Q1/ Steam enters the turbine at 30 bar, 400°C, amount of steam is extracted at 5 bar to a single direct contact FWH and the rest is expanded to a condenser at 0.1 bar. Draw T-S diagram and what is the cycle efficiency? (Pumps work may be neglected). 1 kg Power oulpul Turbine F Boiler 2 (1- m) Condenser Heater Pump (1 mika

Q1/ Steam enters the turbine at 30 bar, 400°C, amount of steam is extracted at 5 bar to a single direct contact FWH and the rest is expanded to a condenser at 0.1 bar. Draw T-S diagram and what is the cycle efficiency? (Pumps work may be neglected). 1 kg Power oulpul Turbine F Boiler 2 (1- m) Condenser Heater Pump (1 mika

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

3. A gas turbine uses the Joule cycle. The inlet pressure and temperature to the compressor are respectively 1 bar and -10°C. After constant pressure heating, the pressure and temperature are 7 bar and 700°C respectively. The flow rate of air is 0.4 kg/s. Calculate the following. 1. The cycle efficiency. 2. The heat transfer into the heater. 3. the net power output. y= 1.4 Cp = 1.005 kJ/kg K %3D
Instructions: solve problems under the concept of Reheat, Regenerative and Reheat-Regenerative Cycle in Rankine cycles (set the values to 4 decimal places for consistency) Review Questions (M.1) Steam at 10 MPa, 600 °C enters the first-stage turbine of an ideal Rankine cycle with reheat. The steam leaving the reheat section of the steam generator is at 500 °C, and the condenser pressure is 6 kPa. If the quality at the exit of the second stage turbine is 90%, determine a) the mass flow rate of the steam in kg/h and b) thermal efficiency (%) of the cycle c) mass of the cooling water in kg/ h, if the temperature rise in the cooling water is 20 °C.
10. thermodynamics. please answer asap
Plsss answer with complete solution and english system unit. Thanksss a lot!! ?
A medium size power station is used to produce 30 MW net power for a refinery. The station uses steam as the operating fluid and operates according to the Carnot cycle between the pressure limits of 0.4 bar and 35 bar. Steam enters the boiler as a saturated liquid and leaves it as a dry saturated vapour.(ix) State main disadvantages of using the Carnot cycle as the basis for a power station.
Consider a simple ideal Rankine cycle. If the condenser pressure is raised while keeping turbine inlet state the same, (select the correct statement) the turbine work output will increase. the amount of heat rejected will decrease. the cycle efficiency will decrease. the moisture content at turbine exit will increase. the pump work input will increase.
1. A reheat steam cycle has 13,580 kPa of throttle pressure at the turbine inlet and a 37.50308414 atm reheat pressure, the throttle and reheat temperature of the steam is 1302 R, condenser pressure is 4.3 kPa. Determine the difference between the simple Rankine cycle efficiency and the reheat Rankine cycle efficiency, in percent.
Which of the following will result to an increase in thermal efficiency of a steam power plant utilizing the Simple Rankine Cycle, assuming that both condenser and boiler operating pressures remain constant. I. Increasing the turbine outlet temperature.II. Increasing the boiler outlet temperature a.Both I and II b.I only c.Neither I nor II d.II only
Question 4 A combined cycle power plant has Both Gas Turbine and Wind Turbine Gas Turbine and Desalination turbine Gas Turbine and Steam Turbine Electric Turbine and Steam Turbine
Please answer a,b,c. Badly needed. Thank you.