Q2: By using the General flow equation: Reu erd 0.5 P2- P2 Q = 38.77F | D2.5 Po GT;LZ Approve that, for two parallel gas pipelines (1- BCE & 2-BDE ) as shown in the figure below, the equivalent pipe diameter for both pipelines can be determined by the following equation: 1/5 K. (1+ const1 D. = D1 K1 const1 where A в E F K2 (D L2 K, (D2 constl = D 이

Q: 1) Pitot tube can be used to measure the flow velocity. The equation can be derived from Bernoulli…

A:

Q: Delta Z (ft) Operating Head (r) Operating Discharge (cfs) Elficiency (%6) Brake Horsepower (hp)

A:

Q: From the theory, the equation governing the flow rate through a orifice meter is shown as follows:…

A: The inner diameter is The outer diameter is The difference in pressure is

Q: 04: For the piping system, compute pressure at A, and mid pipe 2. If pipe (3) & pipe (4) havi equal…

A:

Q: Sensitivity Analysis: Flow Velocity Equations Perform a sensitivity analysis comparing two flow…

A:

Q: Pump head, hp, can be formulated as, h, = 22 - z1 + hm + he Where, E h = EK and hy = Table 1: Minor…

A: a)  Volume flow rate =0.006 m3/s ( given) Radius = 2cm = 0.02m Cross section area= 3.14 × 0.022…

Q: he figure shown below is a series pipeline system used to draw a fluid from a lower source open tank…

A: Given       Volume flow rate: Q=0.015 m3/s                     Length: Ld=100 m Elevation…

Q: Keeping in mind continuity of flow, compute the velocity of flow for section C (Vc), the 6 inch…

A: Given Data

Q: 49. Water flows at a rate of 200 GPM into a piping system connected in series. Length, diameter, and…

A: Given:To find:(a) Total pressure drop.(b) Diameter of the equivalent pipe.

Q: Air flows through a circular pipe with variable cross section as shown. The pipe diameters shown are…

A:

Q: For the figure shown below with the accompanying data table, what is the approximate flow in pipe 1…

A:

Q: q; = K(P; − P;) - qj q; = K(P; - P;) where qi and q; are fluid flow at nodes i and j, respectively;…

A:

Q: 12. A constant diameter pipeline is used to transfer water from one location to location. At outlet,…

A: Since there are two problems, according to our guidelines, we are supposed to answer the first one.…

Q: The following figure shows a bent in a pipe with a diameter of D (cm). Pressure is measure in cross…

A:

Q: % Parameters D = 0.1; % Diameter of the tube (m) L = 1.0; % Length of the tube bundle (m) N = 8; %…

A: It is asked to find the error in the Matlab code given

Q: CS) Flow through a heat exchanger tube is to be studied by means of a 1/10 scale model. If the…

A:

Properties of Fluids

The term fluid represents a type of substance that can easily change its shape under any external pressure/force and can flow. Fluids can acquire any shape in which it is stored and can resist normal stresses but cannot resist shear stress in rest condition. Whenever external shear stress is applied to fluids, it starts to flow. The fluids may be liquid or gas. Example- water, air, etc.