Q2/ A 3200 ft segment of 3.25-mi four-lane undivided multilane highway in a suburban area is at a 1.5% grade. The highway is in level terrain, and lane widths are 11 ft. The measured free-flow speed is 46.0 mi/h. The peak-hour volume is 1900 veh/h, PHF is 0.90, and there are 13% trucks and 2% RVs. Determine the LOS, speed, and density.

Q2/ A 3200 ft segment of 3.25-mi four-lane undivided multilane highway in a suburban area is at a 1.5% grade. The highway is in level terrain, and lane widths are 11 ft. The measured free-flow speed is 46.0 mi/h. The peak-hour volume is 1900 veh/h, PHF is 0.90, and there are 13% trucks and 2% RVs. Determine the LOS, speed, and density.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

A long segment of suburban freeway is to be designed on level terrain. The level segment, however, is followed by a 4.5% grade, 2.0 miles in length. If the DDHV is 2,500 vehicles per hour with 15% trucks (standard mix), how many lanes will be needed on the (A.) Upgrade, (B.) Downgrade, (C.) Level terrain segment to provide for level of service C? Lane widths and lateral clearances may be assumed to be 12 feet and 6 feet, respectively. Ramp density is expected to be 1.0 ramps per mile. The PHF is 0.92. Good weather, no incidents, no work zones, and regular users of the facility may be assumed.
A multi-lane Minor Arterial is being designed through a level urban area. The current daily volume = 8000 vpd in both directions with 10% Trucks, peak hourly factor 90%and a 60% directional distribution factor. How many lanes are required?
A six-lane freeway (three lanes in each direction) in rolling terrain has 10-ft lanes and obstructions (fLW = 6.0 mph) 4 ft from the right edge of the traveled pavement (fLC = 0.8 mph). There are five ramps within three miles upstream of the segment midpoint and four ramps within three miles downstream of the segment midpoint. A directional peak-hour volume of 2000 vehicles (primarily commuters) is observed, with 600 vehicles arriving in the highest 15-min flow rate period. The traffic stream contains 12% large trucks (ET = 2.5) and buses and 6% recreational vehicles (ER = 2.0). What is the heavy-vehicle adjustment factor (2 decimal places)?
Determine the value of PTSF for a 6-mile two-lane highway in rolling terrain. Traffic data are as follows: • Volume = 1600 veh/h (two-way) • Percent trucks = 14% • Percent RVs = 4% • Peak hour factor = 0.95 • Percent directional split = 50 - 50 • Percent no-passing zones = 50
A Class I two-lane highway has a base free-flow speed of 110 km/h. Lane width is 3.6 m, and shoulder width is 2.4 m. There are six access points per kilometre. The roadway is located in rolling terrain with 40 percent no-passing zones. The two-way traffic volume is 1000 veh/h, with a PHF of 0.90. The directional split is 70:30. Traffic includes 10 percent trucks and 5 percent recreational vehicles. The length of the analysis segment is 9.5 km. Compute service flow rate for the two-way segment.
A developer has applied for a construction permit to build a supermarket at the southeast cornerof an intersection that is formed by a four-lane divided highway in the east-west direction and atwo-lane road in the north-south direction. Traffic on the two-lane road is controlled by a stop signat the intersection. The speed limit on the four-lane highway is 88 km/h. using the sight trianglerequirements at the intersection (Case B1), determine whether permission should be given for theconstruction if the following conditions exist. Provide a diagram for your solution.Major road lane width = 3.6 mMinor road lane width = 3.3 mMedian lane = 2.8 mDesign vehicle is a passenger carApproach grade = 2%Maximum feasible distance building from the center of the nearest lane of four-lane road = 5.4 mMaximum feasible distance building from the center of the nearest lane of two-lane road = 16.5 m
A six-lane freeway (three lanes in each direction) currently operates at maximum LOS C conditions. The lanes are 11 ft wide, the right-side shoulder is 4 ft wide, and there are two ramps within three miles upstream of the segment midpoint and one ramp within three miles downstream of the segment midpoint. The highway is on rolling terrain with 10% heavy vehicles, and the peak-hour factor is 0.90. Determine the hourly volume for these conditions in veh/h. Round of your answer to whole number. fLW = 1.9, fRLC = 0.80, PHF = 0.90, N = 3 lanes PT = 0.10, ET = 3.0.
A temporary diversion has been constructed on a highway of -3% gradient due to major repairs that are being undertaken. Determine the speed limit that should be imposed on the diversion if drivers can see the sign inform ing them of the diversion at a distance of 400 ft from the diversion and the posted speed limit on the highway is 60 mph.
A 3.25-mile segment of undivided, four-lane highway is primarily on level terrain. The highway segment does, however, contain one sustained grade of 2.5% that is 3,200 ft long. Other relevant information include: Base free-flow speed = 65 mph %3! 11-ft lanes • 4 ft clearance at the roadside (right side) • 20 access points/mile Peak-hour volume = 1,900 veh/h 13% trucks; 2% RVs • PHF = 0.90 • Familiar facility users At what LOS is the highway expected to operate? (Hint: Three different analyses will be needed: a) the level terrain portion of the highway, b) the 2.5% upgrade portion of the highway, and c) the 2.5% downgrade portion of the highway.)
The heavy vehicle adjustment factor for a freeway in rolling terrain with 5% heavy trucks is: 1.08 1.13 0.89 0.93 1.00 OOO O