An op amp (20 dB drop in gain/decade), has an open-loop gain of 100 dB and a unity- gain frequency of 5 MHz. (a) What is the open-loop bandwidth of the op amp? (b) The op amp is used in a voltage follower (gain = 1). What is the amplifier's bandwidth?

An op amp (20 dB drop in gain/decade), has an open-loop gain of 100 dB and a unity- gain frequency of 5 MHz. (a) What is the open-loop bandwidth of the op amp? (b) The op amp is used in a voltage follower (gain = 1). What is the amplifier's bandwidth?

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

An inverting amplifier is to be designed with a gain of 5 and an input impedance of 10k ohms. What should be the value of the feedback resistance?
6. For common-source small-signal FETS, the output voltage is 180° phase shifted with respect to the Q 7. The operating cycle of a Class A amplifier is Q 8. The maximum efficiency of a Class B amplifier is Q 9. In analyzing op-amps, when the non-inverting input pin is at ground and the inverting input pin is also at 0 V for an AC signal, the technique is called as Q 10. is an op-amp application circuit which is useful in low pass filter circuits.
Subject: Electronic engineering Explain in simple words about Common-mode rejection in operational amplifier.
Help with this would be greatly appreciated.
Q.3 (a) Figure Q. 3(a) shows a basic op amp circuit. (i) State current and voltage assumptions that are used to analyse the op amp circuit. (ii) Explain the function of +Vcc and -Vcc in the linear op amp operation. (iii) Give one advantage of using op amp compared to a single BJT transistor in amplifier circuit. +Vc V+ I- Vo V- - Vec Figure Q. 3(a) SITI NOLOC
Why are the two circuits called inverting and non-inverting amplifier, respectively?
3G Problem 1. (P1) Three op-amps are connected in cascade configuration. An 80 microVolts signal is connected to the non-inverting input of the first op-amp. Both the 2nd and 3rd op-amps operates as inverting amplifiers. All feedback resistors are 420 KOhms while the input resistances are 71.4kOhms, 19.1kOhms, and 14KOhms respectively. Determine the output voltage of the second stage stage. a.-2640 mV b.-26.4 mV c.-1.2 mV d.26 V
please need correct answer fast Q1) For an Operational amplifier if CMRR = 130dB and Open loop differential gain Aol = 150000, the value of Common mode gain ACM will be __?
Q4:Choose the correct items of the following statements: 1-The tail current of a diff amp is a-Half of either collector current. b-Equal to cither collector current. c-Equal to difference in base currents. d-Equal to emitter current. 2-The voltage gain of a diff amp with an unloaded differential output is equal to Rc divided by a-r.. b-r/2. c-2r. d-RE 3-A-commmon -mode signal is applied to a-The nan inverting input. b-The inverting input. c-Both inputs. d-The top of tail resistance. 4-The common -mode rejection ratio is a- Very low. b- Often expressed in decibels. c- Equal to the voltage gain. d- Equal to the common- mode voltage gain. 5- The input offset current is usually a- Less than the input bias current. b- Equal to zero. c- Less than the input offset voltage. d- Unimportant when a base resistance is used. 6-With both bases grounded the only offset that produces an crror is the a- Input offset current. b- Input bias current. c- Input offset voltage. d- B. 7-A compensating…
3A Problem 1. (P1) Three op-amps are connected in cascade configuration. An 80 microVolts signal is connected to the non-inverting input of the first op-amp. Both the 2nd and 3rd op-amps operates as inverting amplifiers. All feedback resistors are 420 KOhms while the input resistances are 71.4kOhms, 19.1kOhms, and 14KOhms respectively. 3H Determine the total gain of the circuit in Problem No. 1 (P1) a.792.105 b.9000 c.792 V d.792
QUESTION 2 A non-inverting amplifier has a 15-k Rf and a 1.2-kR,. How much is its closed-loop volt 9. 12.5. -12.5. 13.5.
Answer the following question regarding amplifiers: