12:36ll ? 4a docs.google.comPower Plant |Q(2-3)A gas-turbine power plant operateson Brayton cycle. The air pressure inside thecombustion chamber is 1100 kPa. Thepressure at the turbine exist is 1.10 bar. Usinglocal thermometers on site, the maximumtemperature reached in the system is 1311Kwhile the minimum temperature in thesystem is 22C. The working fluid is air, whichenters the compressor at a rate of 120m3/min and leaves the turbine at 460°C.Assume the compressor has no deviation.Determine:The compression ratioYour answerTurbine isentropic efficiency %Your answer->14

Answered: Image /qna-images/answer/d47c9f38-7f3c-418f-8657-e8655277e3ca.jpg

Q(2-3)A gas-turbine power plant operates on Brayton cycle. The air pressure inside th combustion chamber is 1100 kPa. The pressure at the turbine exist is 1.10 bar. Usi local thermometers on site, the maximum temperature reached in the system is 1311 while the minimum temperature in the system is 22C. The working fluid is air, whic enters the compressor at a rate of 120 m3/min and leaves the turbine at 460°C. Assume the compressor has no deviation. Determine: The compression ratio Your answer Turbine isentropic efficiency %

Q(2-3)A gas-turbine power plant operates on Brayton cycle. The air pressure inside th combustion chamber is 1100 kPa. The pressure at the turbine exist is 1.10 bar. Usi local thermometers on site, the maximum temperature reached in the system is 1311 while the minimum temperature in the system is 22C. The working fluid is air, whic enters the compressor at a rate of 120 m3/min and leaves the turbine at 460°C. Assume the compressor has no deviation. Determine: The compression ratio Your answer Turbine isentropic efficiency %

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Provide complete solution and detailed diagram. What is the resulting pressure when one pound of air at 15 psia and 200oF is heated at constant volume to 800oF? A. 180 psia B. 28.6 psia C. 36.4 psia D. 521.1 psia
In an ideal Rankine cycle, steam is generated at 4.1 MPa and 480 deg. C. The condenser is at 32 deg. C. Determine: a. The cycle thermal efficiency b. For the engine with the same end states, the thermal efficiency and steam rateuse the attached steam table below
Draw a detailed PV and Ts diagram Note: For AIR, use c, =1.0062 kJ/kg-K, R = 0.287 KJ/kg-K 1. In a Brayton cycle air enters the compressor at atmospheric pressure, 32 °C and leaves at a pressure of 911.93kPa. The air is heated to 717°C in the combustor. For the net output 2125kW, Compute (a) the rate of flow of air per second, (b) the thermal efficiency and (c) the mean effective pressure.
You are required to design a spark ignition engine with a compression ratio of 9. the cycle pressure is 1 bar and the temperature is 300K. The maximum temperature in the Assuming a cold air standard process analyze the appropriate cycle. At the beginning of cycle is 2000K (a) Show the cycle on a p-v and T-s diagram (b) Calculate the heat transfer and work per unit mass of air. (c) Calculate the thermal efficiency (d)Assuming all the heat is transferred at high and low temperature what is the maximum efficiency of the cycle. Justify your answer.
THERMODYNAMICS The combustion peak pressure is 900 psia of a gasoline engine. The volumetric compression ratio of 10 and befont compression has air at 520 R, 22 psia in the cylinder Assume cold air properties. What is the cycle's maximum temperature? Determine the temperature at the start of the exhaust (heat rejection) as well as the over cycle efficiency. Show Complete Solution on a Paper.
Draw and label the P-V diagram of actual otto cycle applied to petrol engine. Draw and label the T-s diagram of ideal Rankine Cycle. Highest temperature of gas turbine cycle is 1200K and lowest temperature is 400K. What is the pressure ratio that will produce maximum efficiency, given that specifica heat ratio k for air is 1.42?
A rankine cycle operates between a pressure limit of 6 MPa. and 50 kPa., the steam leaves the boiler at 450 C, the isentropic efficiency of the turbine is 94%, the steam mass flow rate is 20kg/sec. draw the T-S diagram assuming point 1 is at the pumpe entrance. and determine the required power to operate the pump, cycle thermal efficiency. Ans. (122 kW, 30.25%)
COMBUSTIONMENGINEERING PROBLEM: Rdirat www A regenerative-reheat gas turbine with intercooling between turbine stages is shown in figure. Air enters at 100 kPa, 300 K with a mass flow rate of 5.807 . The pressure ratio across the two-stage sec compressor is 10. The pressure ratio across the two-stage turbine is 10. The intercooler and reheater each operate at 300 kPa. At the inlets to the Turbine stages, the temperature is 1400 K. The temperature inlet to the second compressor stage is 300 K. The polytropic efficiency of each compressor and turbine stage is 80 %. The regenerator effectiveness is 80 %. č, = 1.005 , k = 1.4 Determine a. The Compressor work, in kg air k/ b. The Turbine work, in- kg air c. The Net cycle work, in- kg air d. The thermal efficiency, in percent e. The work ratio f. The The net power developed, in kW E- Draw the corresponding cycle diagram on the pv plane.
I need the answer as soon as possible
The maximum temperature in the cycle : (in degree Kelvin) is Otto cycle has a compression ratio of 8. Before the compression, the air is at 280 k, 85 kPa. The combustion produce a maximum pressure of 6.5 MPa.
kg An ideal dual combustion cycle where air has initial conditions air at 110 kPa and 20C, is compressed to 0.051m. During the heat addition process, it was found that the pressure ratio is 1.5, and the cut off ratio is 2.5. Draw the PV and TS diagrams, solve for QA, QR, Wnet, efficiency, and Pmep
you can see the right answer for step 1. pls answer right for the following parts