Q3: For the maximum power transfer to(2000) resistor, find:1. Turn ratio "n"?2. Maximum power transfer?3. Output voltage "Vo"?(Ans.: n=0.2, Pm=28.8mW & Vo=2.4V)5KO1ΚΩ1:n30Vrms20KOVo:2002idcal

Q3: For the maximum power transfer to 5KO 1KO (2000) resistor, find: 1. Turn ratio "n"? 1:n 30V 20KO Vo 2002 rms 2. Maximum power transfer? 3. Output voltage "Vo"? (Ans.: n=0.2, Pm=28.8mW & Vo=2.4V) idcal

Q3: For the maximum power transfer to 5KO 1KO (2000) resistor, find: 1. Turn ratio "n"? 1:n 30V 20KO Vo 2002 rms 2. Maximum power transfer? 3. Output voltage "Vo"? (Ans.: n=0.2, Pm=28.8mW & Vo=2.4V) idcal

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

In the full-wave rectifier circuit of figure, the transformer has a turns ratio of 1:2. The transformer primary winding is connected across an AC source of 230V (rms), 50 Hz. The load resistor is 50ohms. For this circuit, determine the peak-to- peak ripple in the output voltage * Di i v2 = VmSin ot RL Vs(N V1 Vo + V3 = VmSin ot D2 Full-wave rectifier- Circuit operation during positive half cycle 460 V 207 V 325.3 V None of the above ell ell
FAIRCHILD Discrete POWER & Signal Technologies SEMICONDUCTOR ru 1N4001 - 1N4007 Features • Low torward voltage drop. 10 a14 * High aurge eurrent cepablity. 0.160 4.06) DO 41 COLOR BAND DGNOTEs CAT-Cos 1.0 Ampere General Purpose Rectifiers Absolute Maximum Ratings T-26*Cuness atnerwioe rated Symbol Parameter Value Units Average Recttied Current 1.0 375" lead length a TA - 75°C Tsargei Peak Forward Surge Current 8.3 ms single halr-sine-wave Superimposed on rated load JEDEC method) 30 A Pa Total Device Dissipetion 2.5 20 Derste above 25°C Ra Tag Thermal Resistence, Junction to Amblent 5D Storage Temperature Range 55 to +175 -55 to +150 Operating Junetion Temperature PC "These rarings are imithg valuee above whien the serviceatity or any semiconductor device may te impaired. Electrical Characteristics T-20'Cunieas ofherwise roted Parameter Device Units 4001 4002 4003 4004 4005 4006 4007 Peak Repetitive Reverse Vellage Maximum RME votage DC Reverse Voltage Maximum Reverse Current @ rated VR…
In a temperature measurement system the element A receives the temperature value and produces millivoltage as the output. This output is given to an element B. The element B increases the millivoltage value into voltage value. Then it is given to element C. The element C converts the analog voltage into Digital value .The element D displays the output. Identify the elements A, B, C and D used in the above mentioned temperature measurement system.
The input to a full-wave rectifier is 20 V AC (RMS). The load resistor is 20 ohms and rectifier losses are 4W. The ripple factor of the rectifier is: O A. 0.96 OB. 0.33 O C. 0.48 O D. None of the other choices are correct O E. 0.75
For the buck-boost converter, determine the duty cycle, the switching frequency, and the inductor current ripple. The output voltage ripple is about 1%. vs 10 V, mH, C 0.5 micro.F, Vout=-20 V, R-IO Q
p3. A biased parallel clipper is connected to a squarewave 20VAC input.The biasing voltage of 5V has the same polarity with the Vo while the Si diode is connected in reverse and will conduct only during negative half cycle. In P3, what is the output voltage (Vo) during the positive half cycle? a. -4.3V b. 20V c. 4.3V d. -12.15V
A half-wave rectifier circuit has an input voltage of 60V for the entire swing of the input signal from the secondary winding of the transformer. If the load resistance is 900 and a shunt capacitor is connected therein: 1. Draw the circuit 2. Solve the following unknown values. a. The peak voltage V b. the average output voltage Volave) c. the average load current lolavel, d. the rms load voltage Volcms), e. the rms load current loma) f. the ripple factor RF of the output voltage, g. the rms ripple voltage Vrirms) h. the average diode current ID(ave) i. the rms diode current Ipicms), j. the peak inverse voltage PIV of the diode, k. the average output power Polac 1. the DC output power Po(de) m.the frequency fr of the output ripple voltage, n. the input power factor PF.
For the given circuit in Figure below, find the open circuit voltage VTH and the short circuit current IN across the terminal. then, find R TH by using the RTH=VTH/IN equation and find RTH with replacing voltage source with short circuit. Let’s assume we connect RL (load resistance) to the circuit between points A and B, what should be the value of RL in order to have max power transfer.
A buck-boost converter operates with an input battery. It converts +12 V to –12 V at apower level of about 75 W. the switching frequency is 120 kHz. The switches have200 ns switching time. The battery has an internal series resistance of 0.2  and seriesinductance of 200 nH. (a) What is the operating value of the duty ratio? What power is lost in the battery resistance? (b) Propose an interface structure to improve operation and decrease losses. What are the duty ratio and battery resistance loss with your interface in place?
An RL load (R=0.2 Ohms, L=10 mH) is controlled by a converter. The supply voltage Vs is 600V and the chopper frequency is 200 Hz. The maximum peak to peak ripple current is equal to: Select one: a. 30A b. 55A c. 90A d. 75A
A half-wave rectifier circuit has an input voltage of 60V for the entire swing of the input signal from the secondary winding of the transformer. If the load resistance is 900 and a shunt capacitor is connected therein: 1. Draw the circuit 2. Solve the following unknown values. 2.1) Vm , Vdc , Vac 2.2) Irms , Idc, Im , lac 2.3) PIV
A PMMC instrument has internal resistance of 0.63 kQ and gives full scale deflection for 31 mA. The required resistance value of multiplier resistors for employing the meter as a multi range voltmeter for voltage range 64 V will be ohms. O a. 205.82 O b. -145.62 O c. 1434.52 O d. 101556.30