Q2// Determine the diameter of a circular rod made of ductile material with a fatigue strength (complete stress reversal), Oe = 270 MPa and a tensile yield strength of 370 MPa. The member is subjected to a varying axial load from Wmin - 250 × 10' N to Wmax 600 x 10' N and has a stress concentration factor = 1.8. Use factor of safety as 2.0.

Q: 3. A 5.0 meter tall steel column with a rectangular cross section of 100mm by 80mm has fixed ends…

A:

Q: 1. Determine the diameter size of rods AB, BC and C if ay = 3600 MPa and the safety factor SF= 2.…

A: Determine the diameter size of rods AB, BC and CA, if Yield stress = Sy = 3600 MPa and the safety…

Q: 1.37 Link BC is 6 mm thick, has a width w = 25 mm, and is made of steel with a 480-MPa ultimate…

A:

Q: 1. Construct a critical end-load intensity against slenderness ratio graph for a range of pinned…

A:

Q: Required Information The part shown is made from AISI 1030 CD steel and is loaded at point C with…

A: Given : material - AISI 1030 CD diameter of bar d = 12 mmNote : Yeild strength for AISI 1030 CD is…

Q: A pressure of 40 MPa shall be contained in a pressure vessel with inner diameter 0.30 m. Find the…

A: Given: Pressure, P = 40 Mpa Inner diameter, d = 0.3 m Maximum tensile stress, σu = 646 Mpa Factor of…

Q: Two cylinders are to be press-fitted together so that the principal stress with the greatest…

A:

Q: What is the minimum cross-sectional area required of a vertical steel cable from which is suspended…

A:

Q: The wire-mass system shown is constructed using 6061-T6 aluminum wire. Determine the minimum…

A:

Q: Determine the allowable stress in last example if the factor of safety is 2.5.

A:

Q: with a stress of 52.89  and diameter of 4cm and thickness of 2mm  (P) load of 2MPa how was the…

A:

Q: End condition total coils wire dia spring index material G squared & ground 14 2.2 mm 10 Hard-drawn…

A: free length l=65mmtotal number of turns nt=14wire diameter  d=2.2mmspring index  c=10G=80GPa=80 x…

Q: A hallow cylindrical steel column with an outer diameter of 200 mm and an inner diameter of 180 mm…

A:

Axial Load

When a bar of the uniform cross-section is acted by a load, such that the load acts along the longitudinal axis of the bar, such kinds of loadings are known as axial loadings. In general terms, a load is an external force acting on a component. An axial load acts perpendicular to the geometric cross-section of the component. Based on the direction of the application of the load, an axial load can be tensile or compressive. The analysis of bodies under the action of axial loads is generally studied under the branch of mechanics, known as statics.