Q2: Producer gas was mixed in a (Y) shaped mixer with air prior to combustion. Assume 3:1 air: fuel flow ratio and PG flow rate of 1kg/s. Assume air to be dry at a temperature of 27 °C. Calculate the properties of air-fuel mixture (temperature, Molar mass, and gas constant)

Q: Brine is solution-mined from a salt deposit by pumping fresh water into the salt deposit, dissolving…

A: Given:The pump is at 0 ft elevation relative to the gradeThe level in the brine tank is 20 ft above…

Q: the liquid mixture temperature value being 100 °C, determine the minimum pressure value at which the…

A:

Q: 1. Based on the following figure, answer the following questions: (a) How many actual trays are…

A:

Q: Liquid propane is vaporized in a process before the gas is burned. a) If the inlet to the vaporizer…

A: Hi and thanks for the question, but you have posted multiple subparts, so we will answer the first 3…

Q: 7 evaporators are connected in series, i.e., the concentrated product of the first one is fed to the…

A: Introduction   Chemical engineers refer to a multiple-effect evaporator as a device for effectively…

Q: H.W (3.1) : Evaluate the given crude oil ° API 36.3 Volume percent TBP Temperature ( "F) 5 62 10 144…

A: (3.1)  specific gravity for whole crude = 141.5/(131.5 + API) for the crude the specific gravity =…

Q: To determine the calorimeter constant of a coffee-cup calorimeter, 28 g of cold water was placed in…

A:

Q: 1. Draw an appropriate process path diagram for the chemical systems undergoing temperature and…

A: Step 1: Case 1:  Step 2:  Step 3: Case 2:  Step 4:

Q: Pure water and alcohol are mixed to get a 50% alcohol solution. The density (g/ml.) of water,…

A: Since we are entitled to answer only 1 question, we will answer the first one as it is not mentioned…

Q: Hydrogen gas is typically purified by diffusion through a palladium sheet. Compute the concentration…

A:

Q: 03:0.75 lbm/min of C3H8 is burned at 77 °F with 150 percent excess air that enters the furnace at 40…

A:

Q: 3. A mixture of 10 wt% water and 90 wt% chloroform enters a gravity separator at the flow rate of 20…

A: It is given that a mixture of 10 wt% water and 90 wt% chloroform enters a gravity separator. Given…

Q: AH of vaporization of water is 418.2 cal/g at the normal boing point. Since virus can survive at…

A: Enthalpy of vaporization of water at its normal boiling point, ΔH = 418.2 cal/g Required water…

Q: Calculate the corrosion rate Cr in units of mm/y, and the electrochemical rate in µg/cm2.s and…

A:

Q: The following graph shows the T-x pressure phase diagram atmospheric for a Pt / Au alloy: T (°C)…

A: This is a binary system phase diagram and if Pressure is fixed we have two degrees of freedom. If we…

Q: A continuous single effect evaporator concentrate a dilute juice stream entering at 3wt% salt…

A: Concentration of salt entering the evaporator = 3 wt % Salt concentration exiting the evaporator =…

Q: How to solve the following question? Question 1 A three parts evaporator is designed to reduce water…

A: The mass flow rate of stream P3 = 14670 lb/hr The points i), ii), iii), and iv) can be determined by…

Q: Q1/The following data have been obtained from permeability test by gas. The test has been done in a…

A: It is given that,core sample has diameter of ,and data with initial and final pressure along with…

Q: What is the gas formation volume factor if z is 0.646, pressure is 4778.4 psia and temperature is…

A: To relate the volume of gas at certain temperature and pressure conditions to the standard volume…

Q: In a filtration experiment, the slurry in water at 25 °C was filtered through a plate and frame…

A:

Q: Beginning at point X trace out the lines for one theoretical plate. What is the composition of the…

A: Given data: Temperature-composition (T,x-y) diagram of compounds An and B is given.

Q: (A) Calculate the Mv of poly(methyl methacrylate) using the table shown below. The MarkHouwink…

A:

Q: Q4/ A Petroleum cut has the following ASTM D86 distillation data:- Volume% 10 30 50 70 90 95…

A: TBP distillation is tedious and time consuming in comparison with ASTM method. Equations given by…

Q: On a 14 day wilderness expedition you'll need to heat 4.0 kg of water to the boiling point each day.…

A: Given,

Q: 3. Using the graph below, the boiling point of CCI4 at standard pressure is 1000 CHCI3 CCI4 H20 800…

A: The given molecule is CCl4. The standard pressure is 1 atm which is equivalent to 760 torr

Q: Examine the nanoscale diagrams and the phase diagram below. Match each particulate diagram (1…

A: This question is based on phase diagram. 7 nanoscale diagrams are given and they each represent…

Q: Basis: 1 mol feed. Since the problem statement asks us to calculate the ratio of the volumes of feed…

A: To solve the unknowns in a chemical process, the degree of freedom must be equal to zero. If DOF is…

Q: vapopr 1x.6.2: An evaporator operating at atmospheric pressure (101.325 kPa) is fed at the rate of…

A: Mass flow rate of weak liquor m = 10000 kg/hConcentrate of caustic soda in feed xf= 4%Concentration…

Q: Use Prandtl and Nusselt numbers and the Dittus-Boelter Equation

A: The objective of the question is to estimate the value of the heat transfer coefficient (h) on the…

Q: ) Find the number of particles per unit volume as N2 (particles / m3)

A: Pressure = 1 atm Temperature = 20 oC Viscosity = 147 * 10-7 kg.m/s

Q: the tube, and the wall temperature is maintained at 55°C. What fraction of the vapour will condense…

A:

Q: Solution STEP 1: Perform required material balance calculations. 36.45 mol/s ġ(J/s) 0.092 mol…

A: Given data: F=100 mol/sV=36.45 mol/sD=63.55 mol/sxF=0.669yv=0.092

Q: An electron in a hydrogen atom is excited from the ground state to the n = 3 state. True or false?…

A: Given that  an electron in a hydrogen atom  from ground state to n= 3 state      According to…

Q: The diffusion coefficient of Material A in Material B is given for two temperatures in the following…

A: Given data: Diffusivity of material A into B at 700 0C = 8.59 × 10-18 m2/s Diffusivity of material A…

Q: Describe the substance at 100°C No partial credit. (Hint: each gridline upwards is 5°C) Show Your…

A: Melting is a physical process that results in the phase transition of a substance from a solid to a…

Q: Determine the units of the rate constants of (a) Zero-Order and (b) Second-Order chemical reactions.…

A: Given data of item 2, Unit of concentration of A = M (mol/L) Unit of time = sec

Q: On a 12 day wilderness expedition you'll need to heat 4.0 kg of water to the boiling point each day.…

A: 4 kg of water is heated to boiling point by using canisters of compressed butane. Mass of butane in…

Q: distillation column

A:

Q: A welder has just welded two pieces of carbon steel together and needs to quench the weld in a water…

A: When two substances are in physical contact with each other the heat is exchanged from one substance…

Q: AH of vaporization of water is 418.2 cal/g at the normal boing point. Since virus can survive at…

A: Enthalpy of vaporization of water at its normal boiling point, ΔH = 418.2 cal/g Required water…

Q: • To determine the freezing point: o Plot the cooling curve in Excel (te

A:

Q: A (fluid 1) at the rate of 145 Ib/min s heated 75 °F to 150 °F by another fluid (fluid 2) enters the…

A: Given: Fluid 1 is heated from; Tc1 = 75oF to; Tc2 = 150oF Using a fluid (2) from; Th1 = 215oF to;…

Q: 1. Volume of water, ml 500 2 Volume of methanol, ml 500 Density of Water at Tr, (Pw, g/cc) 3 1.0000…

A: