nd and 3rd op-amps operates as inverting amplifiers. All feedback resistors are 420 KOhms while the input resistances are 71.4kOhms, 19.1kOhms, and 14KOhms respectively. Determine the output voltage of the second stage stage. a.-2640 mV b.-26.4 mV c.-1.2 mV d.26 V
+Vcc Vin VI Vo Vref VN -Vcc Ry RxL Figure Q.A2(e). Inverting Schmitt-trigger circuit. (ii) The operational-amplifier (op-amp) of the inverting Schmitt-trigger in Figure Q.A2(e) has saturation voltages of +Vsat = +11 V and -Vsat = -11 V. The voltage divider circuit has the relationship of Rx = 2RY with the value of RY being 100 kn. Using the relationships derived above: (a) Calculate the values of the upper threshold point (UTP or Vi*), lower threshold point (LTP or Vr). (b) Now, sketch the input-output characteristic of the inverting Schmitt- trigger. Clearly label axes, the threshold voltages and the saturation voltages in your sketch.
Given the four statements, which of the following statements are not true about the operation of an op-amp? i. Op-amp's close loop operation employs negative feedback that takes portion of the output and applies it back out of phase with the input. 1i. In an op-amp, amplification of the common input signals is much less than that of the opposite input signals. iii. In open-loop operation, the output of the op-amp is driven to saturation with Vo- +Vsat. iv. Op-amp's close loop operation employs positive feedback that takes portion of the output and applies it back out of phase with the input. O i, iii, iv O i, iv O i i, ii O i, iv
Find the sum of all the digits in 1/1/2003 and then do the tollowing:(a) Convert the sum into 32-bit binary.(b) Convert the sum into 32-bit, IEEE-754 single precision floating point format.For example, if your date of birth is 15-8-2001, then the sum of its digits would be 17. You should convert it into 32-bit binary and single precision floating point formats.
Need help with this Q2a
A certain op-amp has three internal amplifier stages with midrange gains of 30 dB, 40 dB, and 20 dB. Each stage also has a critical frequency associated with it as follows: fc1 = 600 Hz, fc2 = 50 kHz, and fc3 = 200 kHz. (a) What is the midrange open-loop gain of the op-amp, expressed in dB? (b) What is the total phase shift through the amplifier, including inversion, when the signal frequency is 10 kHz?
2. Suppose we have an op-amp that is powered by a ±15 V supply (assume Vout max is ±14V), and has a maximum output current of 50 mA. The maximum slew rate of the op amp is 107 V/s. In the circuit below where Vin=5sin(100t). a. What would the output voltage Vout be if the op amp were ideal? b. Compute and draw the actual output voltage if a load resistor of Rload=100 N is attached to Vout. Vin ww 1 ΚΩ ww 4 ΚΩ + +15V Op-Amp -15V Vout
please do question 2 and 3